Q4) Two observation wells 1700m apart have been constructed in a confined aquifer as shown if fig below. the flow rate is 0.008m'/hr per unit width of the confined aquifer .Well 1 is drilled in soil A with hydraulic conductivity 13m/day, and well2 in soil C with hydraulic conductivity 9m/day. the soil zone B is between the wells, 600 m from well 1 and 300m from well 2. the water level is 6m above upper confining unit in well land 2.5m above upper confining unit in well 2.estamate the hydraulic conductivity of soil B?

Q4) Two observation wells 1700m apart have been constructed in a confined aquifer as shown if fig below. the flow rate is 0.008m'/hr per unit width of the confined aquifer .Well 1 is drilled in soil A with hydraulic conductivity 13m/day, and well2 in soil C with hydraulic conductivity 9m/day. the soil zone B is between the wells, 600 m from well 1 and 300m from well 2. the water level is 6m above upper confining unit in well land 2.5m above upper confining unit in well 2.estamate the hydraulic conductivity of soil B?

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter6: Hydraulic Conductivity

Section: Chapter Questions

Problem 6.15P

See similar textbooks

Similar questions

Q2) A fully penetrating well of diameter 0.3 m is located in an uncontined aquifer of saturated depth 45 m. If the drawdown in the well is 15 m for the discharge of 1200 m³/day and the radius of influence is 300 m, compute hydraulic conductivity?
A 2‐ft diameter well penetrates vertically through a confined aquifer 50 ft thick. When the well is pumped at 500 gpm, the drawdown in a well 50 ft away is 10 ft and in another well 100 ft away is 3 ft.(a) What is the approximate head in the pumped well for steady‐state conditions, and what is the approximate drawdown in the well?(b) Compute the transmissivity. Take the initial piezometric level as 100 ft above the datum.
The wells shown below are in a leaky confined aquifer. The aquifer has a hydraulic conductivity of 30 ft/d, saturated thickness of 45.0 ft, and storage coefficient of 0.00080. The aquitard above has a thickness of 8.0 ft and vertical conductivity of 0.45 ft/d. Well A was turned on at noon Sunday with a flow rate of 150 gpm. Well B was turned on at noon Tuesday with a flow rate of 200 gpm. Find the total drawdown in ft at the observation well C at noon Thursday. 150 ft 350 ft 150 ft
A single ideal pumping well, with radius of 1.0 ft and flow rate of 155 gpm, exists in an ideal confined aquifer. The aquifer has a saturated thickness of 82 ft. The pump continues running until equilibrium conditions are reached. The drawdown at the pumping well is 42 ft, and the drawdown at an observation well 138 ft away is 7.5 ft. Determine: Find the transmissivity in ft^2/day and hydraulic conductivity in ft^2/day Find the radius of influence in feet.
A 1.15 m diameter pumping well penetrates vertically through a confined aquifer which is 42 m thick. While pumping at a rate of 2880 m3/day, the drawdown in an observation well 20 m away is 2.0 m. In another observation well, that is located 60m away, the drawdown is 0.45m. Initial piezometric level is 52m above the datum. Determine: A.The approximate head in the pumping well for steady state condition B.The approximate drawdown in the pumping well C.The transmissivity of the aquifer D.The radius of influence of the pumping well
TELEGRAM Q1: A 30cm diameter well penetrates vertically through an aquifer to an impermeable stratum located 18.0 m below the static water table. After a long period of pumping at a rate of 1.2 m3/min, the drawdown in test holes 11m and 35 m from the pumped well is found to be 3.05 and 1.62m respective. What is the hydraulic conductivity of the aquifer? Express in meters per day. What is its transmissivity? Express in cubic meters per day per meter. What is the drawdown in the pumped well?
A 1.15 m diameter pumping well penetrates vertically through a confined aquifer which is 42 m thick. While pumping at a rate of 2880 m3/day, the drawdown in an observation well 20 m away is 2.0 m. In another observation well, that is located 60m away, the drawdown is 0.45m. Initial piezometric level is 52m above the datum. Determine: The approximate head in the pumping well for steady state condition?The approximate drawdown in the pumping well ? The transmissivity of the aquifer ? The radius of influence of the pumping well?
QUESTION 12 1. A 40 cm well completely penetrates an unconfined aquifer of saturated depth 40 m. After a long period of pumping at a steady rate of 0.025 m³/s, the drawdown in two observation wells 20 m and 80 m from the pumping well were found to be 4.0 m and 2.0 m respectively. Determine the hydraulic conductivity of the aquifer. Round off to two (2) decimal places, Fill in the blank_ x 105 m/s
Q1: A 30cm diameter well penetrates vertically through an aquifer to an impermeable stratum located 18.0 m below the static water table. After a long period of pumping at a rate of 1.2 m3/min, the drawdown in test holes 11m and 35 m from the pumped well is found to be 3.05 and 1.62m respective. What is the hydraulic conductivity of the aquifer? Express in meters per day. What is its transmissivity? Express in cubic meters per day per meter. What is the drawdown in the pumped well?
A confined aquifer has a transmissivity T = 200 ft2/day (18.6 m2/day) and a storativity S = 0.0002. A fully penetrating well begins pumping in this aquifer at a rate of 1500ft3/day (42.5m3/day). Using the Theis solution predict the drawdown h0 h at a radius of r = 100 ft (30.5 m) at the following elapsed times: 10 minutes, 1 hour, 5 hours, and 24 hours. *tip* Spreadsheet software could help you do these repeated calculations.
18. A well that pumps at a constant rate of 0.5m/s fully penetrates a confined aquifer of 34 m thickness. After a long period of pumping, near steady-state conditions, the measured drawdowns at two observations wells 50 and 100 m from the pumping well are 0.9 and 0.4m respectively. a) Calculate the hydraulic conductivity and transmissivity of the aquifer. b) Estimate the radius of influence of the pumping well c) Calculate the expected drawdown in the pumping well if the radius of well is 0.4m
2. (a) A well in an aquifer is pumped over a long period at a rate of 0.05 m3 /s under approximate steady-state conditions. The steady-state drawdowns, from the water table level, at two observation wells at 25 m and 50 m from the abstraction well were observed to be 15.3m and 9.5m, respectively. If the saturated thickness of the aquifer prior to pumping is 80 m, determine the hydraulic conductivity of the aquifer material. (b) Will the actual drawdown in the pumping well be more than the theoretical drawdown? If yes, why and what measures can you recommend for reducing the drawdown in the pumping well?