Q2/ hydraulic cylinder has a piston cross-sectional area of 15 cm2 and a fluid pressure of 2 MPa. If the piston is moved 0.25 m, how much work is done in kj. Q2/ hydraulic cylinder has apiston cross-sectional area of15 cm2 and a fluid pressure of2 MPa. If the piston is moved0.25 m, how much work isdone in kj. *

Write the formula for the fluid pressure in terms of the force acting due to the pressure and the…

Answered: Q2/ hydraulic cylinder has a piston…

Q2/ hydraulic cylinder has a piston cross-sectional area of 15 cm2 and a fluid pressure of 2 MPa. If the piston is moved 0.25 m, how much work is done in kj. *

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: Find the T.F for the system below ta x (Output) k2 wwww u(t) (Input force) No friction

A: Given:- Two Springs k1 and k2 Cart Mass=m To-Find: Transfer Function

Q: Q2: Suppose there are two bodies with an attractive force between them. The first body has mass (m)…

Q: Q1/ The air circulation in a large room by using fan (10 hp). Assuming a well-insulated, sealed room…

A: Given, Large room is well-insulated. Hence, heat transfer to and from room is zero. Hence, δQ = 0.…

Q: Q1. A hydroelectric station has a cubic tank of height 50m above the earth. This cubic tank has an…

Q: a. Given A Fan A with Power in Kw of 10.25 and Fan B with 12.75 kw. Speed of Fan B is 750 rpm, Find…

Q: 1. A 20lbm box is on an air balloon. The balloon has diameter of 10m with air with density of 0.04…

Q: Half a liter of liquid is being heated in a closed container to prepare food. Initial temp is 25C…

Q: 1. A vacuum chamber is cylindrical with 50 cm in diameter and 50 cm in length. How long would it…

A: Given data: Diameter of cylinder = D = 50 cm = 0.5 m Length of cylinder = L = 50 cm = 0.5 m Initial…

Q: rs filled with oil if density psubscripto anc closed by two pistons. The small chamber on the right…

A: Given

Q: A body (8 N) changes velocity from 5 m/sec to 7 m/sec, find the kinetic energy

A: The mass of the body can be determined as, W=mg (8 N)=m(9.81 m/s2) m=0.8155 kg

Q: A reservoir has a mass of 2000kg and a volume of 1 cubic meter. Find its weight density, mass…

Q: Q2: Find the Pre ssures at A, B, C, and D. Air 4ft Water B Air 2ft 21t 4t A Water

Q: Table Q2 show the working pressure inside an engine which moves the piston at different positions…

Q: Find the potential energy stored in object Mass=8 kg Height to be raised=10 m

A: Given data : Height to be raised h=10 m Mass m=8 kg Acceleration due to gravity g=9.81 m/s2…

Q: A cylindrical tank that is 2ft in dia. and 3ft tall is filled with a fluid with p = 64. find its…

Q: Find the potential energy stored in object Mass=8 kg Height to be raised=10 m

Q: i) the force that must be applied to the small piston. ii) the distance that the small piston has to…

Q: Find the value of specific gravity of liquid whose density is 13200 kg/m3

A: Given data : Density of liquid=ρ Density of water=ρW To find : Specific gravity

Q: Given data : Kinetic energy%3D20 Joule Velocity-3 m/s

A: Given:Kinetic energy, KE=20 Jvelocity, v=3 m/s

Q: Find the potential energy stored in object Mass=8 kg Height to be raised=10 m

A: Given : Mass, m = 8 kg Height to be raised, h = 10 m To find : Potential energy stored in object

Q: A man lifts a car by applying a force of 148 N with a hydraulic piston of area of (A1) m². If the…

A: Force applied by the man, F=148 N Area at hydraulic piston where force is applied = A1 Area at…

Q: Find the value of work done if force 2 N displace crate by 1 m

A: Given data : Force applied is denoted by=F Displacement is denoted by=d To find : Work done

Q: isobaric process A certain gas, with cp = 0.529 Btu/lb -R and R = 96 ft lb/lb -R, expands from 5…

Q: A 15hp motor is used to drive an air compressor. The mechanical and compressor efficiency are 65% &…

A: Power inputShaft power=15 hp=11.2 kW T1=30oC=303 K P2P1=6 ηm=65% ηC=70%

Q: 6. A sample of gas (y= 1:5) is taken through an adiabatic process in which the volume is compressed…

A: Data given- Y = 1.5 V1 = 1600 cm3 V2 = 400 cm3 P1 = 150 kPa

Q: It is said that independent temperatures are held at 273 K in a volume of 11.35 dm3, and its…

A: as per guideline i have to solve only three subpart of your question

Q: It is said that independent temperatures are held at 273 K in a volume of 11.35 dm3, and its…

