Q3 / For the circuit shown in figure below, find the current flowsthrough 10 22 and 6 2 resistors, using super position theorem.2 ohm10 ohmIL3 ohmww50 V6 ohm2 Awww5 ohm↑

First, let us find the current flowing through the circuit by considering only 50 V voltage source.…

Answered: Q3 / For the circuit shown in figure…

Q3 / For the circuit shown in figure below, find the current flows through 109 and 6 resistors, using super position theorem. 2 ohm 3 ohm www IL 10 ohm www 50 V 6 ohm 12A ww 5 ohm

Physics for Scientists and Engineers, Technology Update (No access codes included)

9th Edition

ISBN:9781305116399

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter28: Direct-current Circuits

Section: Chapter Questions

Problem 28.24P: For the circuit shown in Figure P28.24, calculate (a) the current in the 2.00-11 resistor and (b)...

See similar textbooks

Related questions

Q: uoyancy po = 3 Object Density (g/cm³) Animation Speed Slower Run Running Pause Reset Low Faster…

Q: Find the pressure Force=0.33 N Area=0.2 mm2

A: Given data :- Force F = 0.33 N Area A = 0.2 mm2 = 0.2 × 10-6 m2

Q: . A ball is thrown vertically upward with an initial speed of 25.5 m/s from the edge of the roof…

Q: upper reserv friction = 0.0

Q: Vector A has a magnitude of 10.84 m and points 16° north of east. Vector B has a magnitude of 6.91 m…

Q: Find the electrical energy consumed in Joules if a toaster of 66 W is used 1500 seconds ?

A: Given data : Time = t Power = P…

Q: On a winter day, your car's refrigerant freezes and expands to 12.75% Calculate the pressure change…

A: Bulk modulus is defined as B= Bulk stress / Bulk strain= ( change in pr. ) / {(change in volume) /…

Q: Given data: Density = 1280 kg/m³ Mass 42 kg Determine the volume

A: Density is defined as the mass per unit volume ρ=mVwhere ρ is the densitym is the massV is the…

Q: Determine Distance covered by train in 1 hr Speed of train=80 km/hr

Q: Decide which physical states are indicated in the following statement. Choose all that apply.…

A: Solid, liquid, and gas are three states of matter. In our daily life w observe and use these states…

Q: A tortoise moves a distance of 102 metres in 0.26 seconds what is the average speed of tortoise in…

A: Given data : Total time taken = t Total distance =…

Q: What is the magnitude force on a proton moving at 2.5 x 105 m/s in a magnetic field 0.5T. If the…

Q: Find the value of distance Speed=21 m/s time=2 s

A: Answer:- Given Speed (V) = 21 m/s Time (t) = 2 s Distance (S) = ? We know that Speed =…

Q: Find the value of distance Speed=21 m/s time=2 s

A: Given data: Speed (v) = 21 m/s Time (t) = 2 s Required: The distance (d)

Q: As it can be seen from the figure below, an 18kg hanging box is connected by a light, inextensible…

Q: the Horizontal thrust 'H' at eac 1-NI

Q: How do moving charges create a magnetic field?

A: When a charged particles moves in a space then it creates a magnetic field. The presence of magnetic…

Q: affec

A: solution of above problem is below:

Q: 6-A Carnot engine operates between reservoirs at 20°C and 200°C, the thermal efficiency of the cycle…

A: Part (6):Given: The temperature of the cold reservoir is 20oC. The temperature of the hot reservoir…

Q: rries the load system a supports.

Q: 1. In a quasi-static isobaric expansion, 550 J of work are done by the gas. If the gas pressure is…

Q: Find the electrical energy consumed in Joules if a toaster of 66 W is used 1500 seconds ?

A: Given data The power of the toaster is given a P = 66 W. The time interval is given as T = 1500 s.…

Q: A tortoise moves a distance of 102 metres in 0.26 seconds what is the average speed of tortoise in…

Q: Will adjusting the distance of the spoon from yourself varies the image formed in the spoon? Why?…

A: Reflection takes place at the surface of spoon .

Q: The slope of the 4.6 kN force F is specified as shown in the figure. Express F as a vector in terms…

Q: 2²=38 N₁ ایا Find E man k dane

A: Given data : Force=F Displacement=d Required : Work done

Q: Find the value of distance Speed=21 m/s time=2 s

Q: 2kN 400 M 600mm

Q: An SUV hauling a trailer is travelling at 25 m/s when the driver hits the brakes. The 1.4 MT trailer…

A: Kinetic energy is the measure of the work an object can do by the virtue of its motion. Kinetic…

Q: A small bar magnet experiences a 1.50×10−2 N⋅mN⋅mtorque when the axis of the magnet is at 45.0∘∘ to…

A: Given Magnetic torque (τ) = 1.50×10−2 Nm Magnetic field (B) = 9.00×10−2 T θ = 45 ° Magnetic…

Q: A long, straight wire lies along the x-axis and carries current I₁ = 1.50 A in the +-direction. A…

Q: For each case below draw a ray diagram. Draw the image as an arrow and give a description of the…

Q: Traffic travels at 65 mi/hr around a banked highway curve with a radius of 3000 ft. What banking…

Q: As it can be seen from the figure below, an 18kg hanging box is connected by a light, inextensible…

A: In the given question, 18kg hanging box is connected by a light string over a light frictionless…

Q: In a vertical dive, a peregrine falcon can accelerate at 0.6 times the free-fall acceleration g…

Q: 2. Charge 1 (with q1 coulombs) generates the electric field shown here. Charge 2 (with q2 coulombs)…

A: The electrostatic potential energy between the two charge particle Q an q , placed at distance d is…

Q: Determine resistance Voltage=14 Volts Current=5 A

A: Given data : Current=i Voltage=V Required : Resistance

Q: In which circuit do the three resistors have equal voltage drops but carry different current?

