Q2/ P1= 30 bar , T1=400 °C P3= 0.1 bar, P2=5bar The feed water heater is a direct contact type Find efficiency and the steam rate of the cycle 1 kg Power output Turbine 30 bar, 400°C Boiler 2 (1 - m) kg 5 bar m kg 3 0.1 bar Condenser Heater Pump 1 kg Pump (1- m)kg

Q2/ P1= 30 bar , T1=400 °C P3= 0.1 bar, P2=5bar The feed water heater is a direct contact type Find efficiency and the steam rate of the cycle 1 kg Power output Turbine 30 bar, 400°C Boiler 2 (1 - m) kg 5 bar m kg 3 0.1 bar Condenser Heater Pump 1 kg Pump (1- m)kg

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: Steam is supplied to a two-stage turbine at 48 bar and 400 °C. It expands in the first turbine until…

Q: through the components of the system, and the property data at the numbered locations are given on…

Q: a. Total heat added b. Total turbine work C. Heat rejected in the condenser d. Total pump work e.…

A: IN THIS PROBLEM USE STEAM POWER CYCLE WITH THE BOILER PRESSURE OF 10MPA . AND THE TEMPRETURE OF THE…

Q: Question 10: A water heater is supplied with cold water (T-30-F) and delivers hot water at a…

A: Given data: T1 =30 deg.F T2 = 130 deg.F Heat lost to the surrounding (Qloss) = 400 Btu/hr. water…

Q: A schematic of a combined refrigeration cycle and a portion of a steam power cycle is shown in the…

A: It is asked to find the turbine work output

Q: A steam power plant operates in cycle as shown.The rating of the power cycle is 100,000 kW.…

Q: A System under consideration is presented in figure below. Steam boiler generates 100 kg/s of steam…

A: The T-s diagram of the given system is Mass flow rate of the steam, ms = 100 kg/s y is the fraction…

Q: A heat pump uses refrigerant-134a as the working fluid and operates on an ideal vapour compression…

Q: A steam powerplant currently operates between a boiler pressure, 110 bar, and a condenser pressure,…

A: The boiler pressure is The condenser pressure The steam is dry saturated at the entry of turbine

Q: A vapor compression refrigeration cycle operates at steady flow conditions with 0.25 kg/s or R-134a.…

Q: A refrigeration plant working on a simple vapour compression cycle with pressure limits of 2.1 bar…

Q: A refrigeration system uses refrigerant-134a as the working fluid and operates on an idea vapour…

A: Refrigerant=R134aLower pressure in the cycle Evaporating pressure, Pe=0.28 MPaHigher pressure in the…

Q: 1-Find y1, y2, y3,y4 of steam bled for feed water heaters without using any enthalpy for the plant…

A: To find: The value of steam bleed (y1, y2, y3 and y4) for feed water heaters. Steam bleed: Steam…

Q: A refrigeration cycle operating as shown in the figure below has a coefficient of performance ß =…

A: GIVEN DATA FOR REFRIGERATION CYCLE COP=1.8 QOUT=750 KJ WE HAVE TO FIND QIN AND W ?

Q: A two stage refrigeration cycle is shown in fig. B. The working fluid is refrigerant 134a. The…

A: Given: Working fluid-R 134A Evaporator temperature of cycle 1=-40 oF Condenser temperature of…

Q: The Reversed Carnot Cycle is used to run a food production company's refrigeration system. The…

A: Given Data Tc= -14°C TH= 52°C Qc= 24 Ton

Q: ANSWER THE PROBLEM WITH COMPLETE SOLUTIONS. PLEASE WRITE LEGIBLY.

A: At P=8MPa and T=480Ch=3348.4 kJ/kgs=6.6586 kJ/kg-KAt P=2 MPa and s=6.6586 kJ/kg-Kh=2963.5 kJ/kgAt…

Q: For the simplified refrigeration/Heat Pump cycle shown in the Figure, the coefficient of…

A: Given data:- The temperature at warm heated space ( TH ) = 25o C The…

Q: Calculate: Work net (kW), heat addition (kW), and thermal efficiency.

Q: The heat pump produces 24,000 BTUH (where BTUH = BTU/hr) for space heating, Q_sh, plus it is heating…

Q: Refrigerant 22 is the working fluid in a Carnot refrigeration cycle operating at steady state. The…

A: To Find : the coefficient of performance . Given : temp at evaporator Te=-30°C temp at entering at…

Q: below. In the power cycle, steam (water) with a mass flow rate m, enters the turbine at state 1. A…

A: Calculate all the values at different points:State (1):P1=5000 KPa T1=350°Ch1=3069.3 KJ/Kg…

Q: Q3)The following conditions are for simple steam power plant: Equipment Turbine inlet outlet work…

A: Turbine inlet pressure P1=40 bar=4 Mpa Turbine inlet temperature T1=320°C Turbine work WT=1000kJkg…

Q: For the steam power plant operating on reheat Ranking cycle shown in figure; (2 Bahr 100ber, 450°C-…

A: Note: Since you have posted a question with multiple sub-parts, we will solve first three sub- parts…

Q: A Carnot heat engine with working temperature of 250 °C and 25 °C, absorbs heat at 400 kJ/min. The…

Q: Q1: A: A steam generator operates at 15 bar absolute pressure. The economizer receives the water at…

Q: A refrigeration cycle operating as shown in figure below has Qout = 1700 Btu and Wcycle = 1000 Btu.…

Q: Heat exchanger 2. Apart from vapor compression refrigeration cycles, refrigeration can also be…

A: Given data At compressor inlet T2 = 15oC = (15 +273) K = 288 K P2 = 150 kPa compression ratio = 12…

Q: A refrigeration system operates on the reversed Carnot cycle. The minimum and maximum temperature…

