Q2:- For static system as shown in figure, if T2 k = 50 N/mm, m, =m2, u = 0.25 for the T1 blocks m, and m2, tensions T1 = 28.35N, spring elongation = 5 mm and the force F1 = m, cos 0 + m, sin 0. Find the inclination angle, Tension in other wire and the mass of blocks. By used Grammar method. F1

Q2:- For static system as shown in figure, if T2 k = 50 N/mm, m, =m2, u = 0.25 for the T1 blocks m, and m2, tensions T1 = 28.35N, spring elongation = 5 mm and the force F1 = m, cos 0 + m, sin 0. Find the inclination angle, Tension in other wire and the mass of blocks. By used Grammar method. F1

Name: Q2:- For static system as shown in figure, ifk = 50 N/mm, m, =m2, u =
Uploaded: 2024-03-20T06:56:46.000Z
Channel: Bartleby
Description: Q2:- For static system as shown in figure, ifk = 50 N/mm, m, =m2, u = 0.25 for theblocks m, and m2,spring elongation = 5 mm and the forceF1 = m, cos 0 + m, sin 0. Find the inclinationangle, Tension in other wire and the mass ofblocks. By used Gramma

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

4. You are pushing horizontally with a 300 N force on a box that is on an inclined plane as shown. The mass of the box is 30 kg and the incline is at a 25 degree angle off the Fapplied horizontal. The coefficient of kinetic friction between the box and the incline is 0.3, and the coefficient of static friction i 0.4. Assuming the box was at rest at t=0 when the force is initially applied, is the box moving up the ramp, down the ramp, or is it at rest after the force has been applied? 25⁰
no air resistance, g=9.81 mls^2 mB=2450 goes up ramp, and the coefficient of kinetic friction between mass b and the ramp is 0.6. The ramp makes an angle of 63 degrees a counterweight is used to raise stone B by tying it to a second mass MA. The coefficient of friction for mA as it slides down the shaft is 0.4 pitched at an angle of 13 degrees. question- draw a body diagram for mass B and write 2 equations for the forces in x and y direction.
Finish the solution of the problem. Find the tension T in the rope.
Consider the system of three connected blocks shown in the diagram. If between the inclined plane and the blocks there is a static friction force of coefficient Us a. Find the minimum and maximum values that M can have for the system to remain in equilibrium. b. If friction between all surfaces is eliminated, determine the mass M that ensures the system remains in equilibrium, and find the tensions in the string
Solve the Friction Problem
IP Two blocks, stacked one on top of the other, can move without friction on the horizontal surface shown in the figure.(Figure 1) The surface between the two blocks is rough, however, with a coefficient of static friction equal to 0.44. Part A If a horizontal force F is applied to the 5.0-kg bottom block, what is the maximum value F can have before the 2.0-kg top block begins to slip? Express your answer using two significant figures. Πν ΑΣφ. F = N Submit Request Answer Part B If the mass of the top block increased, does the maximum value of F increase, decrease, or stay the same? O increases O decreases O stays the same Submit Request Answer Provide Feedback Figure 2.0 kg F 5.0 kg
Situation 01. A 60-kg block is at rest when an upward force parallel to the 15° surface is applied. If Hie = 0.18, and ,= 0.23, a. Determine the acceleration if P=180N. b. Determine the acceleration if P= 320N.
OU President Harroz is hanging an OU banner outside of Boyd house. The banner is hanging from a bar of length L that is supported by a cable attached a distance L/2 above the end of the bar. There are two options, attach the cable to the end of the bar (blue cable) or at a point somewhere nearer the middle of the bar (red cable). Let Fend be the tension if a cable is attached to the end of the bar and Fmid be the tension if a cable is attached closer to the middle of the bar. (There is only one cable at a time.) Let the mass of the sign be 6.07 kg and the mass of the bar be 4.02 kg. Let the red cable be attached a distance 0.60 L from the right end of the bar. What is the ratio of the forces, Fmid/Fend? Give your answer to three significant digits to avoid being counted off due to rounding. As this is a ratio, there are no units. L ලා L/2
A body with a mass M placed on a tilted surface at an angle of 0 (see figure) We applied a horizontal force F = Mg on the body as shown. a) Assume that the frictional force between the body and the surface is large so that the body remains in place. Find the FN Vertical Force and the Friction Force? b) In terms of the static coefficient of static friction oh what is the range of angle 0 at which the object remains static?
Use 3 Sig figs for the solution and final answer
MCQ 4. The first of two identical boxes of mass m is sitting on level ground. The second box is sitting on a ramp that makes a 20° angle with the ground. The normal force of the level ground on the first box is NL; the normal force of the ramp on the second box is NR. Which statement is correct? a. NR= NL = mg. b. N₁ mg; NR= mg sin 20°. C. NL = mg; NR = mg cos 20°. d. Nr.= mg; NR= -mg cos 20°. e. NR=-NL = -mg.
89 and -89 is wrong. Please answer correctly