QUESTION SIn a two-peg test of a dumpy level, the following observations are taken. What is the true difference in elevation between A and B?Instrument at A Instrument at BRod Reading on ARod Reading on B1.5082.024Rod Reading on ARod Reading on B0.9381.449QUESTION 61. The following data were taken from PEG method of adjustment. Point 1 is midway between A and B. Point 2 is 20m to the left of A and120m from B. Determine the difference in elevation between A and B. (give your answer in two decimal places)Instrument at 2Instrument at 13.02.752.01.50

As per the company's policy we are supposed to answer only one question in Multiple questions.…

QUESTION 5 In a two-peg test of a dumpy level, the following observations are taken. What is the true difference in elevation between A and B? Instrument at A 1.508 2.024 Rod Reading on A Rod Reading on B Instrument at B 0.938 1.449

QUESTION 5 In a two-peg test of a dumpy level, the following observations are taken. What is the true difference in elevation between A and B? Instrument at A 1.508 2.024 Rod Reading on A Rod Reading on B Instrument at B 0.938 1.449

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: A pre-engineering baseline was run down a very steep hill (see Rather than measure horizontally…

A: Vertical angle = -21o26' Height of range pole from the ground, h = 4.88 ft Slope distance between…

Q: The following observations were taken during testing of a dumpy level: Instrument at P Q Staff…

A: Given that :- Instrument Staff reading on P staff reading on Q P 1.475 m 2.205 m Q 1.440 m…

Q: A stadia rod held at a distant point B is sighted by an instrument set up at A. Determine the length…

A: Solution:-

Q: Levelling Data station 3 Station1 Stationz BS 2.2 IS 2.3 I5 2.3 ES 2-3 Banchmark 100 BS 1.2 BS 2.3…

A: Given:- The leveling data of different stations is given:- Station B.S. I.S. F.S. Benchmark…

Q: Q2/ Readings obtained from a two peg test carried out on an automatic level with a staff placed on…

Q: 1. Compute and adjust the following set of closed-loop level observations: Pt BS HI FS Elev BM A…

A: To compute and adjust the closed loop level.

Q: Determine the weighted mean for the following angles: 222° 12'48", wt 3; 222°12'42", wt 1; 222°…

A: The weight of any measured quantity represents the accuracy of the measurement.The weighted mean (W)…

Q: A catch basin with an area composed of an equilateral triangle XYZ and a square section on the side…

Q: The readings given below were made with a tacheometric theodolite having a multiplying constant of…

A: Given data:- Multiplying constant, K=100 Additive constant, C=0 Reduced level at station A = 100.0 m…

Q: To meet a third leveling accuracy, the maximum misclosure of a level run of 4000 meters should be…

Q: Using the following data, check the catch at gauge X for consistency using the records at gauges A,…

A: Data given: Find: (a) check for consistency (b) Adjust the annual catch of gauge X

Q: A line was measured using a tape that is suspended with a pull of 145 N on both ends. The mean…

Q: In the two peg test of a dumpy level, the following observations are taken Instrument at AInstrument…

A: Given: The observations for two peg tests are, Instrument at A Instrument at B Rod…

Q: Rod PREPARE A SET OF LEVELING NOTES eldort hal FIGURE 2.33 1.27 BM 50 Elevation = 321.07 50:0 auto…

A: HI = Elv. of BM. + BS OR Elv. = HI - BS BM- Benchmark HI- Height of instrumemnt FS-…

Q: The readings given below were made with a tacheometric theodolite having a multiplying constant of…

A: Given data:- The adhesive constant, C=0 The multiplying constant, K=100 HI = 1.1 above the ground…

Q: 4.7.2 (This problem is adapted from the Ground Water Manual.") Drawdown versus time data for an…

A: In this question we use Theis euqation Theis equation depicts radial limited groundwater flow in an…

Q: of the large tank showed a discharge of 590 N of water collected in 81 seconds, when under a…

Q: The atmospheric pressure in kPa if a mercury barometer reads 700 mm. A B C D skippe 98.1 kPa 68.7…

A: Barometer reading h=700 mm It is needed to find the atmospheric pressure in kPa.

Q: Write the expression for correction due to dilatancy submergence?

A: the expression for correction due to dilatancy submergence:

Q: 3. The following observations were made during the testing of a Dumpy level. Instrument at Staff…

Q: 3.758 m 1.424 m 1.511 m 4.753 m 3.943 m 3.941 m 2.163 m1.571 m твм 120.73 m Figure 1 Levelling data…

Q: Observation well C A E D B Pumping outflow Ground surface Pumping well

Q: Example-3: Following readings were taken with level. 1.155, 1.565, 2.695, 3.580, 2.085, 2.895,…

Q: What is required is to find all the missing values in the table below for one of the successive…

A: St. B.S I.S F.S Rise Fall Elevation Remark 1 3.150 219.965 2 1.770 3.85 0.700…

Q: A tacheometer with a stadia constant of 0.30m, and stadia interval factor of 100, was set up on the…

A: middle reading is taken as straight reading is angle is not given.

