Q4A 0.7m long soil specimen is subject to a steady-state flow, as shownin Figure Q4. The saturated unit weight of the soil is 20 kN/m³.Determine the following:Water0.3 m0.8 mА0.3 mDatum0.4 mYFigure Q4a) Total head (m) at point A, B and C.b) Elevation head (m) at point A, B and C.c) Porewater pressure head (m) at point A, B and C.

Answered: Image /qna-images/answer/cf332bfc-b645-4f63-a26f-68802010a893.jpg

Q4 A 0.7m long soil specimen is subject to a steady-state flow, as shown in Figure Q4. The saturated unit weight of the soil is 20 kN/m³. Determine the following: Water 0.3 m 0.8 m 0.3 m Datum 0.4 m Y B Figure Q4 a) Total head (m) at point A, B and C. b) Elevation head (m) at point A, B and C. c) Porewater pressure head (m) at point A, B and C.

Q4 A 0.7m long soil specimen is subject to a steady-state flow, as shown in Figure Q4. The saturated unit weight of the soil is 20 kN/m³. Determine the following: Water 0.3 m 0.8 m 0.3 m Datum 0.4 m Y B Figure Q4 a) Total head (m) at point A, B and C. b) Elevation head (m) at point A, B and C. c) Porewater pressure head (m) at point A, B and C.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Exercise 1 A soil profile is shown in Figure Calculate the values of o, u, and o' at points A, B, C, and D. Plot the variation of o, u, and o' with depth. Dry sand roundwater table Thickness (ft) Unit weight (Ib/ft) Layer no. Laver IE H = 5 H2 = 6 H3 = 8 Ya = 112 Ysat = 120 Ysat = 125 Sand I II III TTE Figure 1
Question 33 Dry Sand H, Groundwater Table Clay H, Refer to the soil profile shown. Given H1 = 9.89 m., and H2 = 5.8 m. If the ground water table rises by 3.78 meters, determine the change in effective stress (numerical value only, in kPa) at the bottom of the clay layer. Properties of dry sand: Gs = 2.53, e = 0.63. Properties of clay: Gs = 2.75, e = 0.81. Round off to two decimal places.
The layer of soil shown has the corresponding coef. of permeability. It is required to compute the equivalent coef. of permeability in a vertical direction in cm/sec. Soil layer thickness Coef. of permeability A 3 m 0.010000 cm/s B 4 m 0.032000 cm/s 6 m 0.000041 cm/s O 8.858 7.678 O 9.889 4.556 None of these
Please answer with a good epxlantion and step by step solution
22. A sample of moist soil has a water content of 26%, a void ratio of 1.1, and a Gs of 2.7 a. Draw the phase diagram and fill it in with numerical values b. Determine S, n, yd, Ysat, Ysub
5. A clay layer having a thickness of 10.83 m. has an initial void ratio of 1.14. It is compressed and the void ratio changed to 0.81. Determine the reduction in thickness, in mm., of the clay layer. Round off to three decimal places. Input the numerical value only.
In Situ Stresses of Soil A soil profile consisting of three layers is shown in the figure below. Layer 1 B. Groundwater table H2 Layer 2 Layer 3 O Dry sand O Sand I Clay O Rock Calculate the values of o, u, and o' at points A, B, C, and D for the following cases. Note that y, = 9.81 kN/m³. Layer no. Thickness Soil parameters H1 = 2 m На %3 3.59 m H3 = 1.73 m Ya = 17.25 kN/m³ Ysat = 19.01 kN/m³ Ysat = 18.3 kN/m³ 1 3 1. Point kN/m² u o' A
The cross-sectional area A(x) of a vertical funnel-shape soil specimen of height 2 ft in the 2 constant-head test (see figure below) varies as A(x) = - sq ft where x (in ft) is measured from x+1 the top of the soil region. Knowing the downward flow rate q must be constant at any soil cross- section and the soil's average permeability coefficient k is 0.3ft/sec, obtain (a) the 1-D equation of continuity with Darcy's law in terms of the total head h(x) and the unknown steady flow rate q, (b) the hydraulic boundary conditions on h(x) at the top (x=0) and bottom (x=2') of the soil, (c) the complete solution for h(x) in the soil zone by applying its boundary conditions at .x=0 and 2' in (b), and check that the solution satisfies the conditions of (b). Plot it over the range of 0 ≤ x ≤2' of the soil region. (d) the pressure elevation head he(x) over 0 ≤ x ≤ 2' in the soil and plot it. (e) the pressure head hp(x) in the soil and plot it. ▼ water soil 2.5' 2' ← datum
1 Situation 2 A soil sample in its natural state, when fully saturated, a water content 36.2%. Assume Gs = 2.69. 16. Calculate the void ratio. A. 0.974 C. 0.789 B. 0.563 D. 0.934 17. Calculate the total unit weight of the soil in kN/m³. A. 17.52 C. 20.38 B. 19.32 D. 18.21 18. Calculate the total weight of water required to saturate a soil mass of volume 10m³. A. 48.4 KN C. 45.3 kN D. 56.7 kN B. 50.7 KN
Subject Geotechnical engineering : soil mechanics A layer soil shown has the following data H1= 3m. K1= 2x10^-2 cm/sec H2= 4m K2= 3.2x10^-2 cm/sec H3= 6m K3= 4.1 x 10^ -2 cm/sec Compute the equivalent coefficient of permeability in vertical direction. Compute the velocity if h= 4m
Qsoil basics properties.
The hgure shows a granular soil in a tank having a downward seepage. The water level in the tank is held constant by adjusting the supply from the top and the outflow at the bottom. The void ratio of the soil is 0.50 and the specific gravity is 2.7. H,0 0.8 m 1.1 m A 3.6 m 5.4 m B C If a plczometer is placed at point B, to what height the water will rise above this point?