Please try sir Question No. 13A transmission line has a total series reactance of0.2 pu. Reactive power compensation is applied atthe midpoint of the line and it is controlled suchthat the midpoint voltage of the transmission lineis always maintained at 0.98 pu. If voltage at bothends of the line are maintained at 1.0 pu, then thesteady state power transfer limitof thetransmission line is

Answered: Image /qna-images/answer/41dfa316-07f3-44ba-b7c4-e308711ee4b9.jpg

Answered: Question No. 13 A transmission line has…

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter13: Transmission Lines: Transient Operation

Section: Chapter Questions

Problem 13.12P

See similar textbooks

Similar questions

Write True or False and correct the wrong statement (Ans 7. The unit nearest to the cross-arm in tower has maximum voltage across it and hence it likely to be repaired. 8. Corona losses in DC Transmission supply 10 times more than AC transmission. 9. Irregularity Factor (mv) has value of 0.9 to 0.95 in rough conductor. 10.Power losses in corona dissipated in the form of conductor vibrating. 11. The corona loss on a particular system at 50 Hz is 1 kW/Km per phase but for the same system but 60 Hz will be 1.5 kW/Km per phase. 12.If the number of poles in 3ph 11kV transmission line is 80, then we need 420 discs to suspend the conductor on these poles.
The active component of line current in figure 1 is______. a. 12A b. 20A c. 12A d. 4A
The sequence component line-to-line voltages of a three-phase, 4-wire system are the following: Vab0 = 60cis(-60); Vab1 = 80cis(-12); and Vab2 = 120 cis(40) volts. What is the magnitude of Vbc in volts?
Transmission line conductance is usually neglected in power system studies.
Write True or False and correct the wrong statement (An 7. The unit nearest to the cross-arm in tower has maximum voltage across it and hence it likely to be repaired. 8. Corona losses in DC Transmission supply 10 times more than AC transmission. 9. Irregularity Factor (mv) has value of 0.9 to 0.95 in rough conductor. 10.Power losses in corona dissipated in the form of conductor vibrating. 11. The corona loss on a particular system at 50 Hz is 1 kW/Km per phase but for the same system but 60 Hz will be 1.5 kW/Km per phase. 12.If the number of poles in 3ph 11kV transmission line is 80, then we need 420 discs to suspend the conductor on these poles.
Figure A7C.1. If power is being supplied to the circuit from Line 1, what's the first open-circuit condition encounteredin Figure A7?A. FB. BC. AD. C C.2- How many normally open auxiliary relay contacts are shown in the schematic diagram in Figure A7?A. 2B. 3C. 1D. 0 Figure A7C.3. What type of diagram is shown in Figure A7?A. Three-line schematic diagramB. Block diagramC. Wiring diagramD. Single-line ladder diagram
2. What's the primary instrument for locating a break in a cable during emergency maintenance?A. OSAB. OTDRC. MultimeterD. Power meter
Refer to Figure 1. Using its equivalent reactance diagram, what is the total impedance of the system up to the fault point at the end of the receiving line (in per unit)? Below are the parameters: G1 : 9 MVA, 13 kV, j0.11 p.u. G2 : 8 MVA, 13 kV, j0.06 p.u. T1 : 9 MVA, 13/69 kV, j0.042 p.u. TL : 262 km, 0.031 ohm per km, 0.3 ohm per km, operates at 69 Base values are that of G1. Round your answer to 2 decimal places. what is the fault MVA of the system when a three-phase fault occurs at the receiving end?
What is a grounding conductor? What is a grounding conductor (equipment)? What is a grounding electrode conductor? What is an outlet?
In the following network, the voltage magnitudes at all buses are equal to 1 p.u., the voltage phase angles are very small, and the line resistances are negligible. All the line reactances are equal to j1 p.u. (1) (2. P₂ = 0.1 p.u. P3 = 0.2 p.u. The voltage phase angle 83 in radian at bus 3 is (Assume one of the generator bus as slack bus and sin-¹ (0.1) = 0.1 rad) (a) -0.1 (b) -0.2 (c) 0.1 (d) 0
Fill in the blanks 1. Grounding is connecting …….. of electrical equipment to earth. 2. When a …………………………….… fault occurs on an ungrounded neutral system, the potential of the healthy phases rise to the line voltage. 3. The method of reactance grounding is not used because of ……………………… appearing under fault conditions. 4. The cosine of the angle between the ………………………………………. and the ………………………………...…… is called the sending end power factor. 5. The AC power delivered to a load is equal to ………........
Which termination would result to a phase change of 180 degrees at the load if Zo = 100 ohm? a. 50 ohm b. short circuit c. 75 ohm d. all of these What is the purpose of impedance matching? a. maximum return loss b. maximum SWR c. maximum load power d. maximum reflection A short piece of transmission line that may be open or shorted and used for impedance matching purposes. a. converter b. decoder c. stub d. transformer

SEE MORE QUESTIONS

Recommended textbooks for you

Power System Analysis and Design (MindTap Course …

Electrical Engineering

ISBN:

9781305632134

Author:

J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:

Cengage Learning