Q: The cumulative depth diagram of storm obtained from a recording rain gauge is given below. Obtain…

A: Given,

Q: Problem 3. While leveling between two points Pand Qon opposite banks of a river, the level was first…

Q: Q1: Complete the field notes shown in table by computing and recording the elevation for each point.…

A: Field notes is completed Using H.I method.

Q: Q.7 The number of optimum rain-gauges stations will be: Data given: Coefficient of variation (C) =…

A: given Coefficient of variation-Cv=36.5%Admissible % error E=9%

Q: Q/3/..The reading obtained from a two-peg test carried out on an level with a single level staff set…

A: To find collimation error and observed reading at A and. B

Q: length of channel = 1970 ft, difference in elevation = 9 ft. (HINT: use 0.0078 instead of 0.0195.…

Q: The readings given below were made with a tacheometric theodolite having a multiplying constant of…

Q: Table Q1(d) shows a California Bearing Ratio (CBR) test result for Central d) Spine Road project…

A: California bearing Ratio test is used to determine the strength of sub-grade and sub-base material…

Q: 8. Determine the elevation of B.M. 2. Check arithmetic to see if differences are equal. STA. F.S…

Q: A levelling fieldwork was conducted to determine the level of an existing road that runs road under…

A: Elevation:-The vertical difference between the two point is called Elevation. Levelling:- The…

Q: Consider this problem from a homework assignment with f=0.02 and all minor losses neglected. You…

Q: the centrold of the following shaded areas 1. Use R = 60 mm. 60 mm R 1.5R 75 mm 45 mm 54 mm

A: To find centroid

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A sight is taken with an Engineer's Level at rod held 200 meters away and an initial reading of 2.3 meters is observed. The bubble is then level through 7 spaces on the level tube, and the rod reading is 1.8 meters. One division in the level tube is equal to 0.6 mm. What is the sensitivity of the level tube in meters? What is the radius of curvature of the level tube in degrees?
The following staff readings were taken with the help of a Dumpy level and staff. 0.655, 0.865, 0.555, 1.465, 1.430, 0.975, 1.340, 1.665, 1.235, 2.675, 1.565, 1.125 and 2.085. The instrument was shifted after second, fifth and ninth readings. Take R.L of first point as 222.16 m. i) Enter all the readings in tabular form. ii) Calculate the R.L of all points by height of instrument.
i need the answer quickly
QUESTION 7 1. Using the following data, determine the elevation in BM-13? (give your answer in two decimal places) Station BM-12 1 2 3 BM-13 Station BM-12 1 BS 4.64 5.80 2.25 6.02 2 3 BM-13 FS QUESTION 8 1. Using the following data, what is the difference in elevation between BM-12 and BM-13? (give your answer in two decimal places) BS 4.64 5.80 2.25 6.02 5.06 5.02 5.85 4.34 FS ELEV 209.65 5.06 5.02 5.85 4.34 ELEV 209.65
While leveling between two points Pand Qon opposite banks of a river, the level was first set up near point Pand the staff readings observed at point Pand Qwere 1.385 m and 3.005 m respectively. After this level was set up near point Q and the observed readings on point P and Q were 0.750 m and 2.320 m respectively. If the reduced level of point Qwas 120.00 m, determine the reduced level of point P.
topic: Tacheometry Please draw a diagram based on this Problem. (a) diagram of the problem (b) diagram with the computed unknown variables
8. RISB AND FALL camplete the level notes given: below and show the customary arithmetic check. METHOD. Using the rise and fall method, ROD READINGS IFS DIFFERENCE IN ELEV RISE REDUCED LEVEL STA BS FS FALL 1.73 766.45 m BM13 O+00 2.05 +35 1.88 +60 1.75 + B0 I +00 2.39 3.25 +15 2.44 +40 1.86 +90 1.09 2+00 2.15 TP- 1.84 2.63 2+45 О.77 +68 3+00 1.19 1.08 +50 2.52 BM 14 2.J4
Please do it handwritten
Calculate the reduced level (m) of a point A, if the staff readings at the point A and benchmark are 2.8 m and 2.5 m respectively The reduced level of the benchmark is 100 m.
Round off to Four Decima Places on Final answer only.
Please only round off the final answer to 3 decimal places
Problem 1. A news broadcasters reports that the barometric pressure is 772 mm of mercury. Calculate the atmospheric pressure in kPa (abs). a. 82.9 kPab. 92.9 kPac. 102.9 kPad. 112.9 kpae. 122.9 kPaf. 132.9 kPa