Answered: Q5) Determine the critical depth if the…

Engineering

Civil Engineering

Q5) Determine the critical depth if the flow is 1.5 m³/s. The channel width is 2.5m 45: 2.0 m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Velocity Area Method. At certain section of a river, the left and right water edges are 3.0m and…

Q: Most economical circular channel : Depth =0.938D 20=302°22'

A: let d=depth and 2θ = angle subtend with the free surface to the centyer as shownso,Area=2θ2ππR2-1…

Q: Discuss with relevant examples any three applications of leveling

A: For determining relative altitudes of points on the surface of the earth of beneath the surface of…

Q: Explain differential leveling.

A: Leveling: Leveling is a method or process of surveying in civil engineering to determine the…

Q: Convert from DMS to decimal degrees: 224°16’34’’ 20°54’57’’

A: 1 Degree = 60 minutes 1 minute = 60 secondshence, 1 degree = 60×60 = 3600 sec

Q: Keeping the instrument height as 1.5 m, length of staff 4 m, the slope of the ground as 1 in 10, the…

A: Given data: Instrument height, h = 1.5 m Length, l = 4 m slope of ground (down slope), tanθ=110

Q: From the given Leveling Notes below, answer the following questions: a. b. C. d. e. What type of…

A: Given, A profile levelling is presented by height of instrument, method. ELVATION of benchmark =…

Q: Foom 33* x ( cox?o + kim°8) = (-36.48-Lcosi46'51')- + (-14.52 - 2 kimlu6 si')- %3D う = 14.97 m 三

Q: Discuss Corrected CPT Parameters

A: The cone penetration or cone penetrometer take a look at (CPT) may be a methodology wont to verify…

Q: COURSE LENGTH (m) BEARING / AZIMUTH АВ 110.80 32°27' BC 83.60 unknown CD 126.90 188°51' DE unknown…

Q: From the given profile leveling notes: What is the difference in elevation between station 5 and 2?

Q: 12. TRIGONOMETRIC LEVELING. Two points, A& B, are 3,134.50 meters apart. and B, ahd 1,992.25 meters…

A: Determin the difference in elevation between A and B

Q: Prepare a set of level notes for the data listed. Perform a Elevation of BM 7 is 852.045m. If the…

A: Given :

Q: Question- A line of levels has been run from a bench mark of elevation +125.42 m and ends at another…

A: Given- Elevation of bench mark =+125.42 m & 125.45 msum of BS=17.58 msum of FS=17.61 m

Q: Define the following leveling terms: (a) vertical control (b) elevation, and (c) vertical datum

A: Levelling is a branch of surveying that is used to determine the elevations of given points in…

Q: Define Differential leveling

A: Differential levelling also known as compound levelling.

Q: Prepare a set of level notes for the data listed. Perform a check and Elevation of BM 7 is 852.045m.…

A: The given data is: Length of loop=1500 m Elevation at BM 7=852.045 m Using the formula below,…

Q: What is Dewatering Intermediate Depths?

A: Dewatering provides dry and stable conditions for excavations, allows to increase the stability of…

Q: 86 \div 2

A: The numerator or dividend is the number 86.

Q: Describe the process of differential leveling?

A: Differential leveling is a technique used in surveying to determine the difference in elevation…

Q: 6.29. The flowrate passing over this sharp-crested weir in a channel of 1 ft width is 3.5 cfs.…

A: Given figure are:- As, we know that force exercted by the water on weir plate F =ρw·g·A·h' here ,…

Q: Find wetted area and wetted perimeter

A: Introduction : The given question is related with fluid mechanics . In this question we are provided…

Q: azimuth to bearing: 74.062 degree 56.50 degree

A: to convert following angles from azimuth to bearing.

Q: Discuss with relevant examples any 3 applications of levelling

A: Finding out application of levelling.

Q: An engineer proceeded to do the stadia survey work to determine the topography of a certain area.…

A: Distances are read by recording the interval on a graded rod intercepted by two parallel cross hairs…

Q: The following data were obtained by a stadia measurement; vertical angle is 30°23', and observed…

Q: 3. Two 10"-15.3 lb channels are welded together as shown in the figure. Find the moment of area of…

A: Consider the following figure. For 10''-15.3 lb channels, A=4.47 in2x=0.64 intw=0.24 in Both…

Q: What is the Procedure for locating the upper seepage line for flow through an earth dam.\?

A: The top flow line or upper seepage line for flow is called phreatic line.

Q: Discuss any 3 errors in leveling

A: There are mainly 5 sources of errors in leveling Instrumental errors. Manipulation errors. Errors…

Q: Rod Reading 1.23 Rod Reading B.46 Horizontal Line of Skght 1.23 B 8.46 Turning Point 755.11 Mean Sea…

Q: From the given Leveling Notes below, answer the following questions: a. b. C. d. STA BM1 1+100 1+120…

Q: why is it important to conduct cross section level for a irrigation canal ?

