QUESTION:4 A 10ko resistor is to be designed to handle a current density of 50A/cm when a 5V is applied. If this resistor is limited to electric field of E =100 cm?/V-s, calculate: i current passing through the resistor ii cross-sectional area iii length of the resistor iv conductivity v carrier concentration

QUESTION:4 A 10ko resistor is to be designed to handle a current density of 50A/cm when a 5V is applied. If this resistor is limited to electric field of E =100 cm?/V-s, calculate: i current passing through the resistor ii cross-sectional area iii length of the resistor iv conductivity v carrier concentration

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter12: Electronic Control Devices

Section: Chapter Questions

Problem 14RQ

See similar textbooks

Similar questions

nichrome ribbon resistor elements each has a resistance of 1 ohm. the element is made from sheet of nichrome alloy, 0.025 cm thick. if the width 9f the ribbon is 0.3 cm , what is the length is required per element? assume specific resistance of nichrome alloy to be 10g micro ohm-cm
Nichrome ribbon resistor elements each has a resistance of 1 ohm. The element is made from sheet of nichrome alloy, 0.025 cm think. If the width of the ribbon is 0.3cm, what length is required per element in cm? Assume specific resistance of nichrome alloy to be 109microOhm-cm.
A resistor has a resistance of 43.6 ohm at 20°C and 50.8 ohm at 60°C. Determine the temperature coefficient of resistance of aluminium at 0°C, its resistance at 0°C and at 40°C.
Determine the values of resistance R and inductance L
A two wires, one of Copper and the other of Nickel, if the resistance of the first is (12.7 Q), and the second is (11.6 0) at room temperature, at what temperature are their resistances equal? Note that the temperature coefficient of resistivity of Copper is (0.0039 C-1), and for Nickel it is equal to (0.006 C1).
Notes on the verification of ohm's law by voltage method?
Look for Requivalent(Equivalent Resistance).Please show details
topic: Resistance and ohms law
The following figure shows: 2Ix Oa. A dependent current controlled current source Ob.A dependent current controlled voltage source OC. A dependent voltage controlled current source Od.A dependent voltage controlled voltage source +1
An aluminum wire 7.5 m long is connected in parallel with a copper wire 6 m long. When a current of 5 A is passed through the combination it is found that the current in aluminum wire is 3 A. The diameter of aluminum wire is 1 mm. Determine the diameter of the copper wire. Resistivity of copper is 1.7 x 10 “ ohm-cm and that of aluminum is 1.724 micro-ohm-cm.
2.2. The electrons in a piece of n-type semicon- ductor take 10 ps to cross from one end to another end when a potential of 1 V is applied across it. Find the length of the semiconductor bar.
the non-inductive resistance of kelvin double bridge are set at 100ON each, the standard resistance is set at 0.10020 and the low resistance 0.0000122 was very low. determine the unknown resistance