Q: Find momentum mass=0.33 kg velocity=0.2 m/s

A: Given: The mass of the object is 0.33 kg. The velocity of the object is 0.2 m/s.

Q: The angle of incidence of a wave of a wave with angle of transmission 45 degree and the refractive…

A: Given value--- angle of transmission = 45 degree. n1 = 2 . n2 = 1.3 . We have to find--- angle…

Q: Determine time to cover distance 20 km with car travelling with speed of 15 km/hr

Q: 5. Assume that Circuits A, B, C, and D have identical batteries and convert all of their power to…

A: Heat ∝ Power Lets find the power usage of each circuit:- For circuit A:- All resistance are in…

Q: 3. Does the coefficient of friction depend on the type of surface in contact?

A: Given:- coefficient of friction depends on which factors

Q: can you please type the answer in letter c), especially in the last part. thank you

Q: 2. A 3 kg object moves under the influence of the potential energy x² 5(x) = (x − 4)³ – - +5 Shown…

Q: An aluminum rod 177.4 cm long at 20 °C is heated to 100 °C. What is the new length? Aluminum has a…

A: Given value--- initial length = 177.4 cm. initial temperature = 20 degree C. final temperature =…

Q: What is the SI unit for latent heat of fusion A) Joules B kg-m/s² kg.m²/s² °C D

A: Given Latent heat of fusion is given We have to find the SI unit of it and choose the correct…

Q: 4. If an object is 10 cm from a concave lens with focal length f= -5 cm, what is its position and…

Q: the final equilibrium temperature of the metal bar and the water in K

A: If a element of mass m1 having specific heat c1 at temperature T1 is connected with another element…

Q: C 30 B 400mm

Question

Q3 / For the circuit shown in figure below, find the current flows
through 10 22 and 6 2 resistors, using super position theorem.
2 ohm
10 ohm
IL
3 ohm
ww
50 V
6 ohm
2 A
www
5 ohm
↑

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Finding current flow through the circuit considering only voltage source of 50V

VIEW

Step 2: Finding nodel voltage and current in the circuit

VIEW

Step 3: Current through the circuit only due to current source

VIEW

Step 4: Net Current through 10 ohm resistance and 6 ohm resistance

VIEW

Step 5: Conclusion

VIEW

Step by step

Solved in 5 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Consider the circuits shown below, (a) What is the current through each resistor in part (a)? (b) What is the current through each resistor in part (b)? (c) What is the power dissipated or consumed by each circuit? (d) What is the power supplied to each circuit?
(a) Can the circuit shown in Figure P27.21 be reduced to a single resistor connected to a battery? Explain. Calculate the currents (b) I1, (c) I2, and (d) I3. Figure P27.21
(a) What is the resistance of a 1.00 102-O, a 2.50-k O, and a 4.00-kresistor connected in series? (b) In parallel?
A person with body resistance between his hands of 10.0k accidentally grasps the terminals of a20.0-kV power supply. (Do NOT do this!) (a) Draw a circuit diagram to represent the situation, (b) If the internal resistance of the power supply is 2000 , what is thecurrent through his body? (c) What is the power dissipated in his body? (d) If the power supply is to be made safe by increasing its internal resistance, what should the internal resistance be for the maximum current in this situation to be 1.00 mA or less? (e) Will this modification compromise the effectiveness of the power supply for driving low- resistance devices? Explain your reasoning.
A person with body resistance between his hands of 1.00 k accidentally grasps the terminals of a 20.0-kV power supply. (Do NOT do this!) (a) Draw a circuit diagram to represent the situation. (b) If the internal resistance of the power supply is 2000 , what is the current through his body? (c) What is the power dissipated in his body? (d) If the power supply is to be made safe by increasing its internal resistance, what should the internal resistance be for the maximum current in this situation to be 1.00 mA or less? (e) Will this modification compromise the effectiveness of the power supply for driving low-re si stance devices? Explain your reasoning,
Why is the following situation impossible? A technician is testing a circuit that contains a resistance R. He realizes that a better design for the circuit would include a resistance 73R rather than R. He has three additional resistors, each with resistance R. By combining these additional resistors in a certain combination that is then placed in series with the original resistor, he achieves the desired resistance.
For the circuit shown in Figure P28.24, calculate (a) the current in the 2.00-11 resistor and (b) the potential difference between points a and b.
(a) What is the terminal voltage of a large 1.54-V carbon-zinc dry cell used in a physics lab to supply 2.00 A to a circuit if the cell’s internal resistance is 0.100 ? (b) How much electrical power does the cell produce? (c) What power goes to its load?
B.) For the circuit shown below, determine the current and the voltage drop across R1. R1 = 250 Q, R2 = 500 N, R3 = 100 , & V = 30 V. I = R1 R2 R3 V1 =
In the circuit in the figure, calculate the values of the currents in each arm. ! k=9.109 Nm2/C2 and εo=8,85.10-12 C2/Nm2
Imssb1.mutah.edu.jo/mod/quiz/attempt.phpi For the following circuit in the figure below. Determine V-V, (in units of V) for e= 47 V. a 20 Select one CA 783 OB. 940 Oc39.17 D. -940 E-783 8
on 11 t answered d out of 1.00 g question C,-10μF C2 = 10µF 12V FIGURE 1 Refer to the figure 1. Two electrolytic capacitors are connected in parallel across a 12-volt supply. What is the total charge of the given circuit? A. 240 μC B. 0.6 µC С. 60 иС D. 720 µC