Question- Topic: Traffic Studies on Flow, Speed, Travel Time, Volume and Capacity The lost time due to starting delay on a traffic signal approach is noted to be 3 sec, the actual green time is 20sec and the amber time is 3sec. How much is the effective green time?

Question- Topic: Traffic Studies on Flow, Speed, Travel Time, Volume and Capacity The lost time due to starting delay on a traffic signal approach is noted to be 3 sec, the actual green time is 20sec and the amber time is 3sec. How much is the effective green time?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

An intersection has a three-phase signal with the movements allowed in each phase and corresponding analysis and saturation flow rates shown in the table below. Assume the lost time is 4 seconds per phase and a critical intersection v/c of 0.90 is desired. O 20.464 sec O 22.411 sec O 24.460 sec Phase O 21.035 sec Allowed movements Analysis flow rate Saturation flow rate Using v/c equalization ratio, calculate the effective green time for phase 2 NB L, SB L 330, 365 veh/h 1700, 1750 veh/h 2 NB T/R, SB T/R 1125, 1075 veh/h 3400, 3300 veh/h EB L, WBL 110, 80 veh/h 650, 600 veh/h 3 EB T/R, WB T/R 250, 285 veh/h 1750, 1800 veh/h
A pretimed four-phase signal has critical lane group flow rates for the first three phases of 200, 187, and 210 veh/h (saturation flow rates are 1800 veh/h/In for all phases). The lost time is known to be 4 seconds for each phase. Assuming X₁ = 0.9. If the cycle length is 60 seconds, what is the estimated effective green time of the fourth phase? 6.93 sec O 21.89 sec Ⓒ 7.78 sec Q 7.41 sec
Solve it accurate.
25 The table below shows the design flow rate and saturation flow rate for a major intersection on a highway. Using the Webster method, determine the optimum cycle length for the intersection and also determine the green time for each phase. Design Flow Rate (pcu/hr) Through Phase Saturation Flow Rate (pcu/hr) Intergreen period (sec) Left Through Left A 976 234 3700 1615 3.5 676 135 3700 1615 3.5 194 26 3700 1615 3.5 322 371 3700 1615 3.5
Transportation Engineering Roll No. - 69 do the numerical part 2. Explain with the help of sketches various types of highway intersections. The 15 minute design traffic volume on cross road 1 and 2 during peak hour are observed as 180+R.No. and 150+R.No. vehicles per lane respectively. If the amber times required are 4 and 3 seconds respectively for two roads, design the signal timing by trial cycle (or exact) method. Assume average time headway of 2.5 sec during green phase. CO3
Question 2: The collected data in Table (1) from speed and delay studies by floating car method on a segment of urban road of length 3.5km, running North-South are given in table below: Table (1) Collected field data Trip No. Direction Journey of Trip Total No. of No. of No. of time stopped delay Min. sec. vehicles vehicles vehicles Min. sec. overtaking overtaken from opp. direction 1 N-S 6 32 1 40 4 7 268 S-N 7 14 1 50 3 186 3 N-S 6 50 1 30 280 S-N 7 40 2 00 1 200 6 10 1 10 2 22 N-S 3 250 S-N 8 00 170 7 N-S 6 28 1 40 2 290 8. S-N 7 30 1 40 2 160 Estimate the average travel time for North -South and South – North directions respectively.
An approach to a pre-timed signal has 40 sec of effective green in a 75-second cycle.The approach volume is 700 veh/h and the saturation flow rate is 1600 veh/h.Calculate the time to queue clearance after the start of the effective green, themaximum number of vehicles in the queue, the total vehicle delay per cycle andthe average delay per vehicle assuming D/D/1 queuing.
An observer notes that an approach to a pretimed signal, the time it will take the queue to clear after the start of the effective green (assuming that approach capacity exceeds arrivals and D/D/1 queuing applies) is 60 s. If the saturation flow rate is 1440 veh/h and the effective red time is 40 seconds, what is the maximum number of vehicles in a queue in a given cycle?
plz, solve this problem, it is not graded question. Transportation Engineering-1
Q2: What are the assumptions for using the equations in the queue test? Q3: A signalized intersection, of 105 sec cycle length, the east approach has an effective green time of 20 sec, and the percentage of vehicles arriving during green time is 28%. The west approach has 16 sec green time and 32% of vehicles arriving during the green time. Determine which approach is best coordinated with the upstream signal.
An intersection has a three-phase signal with the movements allowed in each phase and corresponding analysis and saturation flow rates shown in the table below. Assume the lost time is 4 seconds per phase and a critical intersection v/c of 0.90 is desired. Phase 3 Allowed movements NB L, SB L NB T/R, SB T/R EB L, WB L EB T/R, WB T/R Analysis flow rate 330, 365 veh/h 1125, 1075 veh/h 110, 80 veh/h 250, 285 veh/h Saturation flow rate 1700, 1750 veh/h 3400, 3300 veh/h 650, 600 veh/h 1750, 1800 veh/h Using v/c equalization ratio, calculate the effective green time for phase 1 O 15.954 sec O 12.105 sec O 14.127 sec O 13.190 sec
Subject: transportation engineering Read the question carefully and give me right solution according to the question. A signal has four phases, where the critical lane group flow ratios are 0.115, 0.204, 0.099, and 0.248. If the lost time per phase is 6 seconds and the critical intersection v/c ratio is 0.88, calculate the minimum cycle length and the phase effective green times such that the lane group v/c ratios are equal.