R w.. I L m Vm 20 C HI Calculate the following: a. Inductive reactance, Capacitive reactance b. Impedance, Circuit current c. Phase angle, power factor d. Circuit Powers: P, Q, S e. Resonant frequency, Q and BW Given the following R = 60 92 L = 0.30 H C = 17 uF Vac = 24V, 50Hz

R w.. I L m Vm 20 C HI Calculate the following: a. Inductive reactance, Capacitive reactance b. Impedance, Circuit current c. Phase angle, power factor d. Circuit Powers: P, Q, S e. Resonant frequency, Q and BW Given the following R = 60 92 L = 0.30 H C = 17 uF Vac = 24V, 50Hz

Physics for Scientists and Engineers

10th Edition

ISBN:9781337553278

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter32: Alternating-current Circuits

Section: Chapter Questions

Problem 20P: A 60.0-ft resistor is connected in series with a 30.0-F capacitor and a source whose maximum voltage...

See similar textbooks

Related questions

Q: 3. In your initial ocular visit to the site, you measured the radius of the curved path that is 40…

Q: A uniform plank has a mass of 4.00 kg and a length of 10.0 m. A fulcrum is placed below the plank at…

Q: For problem 28.9, solve for the magnetic field (For problem 28.9, solve for the magnetic field (in…

A: The motion of the electron is in straight line therefore the forces in vertical direction due…

Q: The figure below depicts a ball in flight. The direction of the airflow is indicated by the stack of…

Q: 4. CA shopper in a supermarket pushes a cart with a force of 35 N directed at an angle of 25° below…

A: Write the given values with the suitable variables. F=35 Nθ=25°d=50 m Here, F, θ, and d are the…

Q: Questions 1 and 2 refer to the velocity vs. time graph below for an object moving along a flat…

A: 1. In the following velocity time graph, we can see that at points b and d, the line changes its…

Q: 1. How does this coefficient compare to the coefficient of the block (wooden side down) obtained…

A: The earlier obtained coefficient of the block (wooden side down) is µs (wooden side down) = 0.338…

Q: e the work done by friction as a 3.7 kg box is slid along a floor from point A to point B in the…

Q: student rolls a stell ball of the edge of a table at a velocity of 3.4m/s. How tall must the table…

Q: In the 2011 nuclear accident at Fukushima, Japan, an ENV earthquake-triggered tsunami wiped out…

A: Solution are attached below

Q: 1. For every force exerted to an object, an equal force with the same direction will react to it. 2.…

A: 1. True For every force there exists an equal and opposite force. This is Newton's 3rd law of…

Q: E7. Starting from rest, a merry-go-round accelerates at a con- stant rate of 0.2 rev/s². a. What is…

A: Given: The initial angular velocity is 0 rev/s. The angular acceleration is 0.2 rev/s2. The time…

Q: Exercise 4-9: A child's playground slide is d = 5. Om in length and is at an angle of 0 = 20° with…

A: Distance= d = 5 m Mass = m = 30 kg Angle = 20 degrees

Q: Consider three periods in the history of the Universe: one million years after the Big Bang (age = 1…

A: In early times, the Universe was expanding at a rapid pace. Then, the rate of expansion of the…

Q: opper-63 has a nucleus mass of 62.92959 u. Its atomic number is 29, and its atomic mass number is…

Q: A steel cable with total length 32.4 m and mass 96.8 kg is connected to two poles. The tension in…

Q: A force F(x) = bx³ acts on a potato as it moves along the x-axis from the origin to 4.1 m. How much…

Q: Macmillan Learning The graph shows the x-directed force F, acting on an object as a function of the…

A: In the Force-displacement diagram, work done is the area under the curve.

Q: what happens to the de of a fraction when the numerator (the top) approaches (gets very close to)…

A: Fraction = numeratordenominator

Q: A place kicker A executes a "pooch" kick, which is designed to eliminate a potential return by the…

Q: Velocity vs. Time Graph Attempt #2 (sa) What is the change in velocity in section a? What is the…

A: The area under a velocity time graph gives the distance covered by the object.

