QUESTION 10 What is the period of the following sinusoidal voltage signal v(t) = 180 cos (146t+40°) V? Write your answer in milli-seconds. QUESTION 11 What is the frequency of the following sinusoidal voltage signal v(t) = 135 cos (261t+39°) V? Write your answer in Hz.

Q: The following graph below shows the response of a forced oscillation, A. versus the ratio of the…

A: Given amplitude A versus ratio of driven frequency and system's natural frequency is shown below.…

Q: The inverse Laplace transform

A:

Q: The incremental cost (in Rupees/MWh) of operating two generating units are functions of their…

A: Given- Incremental costs and their respective powers are given- dC1/dP1=0.2P1+50,dC2/dP2=0.24P2+40,…

Q: 1. Find the transfer function 0000 2 H ΤΩ Vo(s) for each network shown below. V₁(s) (a) + Vo(1) 0000…

A: Given, The circuit diagrams,

Q: With the instruments located in the high-voltage side and the low-voltage side short-circuited, the…

A:

Q: 3. while the relationships for nodes A, B and c in fig 1. A I, 3A 15 I3-IA * figure 2 B 14 76=1A C…

A:

Q: An LTI system is described by the following differential equation: d² y(t) + 3 = y(t) + 2y(t) = =…

A:

Q: 29. A lossless transmission line of characteristic impedance Z, = 50 ohms is terminated in a load…

A:

Q: 8. A point charge of 90 nC is located at the origin, and there are also three uniform sur- face…

A: Given data Charge: Q=90 nC at r=0 Uniform Surface charge distribution: σ1=-8 nC/m2 at r=1 σ2=4.5…

Q: Determine what are the system properties( Time Invariance, memory, Invertibility) for the following…

A: If the system input-output characteristics are not changing with time then it is a time-invariant…

Q: 4. Draw the waveforms for the output and its complement of a negative-edge triggered JK flip- flop.…

A: In this question we need to draw the waveform of the given flip flop.

Q: Find the z-transform of the following function, assuming that T = 0.5 sec Y(s): = 1 (s + 1)²

A: Given, Function is Y(s) = 1/(s+1)2 Sampling period (T) = 0.5 sec We need to determine the…

Q: 1.5 0.5 -0.5 -1.5 Question 2. Consider the cosine Where f 11.18 -3 (a) Draw the time domain signal…

A:

Q: System properties ( Causality, Linearity,  Time Invariance, Stability, memory, Invertibility) for…

A: Given: A system, y(t)=x2(t), To find: Check whether the system follow the properties Causality,…

Q: Question 1: Find the z-transfer function of the system G(s) with ZOH and sampler for a sampling…

A: Laplace to Z-transform transformation:

Q: 1.6 For a potentiometer shown below. If the voltage between 1-3 is 13V, the resistance between 1-2…

A:

Q: Sample Xa(t) with a sampling frequency Fs=800 Hz and find X(n). Find, if possible, the signal Ya(t)…

A: Given frequency(f) = 800 Hz we have to find lowest frequency(x)

Q: If F(s) = 4s2 + 4s + 4 s(2s² + 5s + 10) f(0) equals: lim f(t) equals: t-x f'(0) equals: is the…

A: Given: L(f(t))⇒F(s)=4s2+4s+4s(2s2+5s+10), To find: i) f(0)ii) limt→∞f(t)iii) f'(0)

Q: b) Referring to the circuit below use Kirchhoff's laws to calculate the currents flowing in each…

A: The circuit is shown below:  Applying Kirchoff's current law at node x of the above circuit,…

Q: What is the distance between adjacent voltage minima? a. λ/3 b. λ/5 c. λ/2 d. λ/4

A: The distance between any two adjacent minima and any two adjacent maxima is lambda/2. This is a…

Q: 5. What influence does negative feedback have on the input resistance? 6. What influence does…

A: We have authorized to answer only 3 subparts at a time since you have not mentioned which question…

Q: Question A 6-bit PCM system is uniformly quantized with a bit rate of 4.8 kbps. The signal-to-…

A: Given, Number of bits in PCM, n=6 The peak amplitude, Am=10 V

Q: Determine the Thévenin and Norton equivalents of the circuit.

A: It is given that:

Q: What are the types of pulse modulation systems and define them?

A: To state and define: Types of Pulse modulation systems.