A: Given data: Cycle : Reversed Carnot Cycle Minimum Temperature = Tmin = 30°C = 30 + 273 = 303 K…

Q: pressure Q4// An aircraft is flying at a speed of 480 m/s. This aircraft used the simple aircraft…

Q: Calculate the heat supplied to the working fluid in a Rankine cycle with reheat. Assume that the…

Q: AC/ pump analysis System 2 tons operating steadily to maintain 60 F inside. Temperature outside:…

Q: 1- A refrigeration system shown below uses R-134a. The refrigerant comes out evaporators and flash…

Q: Q3/ A steam power plant operates on the cycle shown in the Figure. For the following set of…

A: Given data: P2=P3=10000 KPaT3=600°CP4=P1=10 KPaturbine efficiency=0.80pump efficiency=0.75power…

Q: A heat pump has a coefficient of performance of 3.1 in heating mode. If it requires 130 J of work…

Q: The figure shown represents a refrigeration system works with R-134a as a refrigerant to produce 20…

A: The refrigeration capacity = 20 TRThe evaporator, flash cooler and condenser temperature are -23, 0…

Q: Q2 : A reversed cycle operates as either a refrigerator or a heat pump. In either case the power is…

A: Block diagram of both the heat pump and refrigerator is same but the…

Q: What is the rate of refrigeration in kW of an ideal heat-operated refrigeration cycle that receives…

A: Given:W=1 kWTs=70 KTL=15 KTH=35 K

Q: 320K 1000 K Q42 w (350kJ) 283K 300k

Q: responsible for a thermal machine. The machine operates according to the cycle below, functioning as…

Q: The figure below provides steady-state operating data for an ideal refrigeration the working fluid.…

A: Mass flow rate = 30.59 (lb/min) vapor compression refrigeration system with working fluid R-134a…

Q: Based on the steam engine represented on the following figure, a) Describe the heat engine cycle…

Q: Explain why we use temperatures at high altitudes? | air-conditioning systems f. air planes despite…

A: Given Steam jet water vapor refrigeration Thermoelectric system Vortex tube refrigeration Airplane…

Q: A schematic of a combined refrigeration cycle and a portion of a steam power cycle is shown in the…

A: m_3 = 3[kg/s] P[1] = 5000[kPa]T[1] = 350[C] P[2] = 2000[kPa]T[2] = 250[C] P[3] = 200[kPa]x[3] =…

Question

Q2/ P1= 30 bar , T1=400 °C
P3= 0.1 bar, P2=5bar
The feed water heater is a direct contact type
Find efficiency and the steam rate of the cycle
1 kg
Power output
Turbine
30 bar, 400°C
Boiler
(1- m) kg
5 bar m kg
0.1 bar
Condenser
Heater
Pump
1 kg
(1- m)kg
Pump

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

9.
Solve for me. d.e.f.g.h
A compound compression system below, Sketch (ph) diagram for cycle and calculate : 1. Total compressor work. 2. Q condenser 3. Enthalpy drops of refrigerant after sub-cooler 3 Water inter cooler Refrigerant (working fluid) R717 Low Cycle Pressure 1.8 bar Intermediate Cycle Pressure 4 bar T3= 40 °C Low stage compressor High stage compressor Ts= 50 °C Evaporator Qwraporation=1130 kJ/kg Expansion valve Condenser Sub-cooler
Thermodynamics
4. The values of a vapor compression refrigeration cycle were given below. Calculate the values of refrigerant flow rate, refrigeration capacity, and the COP of the system. T1= Evaporator water outlet = 10 °C T2= Evaporator water inlet = 16 °C T3= Condenser water inlet = 16 °C T4= Condenser water outlet = 22°C Cooling water flow rate = 1.5 L/min Heating water flow rate = 1.5 L/min Enthalpy of R134a in evaporator outlet = 305 kj/kg, Enthalpy of R134a in evaporator inlet =115 kj/kg Enthalpy of R134a in condenser inlet =327 kj/kg
Q2: A closed Gas turbine unit operating within below temperatures and pressures. Determine the heat supplied; the power output; work ratio; and the cycle efficiency. Compressor ti-20 °C Pi 1 bar mar = 5 kg/s P:= 7 bar t-760 °C Combustion chamber Cooler Turbine HOA W₁=?
Please dont late give me Last number
Please solve
Power generation using steam is one of the most common method which can be found around the world. In these type of power plants, steam goes through a basic thermodynamic cycle called Rankine cycle which is shown in the following figure. Steam flow Boiler Qin Pump Wout Win Condenser •Qout For the proper operation of the cycle, water should be pumped to the boiler using pump which required work input (Wm) generate steam and then high pressure steam is fed to the turbine. By extracting the energy from high pressure steam, turbine is producing work output (Wout). Because of this, the steam pressure is reduced and low pressure steam is flowing into the condenser. Condenser removes heat energy from steam further (Qout) and steam is converted into liquid water. The liquid water can be pumped into the boiler again and the cycle continues. Performance of a Ranking cycle can be evaluated by using thermal efficiency (nth)which is determined from; the cycle. Heat energy should be supplied to the…
Below is an ideal cascade refrigeration system with High P = 800 kPa, Intermediate P = 360 kPa, and Low P = 140 kPa.If the lower cycle transfers 69kW of energy to the upper cycle, What is the mass flow rate of R-134A (in kg/s) in the upper cycle? a.0.4014 b.0.3892 c.0.3554 d.0.4357
The following is a thermodynamic cycle: engine emits 22.4 kW; hot body provides 4220 kj/min; tiny pump consumes 2 kW (to disperse functioning substance). Draw the system.Calculate (a) the net work.(b) Calculate the heat rejected. Calculate the thermal efficiency.