Answered: Saturated Surface Dry Weight = 3650.3 g…

Saturated Surface Dry Weight = 3650.3 g Oven Dry Weight = 3625.5 g Submerged Weight = 2293.0 g. Compute the Absorption Capacity in %.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Which of the following is not true for the pan coefficient applied to Class A pan? (i) it is always…

A: Class A evaporation pan is used to measure the rate of evaporation on the field. This pan containing…

Q: 24000-ton coal/day having 4.2% Sulphur and emits gases at velocity of 18.3 m/s and temperature 140…

A: Plume height (∆h): For Neutral conditions Holland’s Equation is often used…

Q: The hydraulic residence time of the conservative PFR shown below is 72 minutes. At time te0, the…

Q: This is an end piece for the support frame of an A-type evaporator coil. Toforce the airflow through…

A: Consider the free body diagram of the triangular end piece of for the support frame of an A-type…

Q: 10-9. A dual-media filter contains anthracite with an effective size of 1.2 mm and uniformity…

Q: A monomedia anthracite filter is designed with the following specifications: effective size 1.1 mm,…

A: Given: Effective size, d = 1.1 mm Density, ρp=1650 kg/m3ρw=1000 kg/m3 μ=1.62×10-3 kg/ms Ergun…

Q: The pan evaporation for a particular month is 3 cm. The pan coefficient is 0.80. The lake…

A: Given- Pan evaporation=3 cm, Pan coefficient=0.80

Q: Given: Rate of infiltration, in/hr 2.4 Final capacity, in/hr 0.3 Horton k, hr*1 0.1 Solve for the…

Q: 10-7. Determine the variation in backwash velocity required to expand an anthracite medium with an…

A: Giveneffective size of particle=1 mmuniformity coefficient=1.3temperature variation=3° - 30° CTo…

Q: 1. In undisturbed air stream, where the pressure is 14.7 psi and density is 101325Pa, where the…

Q: A monomedia anthracite filter is designed with the following specifications: effective size 1.1 mm,…

A: Given data: Effective size, d = 1.1 mm Coefficient of uniformity, Cu=1.4 Density, ρp=1650…

Q: Q1)) The reservoir has the following data: Evaporation by mass transfer = 4.5 mm/day Emitted solar…

A: Given- Evaporation by mass transfer = 4.5 mm/day Emitted solar radiation = 7.25 MJ/m2.day…

Q: Q3)) The reservoir has the following data: Evaporation by mass transfer = 5.5 mm/day - Emitted solar…

A: The given data is: A=Albedo=0.723 Hn=Net radiation in mm=? Hc=Radiation incoming=8.5 MJ/m2 day…

Q: For a monosized media filter with a particle size of 2.5 mm in diameter, a bed depth of 2 m and…

A: The head loss during the filtration process is estimated by Carmen Kozney equation, HL =…

Q: 02-B A sandy layer with 3.5x10 cm/s hydraulic conductivity, a pump-out test is carried out in a…

Q: Determine the temperature rise of 20.615°F in the water-cooled condenser in °C.

Q: The average weather conditions are; Net radiation Air Temperature Relative Humidity Wind speed…

A: Net radiation = 100 W/m2 Temperature = 25°C Relative humidity = 55% Wind speed = 2.7 m/s Height = 2…

Q: 10-9. A dual-media filter contains anthracite with an effective size of 1.2 mm and a uniformity…

A: Given,Effective size, D10=1.2 mmUniformity coefficient, Cu=1.5to determine,Size of underlying sand…

Q: Provide a reasonable design for a 99,4% efficient ESP treating 30,000 m3/mm of gas, The dust has a…

A: The given data is shown below: Efficiency=99.4 %Discharge=30,000 m3/minResistivity=7.1×1010 ohm-cm

Q: Using Energy Balance Method

A: As Energy balance method is highlighted hence solving for that only.assuming sensible heat flux Hs…

Q: It is desired to increase the rate of filtration by raising the speed of rotation of the drum. If…

Q: Find the length of a settling chamber needed to collect 90% of 50 um particulates (pp= 1.2 g/cm).…

A: It is required to determine the settling velocity of particulates. vs=gρp-ρadp218μ Here ρp is the…

Q: 8. The upper portion of an inverted U-tube is filled with oil having a pecific gravity of 0.98. The…

A: Determine the pressure difference (PB - PA).

Q: At 100°C of temperature, 3.5 atm vapour pressure of water is equivalent to: 1. 350.0000 kPa 2.…

A: Given data- Temperature T=100oCVapour pressure VP=3.5 atmTo Find-Vapour pressure of water Equivalent…

Q: A reaction turbine works under 30m head of water. The atmospheric pressure at the location of…

Q: Use the laboratory data to determine the specific gravity and water Oven Dry weight - 4.97 kg Weight…

A: Given oven dry weight (A)=4.97 kgsaturated surface dry (SSD) weight (B)=5.04 kgsubmerged weight…

Q: A monomedia filter 0.75 m deep contains sand with an effective size of 0.55 mm. The sand has a…

A: Given, Thickness of sand (L) = 0.75m Effective diameter (d) = 0.55 mm or 0.00055m To Find: Head…

Q: - A 25 ml water sample is placed in a dish that wt. 50g, after evaporation and drying at 103°C, and…

Q: A soil of two layers has a hydraulic conductivity of 8(cm/day) for the first layer, and 2.5(m/day)…

A: Given:- The hydraulic conductivity of the first layer = 8 cm/day The hydraulic conductivity for the…

Q: Calculate Superelevation for a horizontal cure with redius 300mand wides 8m. the design speed 50…

