Q5: Consider a unity f.b. system with the following O.L.T.F.: k(s + 3) GH = s(s + 1)(s + 2)(s + 4) Sketch the root locus for this system and find the range of k such that the closed loop system is stable.

Q5: Consider a unity f.b. system with the following O.L.T.F.: k(s + 3) GH = s(s + 1)(s + 2)(s + 4) Sketch the root locus for this system and find the range of k such that the closed loop system is stable.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: i, 12 1Ω 1F V 1H

Q: 8. Design a lag compensator to modify the behavior of the plant 1 G,(s) - (s+1)(s +25 +2) Such that…

A: Steps- Find old Steady-state error Write Lag compensator general expression Locate pole and zero on…

Q: QUESTION 5 Consider the closed-loop system in the figure below R.(s) K Give your answer correct to…

A: input R(s) = a/s a = 26 K = 14 output Y(s)

Q: A circuit consists of five resistors in parallel with values of 10, 20, 30, 40, and 50 ohms. What is…

A: Introduction: Resistor: An electrical…

Q: 3-What is the value of rising time tr 8:52 4_What is the value of error of steady state (es.s) 9…

Q: Choose loops for the circuit below so that there is one unknown current. Write a KVL loop equation…

A: A circuit diagram is given in the question. The initial voltage of the capacitor vC0-=0 Volts. We…

Q: 2. Show that a ohm · farad is the same as a second. Show steps. 3. A 3 µF capacitor initially has a…

Q: Problem (1) (1) Find the transfer function and the capacitor voltage in the network shown in Figure…

Q: 1) Plot the root locus of the below system. 2) Give the value of the gain K where the response of…

Q: A 30 Q resistor and a 20 mH inductor are connected in parallel. This parallel combination is also in…

A: The circuit can be made as: The frequency of the circuit is:

Q: 3.. Assume the system in Figure 3 is underdamped and has a specification that by 2 seconds, the…

Q: A four-wheel drive vehicle with antilock brakes uses a sensor to keep each wheel rotating to…

Q: 5) With derivative controller, the value of maximum overshoot M, is

A: Control systems are represented by transfer function. This can be written in both time domain and…

Q: : For the closed loop system shown in figure below, where R(s) is unit step function. (1) Determine…

A: detail solution is in the image

Q: The diagram below depicts an RC circuit where C= 1.55μ F, R₁ = 200, R₁ = 14, R₂ = 14.50, and V = 3.5…

Q: b) Figure Q3(a) shows a simplified waveform generator. i) Name the op-amp configuration. ii) If the…

A: Since you have posted multiple questions, we will provide the solution only to the first question as…

Q: (a.3) When using a battery of emf ɛ to build up current I in an inductor in series with a resistor…

A: RL circuit : The RL circuit consists of resistance and inductance connected in series with a battery…

Q: As sKeth the Root Locus kcs+5) Ges) = (S+1) (s +2) in oPen loop System.

Q: 1 The transfer function of a second order system is G(s) = - Calculate rise time (1,), peak s2 +0.8s…

A: In this question we will find peak time , rise time , settling time and peak overshoot for second…

Q: Q5... The loop gain of a feedback control system is given by: 150 G(s)H(s) =- s(s+3)(s+12) Determine…

Q: 1) Superposition V1 R1 www 1k C1 1E-6 In the above circuit, V1 is a DC source and V2 is a sinusoidal…

A: Given Data:An RC series circuit with,DC voltage AC voltage The passive components To Find:a. The…

Q: 4. Consider a series LRC circuit, with an inductor L with no current initially flowing through it, a…

A: Circuit is underdamped. i.e., α<ωoR2L<1LC

Q: 5- The error response of a control system is given as e(t) = 2e¬"sin (6t + 50°). Find the damping…

Q: Problem 1. Consider the plant in the folowing control system. 10 G(s) =+s+ 10 First, determine thc…

A: Consider the given expression for the plant, Gs=10s2+s+10 The natural frequency is given by:…

Q: QI. For the system shown below R(s) E(s) 5000 c(s) s(s +75) Find Maximum overshoot due to step input…

A: In this question , system is given..We have to find out maximum overshoot, settling time , steady…

Q: Q3: A control system has a closed loop T.F. with unity feedback as Y(s) K(s + 3) U(s) s(s + 2) + K(s…

