Q3) A leveling staff setup on point R of elevation (-8.79 m), is observed from point A where the three staff reading are (-0.69,- 2.52,-4.35 )m with zenith reading (90° 00'). Then the staff moved to point F where the three staff reading are (-0.53, -2.21, -3.90 )m with zenith reading 299 009.Compute the horizontal distance R F, and reduced level of point F Note: The device used was modern.

Q3) A leveling staff setup on point R of elevation (-8.79 m), is observed from point A where the three staff reading are (-0.69,- 2.52,-4.35 )m with zenith reading (90° 00'). Then the staff moved to point F where the three staff reading are (-0.53, -2.21, -3.90 )m with zenith reading 299 009.Compute the horizontal distance R F, and reduced level of point F Note: The device used was modern.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Q.I A line of level is run from B.M.1 (elevation-106.40m) to B.M. 2(elevation-110.50m). The field observations were recorded as given below: B. S 1.95 Station I.S F.S Remarks В.М. 1 2 0.65 3. 2.60 1.45 4 1.90 -1.60 5 0.55 6. 0.50 В.М. 2 Reduce the level of point 2, 3, 4 and 5, determine the total error of closure, and adjust the values.
Situation II: 6m 45 f 2 kN/m -3 m B
Hi! help me with this please. Thank you! Compute the elevation of BM6 a.270.17 b.207.71c. 217.70
Determine the misclosure and the correction. Express your answers in feet to two decimal places separated by a comma. Misclosure, Correction = [ΫΠ ΑΣΦ ↓↑ vec ? ft
Surveying//Theoritical part.
c. The following consecutive readings were taken with a level and a 4.0 m staff on a continuously sloping ground at a common interval of 30 m: 0.780, 1.535, 1.955, 2.430, 2.985, 3.480, 1.155, 1.960, 2.365, 3.640, 0.935, 1.045, 1.630, and 2.545. The reduced level of the first point A was 180.750 m. Rule out a page of a level field book and enter the above readings. Calculate the reduced levels of the points by the collimation system? Station Distance B Arithmetical checks B.S. Readings I.S. B.S.-F.S. Height of Reduced Remarks F.S instrument level level R. L. of last point - R. L. of first point
B.S Q3). Two points of A and B on opposite bank of a river, the level was setup near A and staff readings at A and B were (3.25 m) and (b1) respectively. The level was changed to near B and respective staff readings on A and B were 2.15m and 1.8m, Bis elevations of A and B are 82.6m and 83m respectively, find value of (bl).
The instrument was set at point A with HI of 12.35 m MSL. The top of the tower was sighted with vertical angle of 30°. The instrument was then transferred to point B (towards the tower) that is 100 m away from point A. The top of the tower was sighted again with vertical angle of 33° when HI is 11.05 m MSL. Determine the elevation of the tower (in m MSL).
SITUATION 4. From the given data of differential leveling as shown in the tabulation: STA. F.S. 1 2 3 4 5 6 7 B.S. 5.87 7.03 3.48 7.25 10.19 9.29 6.29 6.25 7.08 5.57 4.45 4.49 ELEV. 392.25
M 88% 11:19 am KB/s E quiz1.docx Q Locate the centroid 7 of the right-elliptical cone. 10 ft 4 ff -3 ft.
Q.I A line of level is run from B.M.I (elevation=106.40m) to B.M. 2(elevation=110.50m). The field observations were recorded as given helow: Station B. S 1.95 Remarks R.M. 1 IS F.S 2 0.65 3 2.60 1.45 4 -1.90 -1.60 0.55 0.50 B.M. 2 Reduce the level of point 2, 3, 4 and 5, determine the total error of closure, and adjust the values.
In carrying out the permanent adjustments of a level by, the following observations were made: Instrument at peg (C) midway between points A and B, 100m apart. Readings at points A and B are 2.500m and 3.500m, respectively. Instrument at peg (D) in line of AB such that AD-120m and BD-20m, Readings at points A and B are 1.500m and 2.600m, respectively. Check whether the instrument needs permanent adjustment or not and whether the line of sight is inclined upward or downward. What should be the correct reading at (A and B) if the instrument is to be adjusted?