Question- A pressure gauge reads 62.3 kPa and 90 kPa respectively at heights of 7 m and 4 m fitted on the side of a tank filled with liquid. What is the approximate density of the liquid on kg/m³? A B 7m 4m

Question- A pressure gauge reads 62.3 kPa and 90 kPa respectively at heights of 7 m and 4 m fitted on the side of a tank filled with liquid. What is the approximate density of the liquid on kg/m³? A B 7m 4m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Q3: A U-tube containing mercury is used to measure the pressure of an oil of specific gravity 0.82…

Q: Find the differential mercury manometer gauge reading shown in the given figure if the pressure…

Q: -The cross-sectional area of one limb of a U-tube manometer is made 500 times larger than the other…

Q: Consider oil flowing through a horizontal pipe at a rate of 3 liter/s. There are two sections of the…

Q: Two pipes namely A and B are connected by a mercury manometer (SHg = 13.6). The fluid in both pipes…

A: SHg=13.6 To find h'

Q: An open tube is attached to a tank as shown. If Liquid X (Glycerin SG=1.26) rises to a height of 800…

A: Apply the principle of manometry the pressure at A can be easily calculated

Q: Meriam red oil, SG=0.827 P2.32 Water A 18 cm H 35 cm B Mercury

A: Given data:- The PB-PA=89.5 kPa=89500 Pa The specific weight of water is, Wwater=9790 N/m3 The…

Q: 10. The cylindrical container in the figure below weighs 400 N when empty. It is filled with water…

Q: A pressure gauge fitted on the side of a tank filled with liquid reads 50 kPa and 100 kPa at heights…

A: given- Pressure at height of 10 m=50 kPaPressure at height of 5 m=100 kPag=10 m/s2

Q: The spring of the pressure gauge shown in the figure below has a force constant of 1 100 N/m, and…

A: To find the change in depth

Q: Q9: For the shown figure, what is the difference in pressure between points A, B? S.9. = 0.92 water…

A: To find pressure difference between point A and B

Q: A differential manometer is attached to a pipe, as shown in the figure. Calculate the pressure…

Q: will be the pressure at the base of the

A: To find: Pressure at base of beaker. Given : The arm of a teapot is 10 cm long and inclined at an…

Q: Manometer with three liquids as shown. SGs are given. Calculate gauge pressure for oil. 20 KPa Water…

A: Given, to determine, Gauge pressure for oil.

Q: i) What is the gauge air pressure in the tank at Point 1?

Q: If the bottom of a pop bottle similar to that shown in the figure below, what would be the magnitude…

A: Given Air pressure in the top of the bottle = 38 psi Specific Gravity of Pop = S.G of water = 1…

Q: A simple U tube manometer is used to measure the pressure of oil flowing in a pipeline. Its left…

Q: Please help with solving

Q: A gasoline line is connected to a pressure gage through a double-U manometer, as shown. If the…

Q: 5.5 in. Open 1.4 in. Water Unknown fluid Open 4.9 in. 3.3 in.

Q: A mercury Manometer is attached to a pipe having suction pressure. The right limb is open to the…

A: Right limb which is open to atmosphere as per given data : For equilibrium condition a) Difference…

Q: As shown in Figure 1, an ideal gas flows isentropically from a large tank into a converging ozzle…

Q: Question 3:-A tank with 100.58 kPa pressure is connected with manometer to measure the pressure. The…

Q: Consider oil flowing through a horizontal pipe at a rate of 3 liter/s. There are two sections of the…

Q: -oil(sg.30.85) 680 mm 1700mm water

Q: Q2:- Calculate the absolute pressure at point B as shown in fig.(2). Neglect the density of air (25…

Q: -Oil SG 0.79 P = 260 kPa gage Gasoline SG = 0.70 Pipe Air- 45 cm 50 cm 22 cm 10 cm Water Mercury SG…

Q: A pressure gage 7.5m above the bottom of the tank containing a liquid reads65.45 kPa; another gage…

Q: A pressurized tank contains water with some air above it. As shown on figure below. Multi-fluid…

