Shaft AB and DC are connected by gears. A torque of 35 Nm is applied at end D of shaft CD. While shaft DC is free to rotate, shaft AB is fixed at end A. Both shafts were made of steel having a modulus of rigidity, G, of 80 GPa. The shear stress (t) shall not exceed 50 MPa. It is also decided that the same diameter be used for both shafts AB and CD, and the angle of rotation at end D should not exceed 1.25 degrees. Determine the diameter of both shafts AB and shaft CD. T=35 Nm 90 mm D. 1.35 m 135 mm 1.8 m

Shaft AB and DC are connected by gears. A torque of 35 Nm is applied at end D of shaft CD. While shaft DC is free to rotate, shaft AB is fixed at end A. Both shafts were made of steel having a modulus of rigidity, G, of 80 GPa. The shear stress (t) shall not exceed 50 MPa. It is also decided that the same diameter be used for both shafts AB and CD, and the angle of rotation at end D should not exceed 1.25 degrees. Determine the diameter of both shafts AB and shaft CD. T=35 Nm 90 mm D. 1.35 m 135 mm 1.8 m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Need only a handwritten solution only (not a typed one).
pls help! Write the complete solutions and legibly. Answer in 2 decimal places. UPVOTE WILL BE GIVEN! MECHANICS OF DEFORMABLE BODIES Let Q = 0 and T = 6 (Example: 4QT mm2 = 406 mm2). Just substitute the number in letter. Thank you! A rigid beam is being supported by three suspender bars made of bronze and loaded as shown in the figure. The cross-sectional area of each bar is 4QT mm2. Determine the average axial stress in each bar.
Please answer all parts please
Give me right solution. Urgent please
Answer this ASAP
Please solve full SOLUTIONs. One page don't do it in steps thanks
A circular plate of radius r= 0.863 m is adjacent to a rectangular plate with base b = 0.944 m and height h = 0.718 m which lies next to a triangular, isosceles plate with base b = 1.509 m and height h = 0.7980 m. t t r r The plates lie on a common baseline and the origin is in the lower left corner, see figure. AY r br h₂ b₁ ht X Determine the centroid of the rectangular plate in the x-direction if its surface density varies in the x-direction according to o r 2 = = 4,55.x kg/m .
Please help me understand this. If you can also provide understandable formula that would be nicer. Thank you ^^
Give an example for type of load classification according to Distribution Concentrated load Distributed load