Representing a transmission line by the two-port network, in terms of ABCD parameters, express Vs, which is thesending-end voltage, in terms of V, which is the receiving-end voltage, and I, the receiving-end current,

The sending end voltage in the form of receiving end parameters.

Representing a transmission line by the two-port network, in terms of ABCD parameters, express Vs, which s the sending-end voltage, in terms of V, which is the receiving-end voltage, and I, the receiving-end current,

Representing a transmission line by the two-port network, in terms of ABCD parameters, express Vs, which s the sending-end voltage, in terms of V, which is the receiving-end voltage, and I, the receiving-end current,

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: 4. Construct or build the Z-bus matrix for the network shown in beloOw fig. below by using KRON node…

Q: b) Write ABCD Parameters of the nominal Tt model of the medium transmission line.

Q: A transmission line of 50 m long as shown in the figure below has Zo = 40 + j70 2, V. = 20 20 Vrms,…

Q: The ABCD parameters of a 200-km, 230-kV, 60-Hz three-phase line are A = D= 0.968 Z0.32, B=97.32480 2…

A: A transmission line ABCD parameters are given . Find the sending end voltage Sending end current…

Q: Choose the correct Answer: ETC Department of UTAS-NIZWA wants to install the cable in the computer…

A: There are three fiber optical cables are given as we know fiber optical cable has high bandwidth.…

Q: a) Obtain ABCD parameters using the nominal t model. b) Obtain sending voltage V, and the current I,…

Q: Obtain the input impedance expression Zent for a transmission line terminated in short circuit

Q: A 29 Km line is terminated by its characteristic impedance. At a certain frequency the voltage at 1…

A: As the line is terminated at characteristic impedance .Hence, it is considered to be equal to…

Q: Answer A=cosBl B= jZ0sinBl C=jY0sinBl D=cosBl I think it's impossible to understand. I don't…

A: Step 1: Step 2: Step 3:

Q: Write down the equations which you used for the derivation of A, B, C and D constant of the…

A: The solution can be achieved as follows.

Q: What are the transformation relations between the scattering (S) parameters and the Z, Y, ABCD and T…

Q: your own words: Define the admittance а-[ parameters of a two-port network, how many admittance…

A: In this question , we will define admittance parameter of two port network...

Q: Q1. A transmission line of any length can be represented by the four-terminal network with ABCD…

A: To represent an Electrical Transmission line we can use ABCD parameters . Based on the length of…

Q: QUESTION 3 A 400 km, 138 kV, 60 Hz transmission line has the following distributed parameters: r =…

Q: A 400kV, 200km, 3-phase transmssion line have the follollowing parameters per phase: z = 0.14+j0.304…

A: Given data, Voltage VR=400 kV z-parameter z=0.14+j0.304 Ω/km y-parameter y=j5.306×10-6 s/km

Q: A 350 km transmission line has the following parameters: z = 0.0195 +j0.35 Ω/km y = j4.5 μS/km Part…

A: We are authorized to answer three subparts at a time since you have not mentioned which part you are…

Q: 3. Summarize the ABCD constant formulae for the short, medium and long transmission line.

Q: Q1: The parameters of long three-phase transmission line 200 km with 50 Hz are l = 1.3 mH/km, c = 9…

A: Given length of the line, l=200km. The impedance per unit is calculated as

Q: a) For the network shown in figure 3a below, determine the output voltage Va given that the two port…

A: The hybrid parameters are represented in equivalent circuit as: where, h11 is in ohms, h22 is in…

Q: A 400kV, 200km, 3-phase transmssion line have the follollowing parameters per phase: z = 0.14+j0.304…

A: It is given that: VR=400 kVl=200 kmz=0.14+j0.304 Ωkmy=j5.306×10-6 skm

Q: Voltage Regulation (VR) is the change in the voltage at the receiving end of the line when the load…

Q: The parameters of a transposed overhead transmission line are given as: Self reactance x, = 0.4 2/km…

A: Given: A transposed overhead line, Self reactance Xs=0.4 Ω/km Mutual reactance Xm= 0.1 =Ω/km

Q: For a one port network, explain the effect on the admittance frequency characteristics when it has a…

A: In the question, What is effect of frequency in admittance of path if Element is connected to…

Q: · The ABCD parameters of a 215-kV 400km 50 Hz three phase transmission line are: A=0.877/1.57"…

Q: For all three types of transmission line prove that, AD-BC = 1, where ABCD are the transmission line…

A: Transmission line parameters or ABCD parameters are very important for the analysis of ABCD…

Q: Discussion :1 - What do you mean by the generalized A, B,C,D constants of Transmissiom Line ? 2 -…

Q: 1. Show that it is impossible to construct a three-port network that is lossless, reciprocal, and…

Q: Question 3 Z/2 Z/2 R/2 R/2 X/2 X/2 lab Y V, Nominal T model of a Medium Line Circuit Globe Figure 2…

Q: 1. In a parallel communication, each bit requires a transmitter and receiver. a) True b) False 2.…

A: Note :- As per guidelines we are supposed to answer only 3 questions. So I request you to please…