Q: A cylindrical tank that is 2ft in dia. and 3ft tall is filled with a fluid with p = 64. find its…

A: Given:-Dia,d=2 ftH=3 ftDensity of fluid, ρ=64 lbm/ft3To find:-Total weight in Pdl

Q: A specific oil has a Gs = 0.82. Solve for it’s a) specific weight in lb/ft³ and kN/m³ and its mass…

Q: A hydraulic car list has an actual mechanical advantage of 50. The mechanic using it applies a force…

A: Work: W=force×displacement Given: Displacement = 1.5 m Mechanical advantage = 50 Total force = M.A.…

Q: 3. A container shown is at 90 deg F, The pressure at point A was measured at 41 in of Hg. Find the…

A: Answer: The pressure at all points are listed below: ◆ PA =2899.52 lb/ft2. ◆ PB = 2837.12 lb/ft2. ◆…

Q: A one cubic meter tank of natural gas at 10 degrees Celcius weighs 100 N (ignore the weight of the…

A: The universal gas constant of natural gas i.e., methane is 518.28 J/kg.K. Write the ideal gas…

Q: Skg of Steam at pressure ot 4.9 bar is produ- ced from water at 20% . Determine the amount of heat…

Q: What is the kinetic energy of a 3000 lb. automobile which is moving at 33 fps?

Q: Determine kinetic energy

Q: If the piston mass is 20 kg and the car mass with its base is 400 kg, what will the minimum pressure…

A: we need to calculate minimum pressure required to lift the car

Q: Given data : m-20 kg V-2 m/s Find kinetic energy

A: Given data : Mass of object=m Velocity of object=V To find: Kinetic energy

Question

Q2/ hydraulic cylinder has a piston cross-sectional area of 15 cm2 and a fluid pressure of 2 MPa. If the piston is moved 0.25 m, how much work is done in kj.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The pressure of the high altitude chamber is 40 m^3. It is put into operation by reducing pressure from 1 bar to 0.4 bar and temperature from 25°C to 5°C. a) How many kg. of air must be removed from the chamber during the process? b) Compute the volume at this mass measured at 1 bar and 25°C
3. A container shown is at 90 deg F, The pressure at point A was measured at 41 in of Hg. Find the pressure at point B, C and D in Ib/ft². Air Air 3ft 4ft 7B Air 5ft 6ft Water 2 ft
Find the displacement, velocity, kinetic energy, potential energy and momentum of an objęct, taking www. wwwww wwww www. mon mmwm w into account that F = ma and F = -kx. wwww w
Problem : What is a force of 2 kg m/s equivalent to in newtons? What is a force of 21bm ft/s equivalentto in Ibf?
Q2: The motion speed of the piston in one hydraulic transmission system is depend on the inlet flow rate, if gw=50ml/s, the surface of the cylinder is 5 cm², so what's the speed of the piston?
A pulley 1 m in diameter rotating at 300 r.p.m is brought to rest in 80s. By constant force of friction on its shaft. How many revolutions does it moves?
5. A cylindrical tank that is 2ft in dia. and 3ft tall is filled with a fluid with p = 64m. find its density in slug/ft3, specific volume in in³/slug , specific lbm ft³° weight in Ibf/ft3, total weight in pdl, and find the specific gravity of the substance compared to water.
Patm 1. Initially; the piston sits on the stops and the linear spring exerts no force, the specific volume is 0.05 m /kg and the pressure is 125 kPa. Atmospheric pressure is 100 kPa, mass of the piston is 102 kg, and area of the piston is 200 cm?. The linear spring exerts a force on the piston in such a way that the specific volume becomes 0.08 m'/kg when the pressure reaches 200 kPa. Heat is transferred to the water until its temperature is 115 °C. Calculate work and heat transfer, showing the process on a P-v plot. Hint: In the final stage, the temperature is 115°C, but the pressure is not given. You need to find P and v using the tables and P-v plot.
Q1. A hydroelectric station has a cubic tank of height 50m above the earth. This cubic tank has an equal part of 35m. The maximum height of water in the tank is 25m for one day and the minimum height of water in the tank is 5m for one day also. The efficiency of the station is 0.9, Find 1. The power that developed by the station. 2. The maximum power that developed by the station. 3. The maximum power that could be developed by the : 35m 25m 50m earth >
Given: Mass of toy car=2 kg Velocity=0.9 m/s Find kinetic energy
A piston with area 2cm2 is moved at a speed of 1.5cm/s. What is the velocity in m/s if the outlet is 15mm2?
A hydraulic car list has an actual mechanical advantage of 50. The mechanic using it applies a force of 48N to on the handle and lifts a car 1.5m off the shop floor. How much does the car weigh?