Question 14 For C=0.012 µF, calculate the frequency (in unit of kHz using 2 decimal points) of the output voltage Vout H₁₁ R₁ www 22 ΚΩ R₂ 56 ΚΩ R₂ www 18 ΚΩ с -OV

Q: Consider the following circuit. Determine the magnitude of current IT in Ampere. Take frequency of…

A:

Q: I need help calculating these frequencies

A:

Q: G₂/ 0011100110 Q2/ (manchester 27 polar NRZ.L 3) unipolar RZ

A: Given,  Binary data = 0011100110; We need to represent the given data in the following line coding…

Q: A+ Β. Μ 409 20Ω Μ 30Ω 30Ω W 109 50Ω

A: The equivalent connection in delta has R1=20ohm, R2=10 ohm and R3=30 ohm First of all the equivalent…

Q: Consider the circuit below. Notice that the outputs of the first two flipflops are connected to the…

A:

Q: 1. Determine the frequency of oscillation. Rf U1 C1 C2 C3 Vout 741 +1 1µF 1µF 1µF R1 10000 R2 10000…

A: Given, C = 1 micro Farad = 1×10-6 F R = 1000ohms

Q: 1. 256 at -40 degrees in rectangular notation is O -196+j165 O -196 - j165 O 196 - j165 196 + j165

A:

Q: The Energy of the signal 10 e-stu(t) in the frequency band [0] Hz is

A: To find the energy of the signal in the frequency band Hz, we can use Parseval's theorem, which…

Q: For the signal shown below: x(t) -2 -6

A:

Q: Apply Input : 10sin(wt) . Plot the output graph and express. Calculate the RMS. R1= 2kΩ

A:

Q: loov C 18.8 PF R 2171-43~ 30.45H Find, IT, Ic, IR, IL

A: Given that: The circuit is shown below. Find: IT, IR, IL, and IC.

Q: 031811550 0 4211550 031811550 031811550 O81 pu 18115 Devredeki tüm elemanların kompleks 031811550…

A:

Q: Given the information provided in the figure below, determine ß, Vcc, RB. 20 μA RB Vcc •2.7 kΩ VCE =…

A: Note   When BE and CB junction of BJT is reverse biased= Cut off Region When BE forward and CB…

Q: 中 向 1Q K

A: The given circuit is asynchronous counter and with each stage frequency is divided by 2.

Q: Consider the following circuit. If the required frequency for oscillation is 10 kHz, then the value…

A: The given circuit is a triangular wave oscillator and the frequency of oscillation is based on the…

Q: In the figure below the input stimulus and its corresponding output response is plotted . It is seen…

A: Sensors are devices that sense the physical quantities and convert it into electrical quantities…

Q: F=50Hz Find Xc へ、3=o.o4 (12-Xc) Fin d Cニ 2 JJ f Xc

A:

Q: Wave energy can be used in furnaces.

A: wave energy provides the energy from the infrared waves which can be used for various purpose.

Q: The output of a transmitter is 1 mV rms and the noise was 0.5 mV rms the SNR is

A: Given :   Signal to noise ratio is the ratio of the output signal voltage to the noise voltage.…

Q: on -10 -15 -20 20 15 10 5 1 2 3 I 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 t (ms)

A: The given waveform is shown below:  The average value of the waveform is determined from the area…

Q: Energy level at negative infinity

A: The Fermi function at negative infinity ....?

Q: For the given circuit and input waveform determine the output waveform. a. b. C. Vi 20 15 d. -10 -5…

A: In this question,  We need to choose the correct options Assume forward bias voltage drop of si type…

Q: The equation for the voltage signal below is e = Em Rotation 90° 180 270° 360° - Em

A: A periodic waveform is a wave that repeats itself after definite intervals of time. Such types of…

Q: Q1 (a) Based on electrical DC circuit as depicted in Figure Q1(a), (i) Determine the mesh currents…

A:

Q: CC (4) (8) 15k RESET Vcc (7) DISCH (6) (3) OUT 12k THRES (2) TRIG (5) CONT GND 50u (1)

A:

Q: e and f is 5

A:

Q: I need help checking if the Vertical Deflection and Horizontal Deflection that I answer is correct.

