QUESTION 3 . y TIAL -y = 0.2e* A 12 kg sack sliding down the smooth ramp. If it has a speed of 3 m/s when y = 1.2 m, a) Draw the free body diagram and kinetic diagram b) Determine the normal reaction the ramp exerts on the sack and the rate of increase in the speed of the sack at this instant.

QUESTION 3 . y TIAL -y = 0.2e* A 12 kg sack sliding down the smooth ramp. If it has a speed of 3 m/s when y = 1.2 m, a) Draw the free body diagram and kinetic diagram b) Determine the normal reaction the ramp exerts on the sack and the rate of increase in the speed of the sack at this instant.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

5. If a ball of weight W is dropped from a height h above the ground (datum), show that the total mechanical energy of the ball in its initial position equals the total mechanical energy of the ball just before it strikes the ground AND also equals the total mechanical energy of the ball when it has fallen h/2. h Datum h 2 Potential Energy (max) Kinetic Energy (zero) Potential Energy and Kinetic Energy Potential Energy (zero) Kinetic Energy (max)
Q3/ A 10 Kg block slides down a hill that is 200 cm tall as shown in the figure with initial speed of 12 m/s: (a) what is the speed of the block when it reaches the bottom of the hill at position B assuming no friction? (b) what is the final speed of the block at position B after traveling a total distance of 500 cm, assuming no friction?
6
Q3. One ball of mass m = 0.7 kg is being swung in the vertical, circular path with radius of r = 2.3 m. At the instant shown, the ball is moving at a speed of v = 5.8 m/s. Determine the tension force in the cable OA. Please pay attention: the numbers may change since they are randomized. Your answer must include 2 places after the decimal point, and proper Sl unit. Take g = 9.81 m/s². Your Answer: Answer A 45° units
help me answer this question please it is too hard for me
graduate who joined the Navy as a pilot is about to take off in an F-15 (WF15 = 81,000 lb) from an aircraft carrier traveling at VA = 40 mph. The jet is launched from the catapult system (a connection just below the deck that assists the aircraft) with the force (Fcp) vs time curve shown that has points of F₁ = 1,000 lb at t₁ = 2 s and F₂ = 3,000 lb at t₂ = 5 s (the plane will reach the edge of the deck at t₂). The F-15 needs to be traveling at 170 mph to take off. Determine how much constant thrust (FTR) the engines must produce during the launch to reach this speed. F2 F₁ FCP t₁ VA t₂ FTR t (s)
Q5: The 10 kN body A shown in Fig. (6) slides on inclined plane. Determine the weight of body B if its velocity changes from 2m/sec upward to 9m/sec upward while it moves 12m. (20 points)
Read the problem carefully and provide complete solutions with derivation of formulas (integrals and derivatives). Complete solution and units please. Use the decimal plaas for final" answers only. 4. a machine is used to cause an object to move along curved path with radius of 1 ft. The object has a mass of 5 1bm and it is subjected to a force of (F= 2 + + 1) lbf, where t is in seconds. Find the change in momentum of the object after 3 seconds if it was initially travelling at 2 ft/s. 2 1bm.ff² Answer: 386.09
Pr4. Two bodies are launched at the same time from two points A and B located at the same height. The distance between points A and B is d. One of the bodies starts from point A upwards with speed v1, while the other starts from point B towards point A with initial speed v2. What will be the minimal distance between the bodies during their motion? (The gravitational acceleration is g, neglect the air drag. The bodies do not reach the ground before the moment of the minimal distance.)
3- A particle of mass m moves along a frictionless, horizontal plane with speed given by v(x)=k/x, where x is its distance from the origin and k is a positive constant. Find the force F(x) to which the particle is subject.
The 150-g hockey puck initially rests on a surface at A with the spring compressed by 0.2 m, as shown. The kinetic friction coefficient between the surface and the puck is ?? = 0.1. The puck is in contact with the spring but is not attached to it. Subsequently, the spring is released. Determine the minimum stiffness of the spring so that the puck just clears the wall at B. Use any method(s) that you like