Q: Supposed a three-phase transmission line is having following parameters. Sending End Voltage, Vs=…

A: We are authorized to answer three subparts at a time. Since you have not mentioned which part you…

Q: Let x(n) be a finite duration sequence of length 8 such that x(n)= {1,2,1,2,1,3,1,3} find x(k) using…

A: given sequence X(K)={1,2,1,2,1,3,1,3}

Q: In a semiconductor crystal, the atoms are held together by O Forces of repulsion O lonic bonds O…

A: In the semiconductor crystal, The atoms are together by sharing the electron pairs. And The bond…

Q: Q1. A transmission line of any length can be represented by the four-terminal network with ABCD…

Q: The SNR for coherent communication :system is higher than non-coherent True O False O

A: From the above question, SNR stands for the signal-to-noise ratio. A higher value of SNR is…

Q: Determine the transmission parameters for the two port network shown below 20

Q: In a lossless T-junction power divider, the characteristic impedance of the input port is 50 N. If…

A: An T junction power divider is simple 3 port network that can be used for the purpose of…

Q: p03 + jo.o05 N/km and shunt admittance of 2.93 x 10-6 S/km. It delivers 350 MVA 169 kV, with 0.95…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: 8. For reciprocal two-port electrical network, the mutual parameters are.......? a. unequal. b.…

Q: Question 1. The impedance of a 150 km long transmission line is z = 0.06+ j0.48 2/km, and the shunt…

A: Transmission Line:Transmission lines transmit electric energy from source to destination in an…

Q: (b) Supposed a three-phase transmission line is having following parameters. Sending End Voltage,…

Q: A 50 Hz, 100 km long, 3-o o/h transmission line has the following constants: Series impedance/phase,…

A: We use nominal π method to calculate the ABCD constant , sending end voltage and current, voltage…

Concept explainers

Transmission Line Parameters

The performance of a power system is mostly determined by the producing stations and transmission lines in the system which can be studied with the help of transmission line parameters.

Question

Representing a transmission line by the two-port network, in terms of ABCD parameters, express Vs, which is the
sending-end voltage, in terms of V, which is the receiving-end voltage, and I, the receiving-end current,

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: To determine

VIEW

Step 2: Explanation

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Transmission Line Parameter (T-parameter)

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

From the given expressions of the parameters of medium length transmission line, which one will have a value nearing to 1? Select one: O a. Ye (1+Zine Ye) O b. Ztine Yc 1+ 4 Ziine Yc 1+ Zline Yc 1+ d. Yc 4
A 160-km, 230-kV, 60HZ, 3-phase line has the following parameters: R=0.0812/km, L=1.275mH/km, and C=8.86nF/km. At full load, the line delivers 250MW at 0.9 pf lagging and 230 kV. Using the z circuit model, calculate the followings: (a) The ABCD parameters, The sending end voltage and current, The percent voltage regulation, and Full-load line losses and efficiency (b) If the resistance were neglected (R=0), what would happen to full-load line losses and efficiency? Waito Your Answers below:
Please clearly
Explain 2-port network with their types.
Q.2: Given a binary symmetric channel with transmission matrix shown below; Determine the channel capacity S0.8 0.2) P(y/x) = {0.2 0.85
Given: gm1=10mS, gm2=25mS, Rin;=0, Rout;=1.5kohms For AC equivalent circuit, replace coupling and bypass capacitors with short circuits. Find the two-port parameters: Vcc 1. Rout, and Rin, 2. Avı and Av2 RA Rp2 Ro1 1.5 kN C3 5 kN 1.5 kN C5 out Vin Q2 RB 5 kN C2 R$2 C4 Rs1
Consider the transmission line model below. Parameters R', L', G',C' are given on a per length basis. (a.1) G'A C' az Using the circuit model above, derive the telegrapher's equation below: a v(z, t) dz R' i(z, t) + L' a i(z,t) at The following identity may be helpful: a lim f(x)
Find the ABCD constants of a network consisting of a 500-ohm resistor shunted across its sending end, a 1000 ohm resistor shunted across its receiving end and 100 ohms of resistance in series between the sending and receiving end.
For a medium transmission line, VRNL is equal to Vs . Select one: O True O False ge
Consider a step down converter supplied by a DC power source of magnitude Vs = 220 V. The switching period is 0.1 ms and the duty cycle k is set to 0.5. The load is an inductive load with R=5 Ohms and L=10 mH. The switch is ideal. The RMS converter current IR is equal to 15.56A. The ripple factor of the input current RFs would be equal to: Select one: a. 0% Ob. 50% Oc. 100% d. None of these
b) Write ABCD Parameters of the nominal π model of the medium transmission line.
(b) Supposed a three-phase transmission line is having following parameters. Sending End Voltage, Vs= 355 kV Distance, l = 145 km Resistance, R= 0.041 Q/km Inductance, L = 0.75 mH/km Shunt Capacitance, C = 0.0123 µF/km Receiving End Voltage, VR = 335 kV Receiving End Power, Sr = 265MVA Power Factor, p.f= 0.8 lagging By taking frequency as 60 Hz, (i) Draw the nominal t model of above transmission line.