A: Radius of curve (R) = 300m Width (B) = 8m Design speed (V) = 50 km/h Centrifugal ratio = 1/10…

Q: A monomedia anthracite filter is designed with the following specifications: effective size 1.1 mm,…

A: Given data: Effective size, d = 1.1 mm Coefficient of uniformity, Cu=1.4 Density, ρp=1650…

Q: A rapid gravity filter operating with an influent concentration C0 of 20 mg/l suspended solids has…

Q: Find the GSB, GSA and the absorption ratio when the oven dry mass is A = 200, in air B = 2020, and…

A: The given data is: oven-dry mass is A = 200, mass of sample in air B = 2020, mass of sample in water…

Q: Calculate the evaporation using Priestley-Taylor Method (mm/day) from an open water surface with air…

A: The given data is shown below: Temperature=22°CRelative humidity=40%Wind…

Q: Calculate the anthracite diameter for a deep-bed anthracite filter of 1.5m with a porosity of 42%.…

A: Given: The depth is 1.5 m. The porosity is 42%. The headloss is 1.8 ft. The filtration rate is 13.5…

Q: 4- In CRP, the rate of evaporation is independent of moisture content.

A: 4. The evaporation rate mainly shows two types of period: A constant rate period (CRP) A falling…

Q: A dead-end mode ultrafiltration membrane system with 13.4 cm2 area was operated with distilled water…

A: Solution; Given Data; Area (A)=13.4 cm2 Time (t)=3 minutes Tempertaure (T) =22°C Transmembrane…

Q: A dual media filter contains 0.4 m of sand with effective size 0.55 mm and 1.4 m of anthracite with…

A: Given, Thickness of sand = 0.4m Thickness of anthracite = 1.4m To Find: Head loss through the…

Q: The performance of a centrifugal blower at its point of b ciency is Q = 10 m³/s, Aps = 5 kPa, and ns…

A: a. Speed: V = 2DP/ρ V = (2 X 0.7x0.0101972/1.21) V = 0.112 m/s FOR 1 KPa

Q: Given: Rate of infiltration, in/hr 3.1 Final capacity, in/hr 0.3 Horton k, hr 1 0.4 Solve for the…

Q: O kPa with a moisture content of 9. lensate the steam) enters at 15°C a team flow to the condenser.

A: Moisture content = 9.8% Dryness fraction x = 100-9.8 = 90.2 % = 0.902 mass Flow rate of water, mw…

Question

Saturated Surface Dry Weight = 3650.3 g

Oven Dry Weight = 3625.5 g

Submerged Weight = 2293.0 g.

Compute the Absorption Capacity in %.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

In a relative conductivity test, the sewage was incubated for a period of 15 days at 20°C. What is the relative stability in percentage. 90.04 % 99.9% 93.36 % 96.8 %
Settling tank has a depth of 3 m and surface area of 900 m2 is used to remove particles of size 0.01 mm and specific gravity 2.65. Compute the removal percentage of the tank for the discharge of 8000 m3/d. Take viscosity of water equal to 10-3 kg/m.s.
barbeque
Calculate Superelevation for a horizontal cure with redius 300mand wides 8m. the design speed 50 km/h. the centrifugal ratio is 1/10..
Calculate the monthly average evaporation from the open water surface using the Penman method according to the following July (31 days) Oh Latitude monthly average temperature Actual daylight hours (n) Sunny hours of the day, E (July, 25 Degrees North Wind speed Reflection coefficient of the water surface Relative gender (%) RA (July, 25 Degrees North O psychrometer constant Saturated vapor pressure at 22 degrees Saturated vapor pressure at 22.1 degrees 25 Degrees North at 22 degrees. 115 sec 13.5 sec 1.8 m/sn 0.07 70 920 gr*cal/cm²/gun 117.74*10-9 (gr*cal/cm²/gun) 0.66 mb/C° 19.82 mmHg 19.94 mmHg Translated with Google Lens
Find the heat loss rate per square meter through the thermal wall of a furnace that operates at 1000°C. The temperature of the outer surface of the furnace wall is 100°C and the thickness of the wall is 10cm. (Average thermal conductivity of refractory clay = 1.3 J/smk)
i need the answer quickly
Calculate the clean-bed head loss with Ergun Equation through a deep-bed anthracite filter with 1.8m of ES = 0.95 mm media at a filtration rate of 15 m/h and a temperature of 15 C. (Accept: KV = 228, Kl = 4.4, and ɛ = 0.50. Values of pW = 999 kg/m³ and µ = 1.14 ×103 kg/m • ).
Compute the evaporation for the month of June from a shallow pond if the surface water temperature is 20°C, the average wind speed at 7.5 m height is 1.5 m/s, and the average temperature and relative humidity at 7.5 m height are 22°C and 40%, respectively. Use mass-transfer method.
Ex12.3 :the daily groundwater recharge 4mm/day, depth of covered drain 2m,the permissible depth of groundwater 1.2m below soil surface, radius of drain pipe 0.1 m. Find the spacing of drains under the following states: Drain is laid on the impervious layer. The soil is homogeneous with K=1m/day. Drain is 15m above the impervious layer. The soil is non-homogeneous ,the first layer have K=1m/day while the second layer have 0.5 m/day. Drain is 3m above the impervious layer. The soil is homogeneous with K-0.8m/day. Use any available equations (Hooghoudt, Kirkham and Dagan)
Q2. A settling tank sludge sample is tested for solids. The sample and the dish weight (74.69) g, the dish weight (21.2) g. after drying, the dish with dry solids weight (22.3) g. what is the percent of total solids (%TS) in the water sample?