Q: Determine the state-space model

A:

Q: H(jw)= Sketch the magnitude characteristic of the Bode plot for the transfer function above.…

A:

Q: 10 V 22 Ω Fig.(2) R

A: 2. Difference between ammeter and voltmeter : Both ammeter and voltmeter are electric device but the…

Q: If D=12x²,-32³a, -9yza, C/m² in free space, specify the point within the cube, 1sxy s2 at which the…

A:

Q: Find the auto correlation function of the signal shown below V X(t) 0 T

A:

Q: (20/1) IREF = 1mA M₁ GND=0V D S VDD Đ G G GND=0V S D VDD M₂ (5/1) I out

A:

Q: 2) Consider the following circuit: V, 0- R₁ wwww i) ii) Identify the function of the circuit. Derive…

A: Given: Op-amp circuit,

Q: -1080 The inverse Laplace transform of (s+2)5 is btet, where b, c and w are constants and t…

A: We need to find out the inverse Laplace transform of given signal .

Q: the line has an SWR = 3 and Zo = 300 ohm, what is the input impedance at the location of the minimum…

A: Given:  SWR=3 Zo= 300

Q: Digital transducers

A: Given :- A transducer To find :- Digital transducer produce analog output. Device which changes the…

Q: An example power system has two distinct manufacturing areas, one with harmonic loads, and another…

A: Note When Nonlinear loads are connected to the unit so Total load current calculated as…

Q: Related Problem Find the minimum and maximum load currents for which the circuit in Figure 3-14 will…

A: The circuit is shown below:  Using Kirchoff's current law,  IT=IZ+ILif IL=0IZ=IZ(max)IZ(max)=IT The…

Q: (1). Find the z-transform for the following discrete-time signal. x[n] 2 1 -2 -1 0 1 2 3 4 5 -1 n

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: A magnetic core with an air gap is shown below. For a relative permeability is 3500, and the space…

A:

Q: a coil of unknown resistance and a reactance of j8 Ohms is in parallel with a pure capacitor of -j16…

A: Note Current will be in phase with voltage in R Load Current lag voltage in inductive Load Current…

Q: A squirrel cage rotor induction motor as a synchronous speed of 3600 rpm and an actual rotor speed…

A:

Q: An inductor can store an energy 0.4 J. The current carried by the wire is 10A. What is its…

A: Given data, Energy stored in inductor E = 0.4 J. Current carried by inductor i = 10 A.

Q: Find the charge q(t) on the capacitor of the LRC circuit in series, when: L = 0.25, R = 10,000. C =…

A: First, we use KVL in terms of current i and then i = dq/dt to frame the ODE. Then they are solved.

Q: Determine the voltage drop per brush on a dc machine if the armature current is 150A and its…

A:

Q: A bar magnet is dropped through a long vertical copper tube. (Assume that the magnet is smaller than…

A: Given that a bar magnet is dropped through a long vertical coppper tube. Consider that the magnet is…

Q: 6) Light of wavelength 400 nm falls on a metal surface having a work function 1.70 eV. What is the…

A: Given data, Wavelength of λ=400 nm. Work function is given as, W0=1.70 eV.

Q: An RLC circuit has R = 6 0, L = 1 H, C = F, and E = 50 sin 2 t Vwith initial conditions I (0) = 0 A…

A:

Q: The rating of a 3 phase synchronous generator is given as 2 MVA, 4400 V, 60 Hz. If the synchronous…

A: Given: 3 phase synchronous generator Power, P=2 MVA, Voltage, V=4400 V, Synchronous reactance,…

Q: QUESTION 6 P 0.8 pf lagging V₂ For the circuit shown above, what is the input power factor angle?…

A: As per bartleby guideline for more than one question asked only first is to be answered please…

Q: Consider the following transfer function G(s) Y(s) U (s) 5 10s +1 a) What is the steady state gain?…

A: Given Data:- G(s)=Y(s)U(s)=510s+1

Q: Vcc=15√ 3300, RRE2 = 8200 and B 1) Determine DC quantities: = 80. Icq.VCEQ; 2) Determine AC…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Digital Integrated Circuit Design

Digital IC design is a procedural interaction that involves converting determinations and highlights into computerized blocks, which are then further transformed into basic circuits. A significant number of the imperatives related with advanced IC plan come from the foundry cycle and innovative restrictions.