**Question 1**You have a supply of 8K x 4 memory chips. The address bus on each chip will be _______ bits wide. (Type out the number e.g., six) Selected Answer: 13 **Question 2**The address 56H is located in _______. **Diagram Explanation:** The diagram illustrates two integrated circuits (IC1 and IC2) with a shared address bus consisting of lines A₁, A₂, and A₉. The chip select (CS) lines are also shown. The connections imply that the address 56H is mapped to both IC1 and IC2.Selected Answer: Both IC1 and IC2 **Question 3**A 1M x 16 memory chip has a capacity of ______. Selected Answer: 1048576 **Question 4**You are building a system with a 64K x 8 memory made up of 8K x 4 memory chips. The address bus on the system (not the chip) will be _______ bits wide. (Type out the number e.g., six) Selected Answer: 13 **Question 5**You are building a computer system and have a memory requirement of 64K x 8, but you only have 8K x 4 memory chips. You can build the system from these smaller chips, but you will need a total of _____ chips to implement the system memory.(Type out the number e.g., six)Selected Answer: 8**Question 6**What value will select IC2?The diagram shows two integrated circuits, IC1 and IC2. Each has a chip select (CS) line. The lines A13 and A12 are shown connected to both IC1 and IC2. There's a NOT gate pointing towards IC2's CS line, which implies that IC2 is selected when the signal from the associated line is low.Selected Answer: 0

“Since you have asked multiple question, we will solve the first question for you. If youwant any…

Answered: Question 1 You have a supply of 8K x 4…

Question 1 You have a supply of 8K x 4 memory chips. The address bus on each chip will be. (Type out the number eg. six) Selected Answer: 13 bits wide.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

For the ROM memory chip shown, find the capacity (including units) . organization: is this memory volatile or non-volatile? (circle one) D7 DO A B IC GZA G28 G1 A16 A17 A18 YO Y1 Y2 0 Y30 Y4 AD ROM A15 VocVpp MEMR OE CE Each Y controls A19- Y50 Y7 Given the ROM memory chip and decoder circuit below (the decoder used is the 74LS138) is used in a system with a 20-bit address bus, find the address range (in hex) the chip will respond to: upper one block lower
6. Given the number 0XA0BOCODOE0F0, a. How many bytes for this number b. How many bits for this number c. Store in 8-bit computer with little endian system, and the starting address is 0x123, please show thedata memory map d. Store in 8-bit computer with big endian system, and the starting address is 0x123, please show the data memory map
microprocessors course department electrical and electronics engineering emergency solution.
i need the answer quickly
Note: Please do not handwritten.
How many address lines are required for accessing the data in the 8K bytes RAM memory chips. While the data is organized as bytes in the first two cases and as nibbles in the last cases?
Question 2: The HCS12 registers have the values shown in the attached table.Where X, means the values is undefined. Answer the following:A. What is the HCS12 operational mode?B. What is the value on port B pins?C. What is the value on pins PT4-PT7?D. What is the value of X in PTT register?E. Is port B working in full or reduced power?F. What is the pins configuration of CAN2 and CAN4?
4 -This digital circuit (image attached) is a: Choose an option:A. asynchronous counter from 0 to 5.B. synchronous counter from 0 to 6.C. 4-bit serial input shift register.D. asynchronous decade counter.E. modulo counter 8.
Q1) Write an assembly program to duplicate each memory location block (size N) starting at address 200h.
Answer the below questions. a. What is the counting range in binary and decimal for an up-counter with 3 bits? b. What is the counting range in binary and decimal for a down-counter with 4 bits?
A ROM chip with a 8Kx8 organization has _______ address lines. A. 3 B. 8 C. 13 D. 8K
In a multibyte addition program, when must you use the ADD instruction? When must you use the ADC instruction?