A: Cross section of an irrigation canal: Components of cross-section: Side slopes Berms Free board…

Q: Determine the correct horizontal distance of AEwhen it was measured AB = 45m, BC= 38m, CD= 55m, DE…

Q: Fom the following traverse notes, determine the linear error of closun NE BEARING LENGTH -2 N 73°…

Q: Given stadia interval (I) = 5.42 Zenith angle = 83°-15'-30" What is the Difference in Elevation (V)?…

A: Given data:- The given zenith angle, =83°15'30'' The given stadia interval is, I=5.42

Q: 80 kN 25 kN/m 150 kNm A 2.0m 1.5m 1.1m -1.4m

Q: The RL of a point is 120 m and elevation of the instrument is 1 m. If a contour line of 119 m is to…

A: Given - RL of point = 120 m Elevation of the instrument (h) = 1 m Elevation of contour line from…

Q: Diferental leveing betwoen BMs A BCD and A oves olevaton dierences (in melers) of 1551, 32336, +38…

A: c = Misclosure = -15.51 + 32.335 + 38.092 - 54.903 c = 0.014 m = 14 mmK = Total distance = 2 + 3 +…

Q: Given the close traverse survey below, compute for all the adjusted Lengths and Bearings. Show…

A: Solution: The table is below:

Q: Table 2.1 NATIONAL OCEAN SURVEY, U.S. COAST, AND GE STANDARDS OF ACCURACY, AND GENERAL SPECIFICATION

A: To find- error- 5mm loop distance- 700 m order of survey=?

Q: What is reciprocal leveling?

A: Leveling:- Levelling is a technique for determining the relative altitude of a point on the earth's…

Concept explainers

Sediment transport

Sediment transport or Soil transport is the movement of solid particles, usually due to the combination of gravitational forces acting on the sediment, and the movement of the liquid at which the sediment enters. Soil erosion occurs in natural systems where the particles are sandstones (sand, rocks), mud, or clay; the liquid is air, water, or ice; and the gravitational force that works to move particles to the landing surface. Sediment transportation or soil migration due to the movement of liquids occurs in rivers, lakes, lakes, oceans, and other bodies of water as a result of currents and waves. Transportation is also caused by glaciers as they flow, and to places on earth under the influence of wind. Soil erosion due to gravity alone is possible in most sloping areas, including hills, scarves, cliffs, and the continental shelf — the continental boundary of the slope.

Question

Determine critical depth

Q5) Determine the critical depth if the flow is 1.5 m³/s. The channel width is 2.5m
45
2.0 m

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given that

VIEW

Step 2: Calculation

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

From the given Leveling Notes below, answer the following questions: .. b. C. d. e What type of leveling is presented? What station has the highest elevation? (Indicate the letter only corresponding to the station - use capital letter) What station has the lowest elevation? (Indicate the letter only corresponding to the station - use capital letter) What is the elevation (in meters - 3 decimal places) of the line of site when the FS was taken at TP1? (Do not include the unit) What is the elevation of BM2 (in meters - 3 decimal places)? (Do not include the unit) STA BM1 1+100 1+120 1+140 TP1 1+160 1+180 BM2 BS (m) 1.256 1.875 HI (m) FS (m) 2.017 1.576 IFS (m) 1.234 1.527 2.246 2.035 1.975 ELEV (m) 89.556 Remarks A B C D E FOI G H
COMPLETE THE CHART: BEARING N. 10° 20' 30" E. S. 73° 45' 13" E. AZIMUTH 276° 12' 07" 196° 15' 12" 202° 17' 45"
Prepare a set of level notes for the data listed. Perform a check and adjust the mis- closure. Elevation of BM 7 is 852.045 m. If the total loop length is 1500 m, what order of leveling is represented? (Assume all readings are in meters.) +S (BS) -S (FS) Point 4.388 6.907 ВМ 7 TP1 4.538 as BM 8 4.680 8.800 TP2 3.730 5.978 5.245 3.598 ТРЗ 8.464 ВМ 7
8. A civil Engineer proceeded to do the stadia survey work to determine the topography of a certain area. The transit was setup at a point A, with the line of sight horizontal, took rod readings from the rids placed at B and C which is 200 m and 60 m from A respectively. Compute the stadia interval factor. Stadia intercept at 8 = 2.001 m and the stadia intercept at C is 0.600 m. a. 100.00 -b. 101.28 C. 99.93 d. 110.17
Determine the elevation of BM2 using Three Wire leveling. Tabulate data from the sketch and make the final table.
Following are the notes for a line of stadia levels. The elevation of BM-A is 184.29m. The stadia interval factor is 100.00 and C = 0.381m. Rod readings are taken at height of instrument. Determine the elevations of remaining points and tabulate values accordingly. STA BACKSIGHT a S (m) BM-A 1.40+y -3°30' TP-1 0.97+y -2°33' TP-2 1.11+y 0°45' TP-3 0.79+y 2⁰00' B-M₁-B VD S (m) (m) FORESIGHT a 1.07 0.93 1.46 1.04 2⁰18' -3°56' -0°26' 8015' VD (m) DE (m) ELEV (m)
Difference between Leveling and sounding
what is differential leveling
Calculate the interior angles from the following observations: Line PQ QR RS ST TP Bearing S 37° 30′ E S 43° 15' W N 73° 00′ W N 12° 45' E N 60° 00' E
need fast
Discuss critical depth determination.
Differential leveling was performed to run the elevation of BM 3-1 located 30.00 meters to the right of station 3 + 480, to BM 3-2 located 27.50 m to the left of station 3 + 920.00. Calculate the elevations of the points and verify the quality of the annotations in the level book. STATION BS HI FS ELEVATION (m) BM 3-1 1.458 328.954 TP - 1 2.256 2.314 TP - 2 1.382 3.127 TP - 3 3.456 2.171 TP - 4 0.759 1.282 BM 3-2 2.000