Q: Consider oil flowing through a horizontal pipe at a rate of 3 liter/s. There are two sections of the…

Q: Determine the capillary rise (in cm) in a glass tube of radius 0.25 mm that is immersed vertically…

A: Given data : Surface tension (σ)=0.0725 N/mRadius (r)=0.25 mmAssume Angle of contact (θ)=0∘

Q: Q1:- A 300 mm diameter of pipes and 350 mm long slides along a large diameter cylinder at a speed of…

Q: What is the pressure difference (PA - PB) measured by the U-tube manometer shown in the figure belov…

A: Manometer is used to measure pressure at any point caused by gases or liquid. It is used extensively…

Q: In the inclined manometer shown in the figure below, the reservoir is large. Its surface may be…

A: Specific gravity = 0.86Inclined glass tube length = 100θ = 30°Pressure at A=?

Q: Gasoline line is connected to a pressure gage through a double-U manometer, as shown in Figure (1).…

A: sign convention when moving downward = pressure positive when moving upward= pressure negative…

Q: WgvFANO PROBLEM 6:A gasoline line is connected to a pressure gage through a double-U manometer, as…

Q: 1. A container contains a certain liquid with unit weight of 7 KN/m³ to a depth of 4 m. Water is…

A: Note:- Hi! Thank you for the question As per the honor code, We’ll answer the first question since…

Concept explainers

Pressure and Stress

Question

100%

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given data-

VIEW

Step 2: Calculation-

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A gasoline line is connected to a pressure gage through a double-U manometer, as shown. If the reading of the pressure gage is 40 psi, determine the gage pressure of the gasoline line. Assume the unit weight of air to be 0.0765 lb/ft3.
Consider oil flowing through a horizontal pipe at a rate of 3 liter/s. There are two sections of the pipe with diameters 10 cm and 7 cm and the two sections are connected by a smooth reducing section as shown in the schematic. We use a manometer with glycerin as the manometer fluid (with glycerin density of Pglycerin 1,260 kg/m³) to measure the pressure difference between the two pipe sections. Assume that frictional effects are negligible and consider specific gravity of oil as SGoil = 0.76. What is the manometer reading, h (i.e. differential height of glycerin between the two arms of the manometer)? 10 cm I h T 7 cm-
A pressure gage 13.31 m. above the bottom of a tank containing a liquid reads 58.93 kPa; another gage at height 2.54 m. reads 82.68 kPa. Determine the density of the liquid. Round off to three decimal places.
A pressure gage 10.52 m. above the bottom of a tank containing a liquid reads 58.5 kPa; another gage at height 3.16 m. reads 85.83 kPa. Determine the density of the liquid. Round off to three decimal places.
What height of mercury column is equivalent to a pressure of 74 psig? The density of mercury is 498 Ibm/ft3. a. 11.28 ft O b. 21.40 ft c. 16.77 ft O d. 10.70 ft
In the figure shown, originally there is a H2=9 cm manometer reading and H1=15 cm. Atmospheric pressure is 101.3 kPa. what is the absolute pressure at A (kPa)? If the absolute pressure at A is doubled, what then would be the manometer reading (cm) ?
Refer to the picture below to solve the following problems
Q/ The laminar flow of water through a pipe is measured by means of a pitot tube situated in the center of the pipe; the reading of a mercury manometer connected to the pitot is 100 mm. The flow is also measured by a venturi meter which connected with the same mercury manometer and the pressure drop across it equals to 300 mm. Find the ratio of venturi to pipe diameter and determine the pressure drop due to friction across the venturi meter.
A manometer consists of a tube of 0.5 inch in the inner diameter and an amount of mercury (SG Hg =13.55). On one side of the tube, oil (SG=1.4) was trapped, a bubble formed, and the fluid inside was stationary. The volume of the oil was 0.6 in^3 and the volume of the air was 0.2 in^3. Now, the oil and bubble are removed. The pressure change across the air bubble is negligible and any curvature on the bubble surface can be neglected in calculating the volumes. Determine how much the mercury height rises (i.e. h 4 -h 2 ).
3