Q: A small rock is thrown vertically upward with a speed of 22.4 m/s from the edge of the roof of a…

A: a) Apply the third kinematic equation to determine the speed of the rock just before it hits the…

Q: The cranes shown in the figure are lifting an object that weighs 20,200 pounds. Find the tension in…

A: In the following problem, we have cranes shown in the figure, which are lifting an object that…

Q: Problem 7.05. A typical internal combustion engine vehicle can provide roughly 170. ft- lbs of…

A: Petrol engines in personal vehicles generate lower torque than diesel engines, the practical…

Q: Four capacitors are connected as shown in the figure below. (Let C = 12.0 µF.) 3.00 με a с th.…

Q: A 7.80-g bullet moving at 575 m/s penetrates a tree trunk to a depth of 5.50 cm. (a) Use work and…

Q: (1) Which pulse should you choose? A. #1 B. #4 C. #3 D. #2 E. none of these (2) Which point on the…

Q: Eight and one-half foot-pounds of work is required to compress a spring 6 inches from its natural…

A: Given that, The compression length of the spring is x=6in=0.5ft And the work done is W=8.5ft.lb If…

Q: ppose seconds. What is its displacement in radians in this time? What is its average rotational…

A: Given value--- angular displacement = 5 rev. time = 4 sec. We have to find--- displacement?…

Q: Problem 7.11. (a) Calculate the angular momentum of an ice skater spinning at 6.00 rev/s given his…

Q: A string is tied to a 3.2 kg object on a table and a 1.5 kg object hanging over a pulley. The…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: rhead view of part of a pinball game is shown. If the plu celeration a of the ball (a) at time t =…

Q: RC Circuits: For the circuit shown in the figure, C = 13 µF and R = 7.6 MS. Initially the switch S…

Q: You are moving a sled with a force of 85.7 N in the positive direction with a friction force of 33.7…

Q: 1. Find the equivalent resistance between points A and B for the resistors shown in the figure. A+…

A: Given:

Q: Consider the net work required to stop a moving object. a. What is the net work, in joules,…

Q: A 700 N person walks up 10 stairs, each of height 30 cm. How much work was performed by the person?

A: Given value--- weight of person = 700 N. height of each stair = 30 cm. number of stairs = 10 . We…

Q: A conical pendulum is constructed with a string length of 0.475 meters and is set into motion with a…

A: For the conical pendulum, the time period equation can be derived as below: T cos θ = mg T =…

Q: 2. Find the current through and potential difference across each resistor shown in the figure.…

A: .

Q: one of your friends decides to fish "the old fashion way" and picks up a stick to fish. you watch…

A: I tell my friend that he keeps missing the fish because of the phenomenon of refraction of light.…

Q: 3-8 As shown in the figure below, the stopped truck is carrying cargo with mass MA and accelerating…

Q: This warm-up question refers to an experimental rotational device that you will see in operation in…

Q: An sled of mass, m, is pulled, so that it accelerates, along a surface by a force P at an angle as…

Q: A metal at 150°C is placed in a cool room at 30°C. After 1 hour, the temperature of the metal…

Q: A thin copper rod 1.4 m long has a mass of 0.070 kg and is in a magnetic field of 0.18 T. What…

A: Length of rod (L) = 1.4 m mass (m) = 0.07 kg magnetic field (B) = 0.18 T

Q: (a) Roads in Canada are typically made out of asphalt or concrete. Is one material significantly…

Q: A loop of wire with radius r=0.075m is placed in a region of uniform magnetic field with magnitude…

Q: E17. A uniform disk with a mass of 4 kg and a radius of 0.3 m is rotating with a rotational velocity…

Q: A Carnot engine works at a high temperature of 420C with the efficiency of 42%. If the efficiency of…

Q: A 75-kg skier starts from rest at the top of a hill that makes an angle of 35◦ below the horizontal.…

