R1 R2 A R5 В R4 R3 R6 R7 The circuit above has R1 -820 Ω, R2-220 Ω, R3470 Ω, R4 - 910 Ω, R5 -560 Ω R6 = 330 Q, and R7 = 680 Q and an equivalent resistance looking into points A and B of RAB = 2244.8 N. The voltage applied to the circuit is VAB = 100 V. Determine the power dissipated by R4. PR4 = 0.1214 W PR4 = 0.0293 W PR4 = 0.6549 W PR4 = 0.0627 W %3D

R1 R2 A R5 В R4 R3 R6 R7 The circuit above has R1 -820 Ω, R2-220 Ω, R3470 Ω, R4 - 910 Ω, R5 -560 Ω R6 = 330 Q, and R7 = 680 Q and an equivalent resistance looking into points A and B of RAB = 2244.8 N. The voltage applied to the circuit is VAB = 100 V. Determine the power dissipated by R4. PR4 = 0.1214 W PR4 = 0.0293 W PR4 = 0.6549 W PR4 = 0.0627 W %3D

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter7: Parallel Circuits

Section: Chapter Questions

Problem 3PP: Using the rules for parallel circuits and Ohmslaw, solve for the missing values....

See similar textbooks

Similar questions

Using the rules for parallel circuits and Ohmslaw, solve for the missing values. ETE1E2E3E4ITl1I2l33.2AI4RT3.582R116R210R3R420PTP1P2P3P4
Subject: CircuitsGivenRt = 37.9529 ohm..Rcd = 3.6 ohm.Rab=2.3529ohmIt=1.58APt=94.85WV2=3.16VV4=6.32VVab=3.7175vVcd=5.688VI10=0.372AI5=0.7435AI8=0.465AI9=0.632AI6=0.348AP2=4.9928WP4=9.9856WPab=5.88WP14=34.95WPcd=8.99WP12=29.96W
Current Attempt in Progress In the figure R₁ = R₂=4.502, R3-7.202, R4 3.80, R5 1.302, and R6 R7 Rg=8.802, and the ideal batteries have emfs 1 = 26 V and 82-8.3 V. What are the (a) magnitude and (b) direction (up or down) of current is and the (c) magnitude and (d) direction of current i2? What is the energy transfer rate in (e) battery 1 and (f) battery 2? Is energy being supplied or absorbed in (g) battery 1 and (h) battery 2? (a) Number i (b) (c) Number (d) O (e) Number i (8) O (f) Number i (h) O O R₁ R₂ www R₂ R₂ Ro Units Units Units Units ww www R₂ R₁ 4 8,0 342 R₂ O O
In circuit shown in figure, the operating point is chosen such that Ic 1.57 mA, VCE = 3.1V,If Rc = 2.5 KO, Vcc = 9 V and B = 49 %3D Determine the values of R1, R2 and Rg [VBE = 0.7 V and l = 10B] Rc R1 VCC RE R2 [5A www ww ww www
this is electric circuit questin ...plz solve it early .plz solve early
What is an SF6 circuit breaker? Write down the construction and working of and SF6 circuit breaker. Please don't write on paper
In the circuit in the figure, the amplitude of the input current is 5 Amps and its phase is 0 degrees, the amplitude of the input voltage is 18 volts and its phase is 90 degrees. How many volts is the amplitude of the voltage phasor V on capacitor C1? Values of the elements in the circuit:R= 14 OhmsC1= 10j OhmsC2= -3j OhmsL= 4j Ohms
What is the total current for the circuit in the figure below? Given: R = 3000 Xc= 150 120 v 60 Hz Select one: O a. 266.7 mA O b. 894 mA O c. 989 MA O d. 1.2 A R Xc
Figure shows a transistor switching circuit. Find the Vcc and Rc, which causes the output voltage to have a peak to peak value of 6V (given that the input voltage signal Vi, and the output voltage signal Vo, have units of Volt) Fone: V₁ 10k2 www +Vcc Rc V₂ B-100
Determine the currents IR1 and IR2, (show as positive values – actual current direction). Verify in Multisim using measurement probes or digital multimeter
Using the supernode concept to determine the voltage marked v20 in the figure, the crossed wires that are not marked by a thick dot are not in physical contact.
In the circuit below, when a 2.2KN load is connected to the output, find the value of the current flowing through the R resistor (IR), the current passing through the zener diode (Iz) and the load current value (IL). Sigorta T1 Dr-De 1N4001 0,1A REGOLATOR D 220V AC Va-20V Vs AC Va 2200 De Vi-13V 15V 4700uF IN47448 Nominal Test Maximum Dynamic Impedance Maximum Reverse Zener Current Leakage Current Voltage) Vz @ IzT IZT ZT @ IzT ZZK @ IzK IZK IR Test Voltage VR V mA Ω Ω mA µA V 15 17 14 700 0.25 11.4 llle