A: Given wave form:Find the vertical deflection and horizantal deflection.

Q: Calculate 11, 12, and 13. The frequency is fixed at 500 Hz, and its output voltage magnitude to 5 V…

A: The circuit diagram,

Q: The output of a transmitter is 1 mV rms and the noise was 0.5 mV rms the SNR is 2 16 none of the…

A:

Q: Find the equivalent impedance for the circuit below: Given: L1-L2-1H, R₁-20, R₂-40, C-0.01F, RC-50,…

A: Given, The given circuit diagram,

Q: Plot the following points: Transmissibility Frequency (Hz) 0.03 2 0.09 9 0.6 11 1.5 100 20 200 1 700…

A: We have to plot the points in log paper chart . Log chart is a chart in which both the axis are in…

Q: V 0 -V For the following circuit, the vo waveform is C ..... Correct O Wrong O

A:

Q: For a frequency of 200 Hz, the time period will be O a. 0.005 sec O b. 0.5 sec O c. 0.05 sec O d.…

A: Given, Frequency, f = 200 Hz

Q: Determine Rc RE Rb

A: The given circuit is shown below:

Q: Q14 Sound P and Q are two different wave patterns for different sounds SOUND Q SOUND P Time Time…

A: The given sound waves are shown below:  On observing the waveform of the above two sound waves, the…

Q: Vee 27 10 •10.4 V 20A Ve z 100 12 ia

A: To determine various parameters in the given transistor circuit:

Q: 2) Calculate the total current (IT)? î o 14V 15 kHz C1 H 0.1μF C2 0.047μF R1 47052 R2 33052 C3…

A: It is given that:

Q: Determine the impedance of the circuit in Figure 3 at the given frequency. 10 kHz Rw 20 (2 ++ 4.7 ΚΩ…

A: laplace  transfer of capacitor, C→1cs laplace  transfer of  inductor, L→Ls So that Rw and L are in a…

Q: (b) Figure A1 shows a diagram of the measured &" of ice at different frequencies as a function of…

A: To show a diagram and temperature dependence is consistent with τ=τ0expT0TLet The Molecular model of…

Q: v=35 sin(5000t)?

A: Given: An equation of AC Wave is given as Vt=35 sin5000 t.

Q: For a frequency of 200 Hz, the time period will be (a) 0.05 s (b) 0.005 s (c) 0.0005 s (d) 0.5 s

A: Given: Frequency, f = 200 Hz

Q: ta tr napan te 12V 11 p I M

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts…

Q: Determine the value of alpha when ß = 100. O 1.01 O 101 Cannot be solved with the information…

A: We need to find alpha .

Q: MULTIPLY the following sets of complex numbers: 15 – j10  and -25 – j30

A: Given: MULTIPLY the following sets of complex numbers: 15 – j10  and -25 – j30

Q: The simplified equation from the following K-Map is CD 00 01 11 10 AB 00 01 11 10

A: k-map is used to simplify thelogical expression . for n-inputnumber of cells in k-map =2n.for…

Q: 50 A RA RB 31.95 N 3 0.05 N Determine IA and IB

A:

Q: 1. Consider the circuit below. Notice that the outputs of the first two flipflops are connecte to…

A: The initial state is 000. Given diagram:-

Antenna Characteristics

The antenna is an important concept in the domain of electronics and communication engineering. An antenna forms an integral part of many commonly used devices such as wireless modems, routers, game controllers, mobile phones, bluetooth devices, and so on. In simple terms, any wireless communication makes use of antennas to serve the purpose. An antenna, also known by the term 'arial', is an electrical device that converts electrical signals into electromagnetic waves or electromagnetic waves into electrical signals. An antenna contains a transmission line usually made up of co-axial cable, it then receives the signals and converts them into electromagnetic waves, which are then transmitted via space into their required destination. A communication system essentially makes use of two antennas, a transmission antenna, which converts electrical signals into electromagnetic waves, and a receiving antenna, which receives the electromagnetic waves and converts them back into electrical signals.