Question

R
www.
I
L
m
Vm 20
C
Calculate the following:
a. Inductive reactance, Capacitive reactance
b. Impedance, Circuit current
c. Phase angle, power factor
d. Circuit Powers: P, Q, S
e.
Resonant frequency, Q and BW
Given the following
R = 60 Ω
L = 0.30 H
C = 17 uF
Vac = 24V, 50Hz

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Writing the given data

VIEW

Step 2: Finding the inductive reactance and the capacitive reactance

VIEW

Step 3: b) Finding the impedence and the circuit current

VIEW

Step 4: c) Finding the phase angle and the power factor

VIEW

Step 5: Conclusion

VIEW

Step by step

Solved in 5 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

At s1iat frequency is the reactance of a 20F capacitor equal to that of a 10-mH inductor?
At 1000 Hz, the reactance of a 5.0-mH inductor is equal to the reactance of a particular capacitor. What is the capacitance of the capacitor?
The self-inductance and capacitance of an oscillating LC circuit are L = 20 mH and C = 1.0 F , respectively. (a) What is the frequency of the oscillation? (b) If the maximum potential difference the plates of the capacitor is 50 V, what is the maximum current in the circuit?
A 2.0-F capacitor is charged to a potential difference of 12.0 V and then connected across a 0.40-mH inductor. What is the current in the circuit when the potential difference across the capacitor is 6.0 V?
An LC circuit in an AM tuner (in a car stereo) uses a coil with an inductance of 2.5 mH and a variable capacitor. If the natural frequency of the circuit is to be adjustable over the range 540 to 1600 kHz (the AM broadcast band), that range of capacitance is required?
An RLC series circuit has a 200 (resistor and a 25.0 mH inductor. At 8000 Hz, the phase angle is 45.0°. (a) What is the impedance? (b) Find the circuit’s capacitance. (c) If Vrms = 408 V is applied, what is the average power supplied?
At what time is the voltage across the inductor of the RL circuit of Figure 14.12(b) a maximum?
An RLC series circuit hag a 1.00 k(register, a 150 (H inductor, and a 25.0 nF capacitor. (a) Find the circuit’s impedance at 500 Hz. (b) Find the circuit’s impedance at 7.50 kHz. (c) It the voltage source has Vrms = 408 V, what is Irms at each frequency? (d) What is the resonant frequency of the circuit? (e) What is Irms at resonance?
A 60.0-ft resistor is connected in series with a 30.0-F capacitor and a source whose maximum voltage is 120 V, operating at 60.0 Hz. Find (a) the capacitive reactance of the circuit, (b) the impedance of the circuit, and (c) the maximum current in the circuit. (d) Does the voltage lead or lag the current? (e) How will adding an inductor in series with the existing resistor and capacitor affect the current? Explain.
An RLC series circuit has a 2.50 (resistor, a 100 (H inductor, and an 80.0 (F capacitor. (a) Find the circuit's impedance at 120 Hz. (b) Find the circuit’s impedance at 5.00 kHz. (c) If the voltage source has Vrms = 5.60 V, what is Irms at each frequency? (d) What is the resonant frequency of the circuit? (e) What is Irms at resonance?
A series RLCcircuit contains a 20.0- resistor, a 0.750-F capacitor, and a 120-mH inductor. (i) 11 a sinusoidally varying rms voltage of 120 V at f = 500 Hz is applied across this combination of elements, what is the rms current in the circuit? (a) 2.33 A (b) 6.00 A (c) 10.0 A (d) 17.0 A (e) none of those answers (ii) What If? W hat is the rms current in the circuit when operating at its resonance frequency? Choose from the same possibilities as in part (i).
Check Your Understanding The angular frequency of the oscillations in an LC circuit is 2.0103rad/s . (a) If L = 0.10H, what is C? (b) Suppose that at t = 0, all the is stored in the inductor. What is the value of ? (c) A second identical capacitor is connected in parallel with the original capacitor. What is the angular frequency of this circuit?