Question 9- SFD & BMD– Cantilever Beam (UDL) i) Draw the Free-Body Diagram & Find Reaction Force ii) Draw Shear Force Diagram (SFD), clearly show all the shear for experiencing at each point. iii) Draw the Bending Moment Diagram (BMD), clearly show all th beam is experiencing at each point.

a) A beam with a solid homogeneous rectangular section is simply supported at A and B.   A concentrated load F = 150 kilonewtons (kN) acts at point C where distance L1 (A to C) = 2.50 metres (m) and distance L2 (C to B) = 1.65 metres (m). The dimensions of the rectangular section of the beam are breadth, b = 35 mm and depth d = 125 mm. Calculate the maximum bending moment that the beam experiences and give your answer in kilonewton metres (kNm) to two decimal places. *Assume the weight of the beam is negligible and zero.   b) A beam with a solid homogeneous rectangular section is simply supported at A and B.   A concentrated load F = 150 kilonewtons (kN) acts at point C where distance L1 (A to C) = 2.50 metres (m) and distance L2 (C to B)= 1.65 metres (m). The dimensions of the rectangular section of the beam are breadth, b = 35 mm and depth d = 125 mm. Calculate the second moment of area for rectangular section of the beam about its centroidal x-axis (Ixxcentroid). Give your answer in…

Please Show clear work and free body diagram if possible, thank you!

please read the questıon and slove it again properly.

Draw complete shear force and bending moment diagrams for the beam. Label all graphs with the appropriate units. All work must be shown that led to the construction of your diagrams. 4) 6 kN 4 kN/m 20 kN-m 6 m 6 m 6 m

PROBLEM 2: Part a.) Derive the appropriate equations for shear and bending moment throughout the beam. Measure x-distance from the left side of the beam and make sure to tell where each equation is applicable. Part b.) Draw the shear and bending moment diagrams for the beam. 3 kN/m A 6 m B 7 kN/m 3 m C

5) Draw the shear and bendingmoment diagrams for the beam and loading shown in the following figure

Needs Complete solution

(a) Square Beam AB having the circular hollow cross-section as shown in Figure Qla and it is loaded as shown in in Figure Q1b. If the beam material density is 8500kg/m³. i) Draw the freebody diagram for the beam for the beam ii) Obtain the equations for shear force in each segment of the beam iii) Draw the shear force diagram iv) Obtain the equations for bending moment develop for each segment of the beam v) Draw the bending moment diagram for the beam vi) Calculate the maximum bending stress developed. (g=9.81m/s?) ф15сm 20cm 20cm Figure Qla 3kNm A B 3m 2m Figure Q1b | (b) i) Select a beam from standard rolled steel beams to replace above beam (Part1 (a)) and Justify your selection ii) A 5m high both end pin supported beam has the cross-section of Figure Qla. Calculate the maximum axial load that can be applied on the column. Also select a beam cross section from standard rolled steel cross section to replace the above column

Gg