Q: 5.) Sketch the positive root locus for the system shown below. Determine the required value of K so…

A: Given the block diagram: We need to sketch the root locus for the system. We need to determine the…

Q: 5. You know that for SRP the efficiency is 2+q(W-1) 2+ q(3W – 1) and that for GBN we have (1) w 1+…

Q: For the system shown in figure (4) with derivative feedback. Determine the value of (A and K) when…

Q: R(s) 1 Y[s) K g? + 3s +2 Figure A2 -1

A: In this question we will find gain k value for given steady state error and will find damping ratio,…

Q: 2. It is very convenient when analyzing circuits with non-ideal components to transform between a…

A: Quality factor of a parallel resonant circuit is =Q=wCR (R and C are component of parallel circuit…

Q: 1) A second order control system with derivative control as shown in Figure 1, the effect of…

Q: Q5: For the closed loop system shown in figure below, where R(s) is unit step function. (1)…

Q: a)Calculate K for dominant closed loop poles -0.694+j3.926 b)Calculate steady state error with…

A: GS=1S+1S+2S+10

Q: Q.15: The switch has been in position "a" for a long time. At t=0 the switch is moved to position…

A: In an electric circuit the transients are due to energy storing elements. Since the energy store in…

Q: Fad Design K that stabilize the closes loup System for K is RC) Constant (pregain) K T 2 S+45 +25+…

A: Refer to the given block diagram, it has unity feed back.Form the characteristic equation as,

Q: Using the Nyquist criterion, find the range of K for stability of the system in Figure (a) below.…

A: The given control system isThe Nyquist plot for K=1 isWe need to find the range of 'K' for system…

Q: R(s) C(s) S(s+ 1 (1+k,s)

Q: Q6. For the system shown in Figure(5) R(s) K s(s+ 1) (s + 6) (s+4) K C(s) Figure (5) a) The value of…

Q: (b) Construct the root locus for the system shown in Figure Q4 (b) and determine the location of…

Question

100%

Q5: Consider a unity f.b. system with the following O.L.T.F.:
k(s + 3)
GH =
s(s + 1)(s + 2)(s + 4)
Sketch the root locus for this system and find the range of k such that the closed
loop system is stable.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

SOLVE CAREFULLY!! Please Write Clearly and Box the final Answer(s)
6) In the circuit below, the constant-amplitude voltage generator delivers four times more current at very low frequencies than it does at very high frequencies. If R1=100 N, find the resistance R2. (HINT: Consider how an inductor and a capacitor behave at high and low frequencies.) R1 V C R2
2. Consider the circuit is shown in the figure below. The circuit comprises a voltage supply, v(t), resistor (R), inductor (L) and capacitor (C). Let x1=i and x2= v. be the state variables for this system, where i and v.are the circuit current and capacitor voltage, respectively. For this system, a) Derive the loop equation, involving integro-differential equations, from first principles Write the state differential equations b) c) Write the state-space equation in matrix-vector form d) Sketch the signal-flow graph. Show all your work. R
see the question in the image.
Can you help me with this question? Thank you!
Now, please construct the frequency-domain equivalent circuit of the above circuit (with all the equivalent values calculated in the above steps).
t=0 Q.22: For the circuit shown beside, find v, and V2 for t > 0 if the circuit is in steady-state at t <0. (Ans.: v (t)-8-2e v & v2(t)=10-4e V) 6V 22 10V 252 F: V2 0.05F
(a) Second order system is shown below. The peak time of the system = 0.25 second and it takes 1.25 second to settle down to 2% of its final value for a step response. R(s) H1 C(s) s2 + H2s + H1 By the information given, let's determine: C(s) i. H, & H, and the function of R(5) ii. Based on your answer obtained in (i), plot the step function. Label your graph correctly.
Please complete the entire question quickly and I will leave you a like :) THANKS!
DETERMINE ( NEED ONLY HANDWRITTEN SOLUTION PLEASE OTHERWISE DOWNVOTE).
signal and system
Electrical system shown below consists of series RLC components. The input to the system is the supply voltage, ?. By assigning the loop current ?(?) and capacitor voltage Vc(t) as system states ( that is ?= ? and ?2= ?c ), and the output is the voltage drop at resistor, Vr(?), develop the state space model for the system.