Q2) Calculate the Rr for the following circuits and draw the equivalent circuits: ㅓㅣㅏ V1 5V 4 R1 ww 4.1k2 R2 1002 1 R3 ww2 5.00M Circuit 1 R4 3302 ww 3 R5 470k

Q: The A/D converters add a significant cost to the system. True False

A: In this questions, we need to tell about the ADC is expensive or cheaper.

Q: The circuit consist of a capacitor, inductor, resistor and voltage source in series, the standard…

A:

Q: Innovative ideas to reduce energy consumption in communution circuit

A: To explain  the  reduce energy consumption in communution circuit

Q: 3) Is there maximum power transfer from: a) source to amplifier? b) amplifier to load?

A:

Q: The electrodynamic instrument can be used as a voltmeter by connecting a large inductive with…

A: The given statement is a false statement.

Q: * final Lod there fanctions 서- 3- (S+€) (s-V3)

A:

Q: If the cross sectional area of a conductor is halved, then the resistance of the conductor becomes…

A:

Q: The equivalent resistance across terminals AB is:

A: Given:

Q: The amount of the current through an inductor in a DC circuit:

A: The solution can be achieved as follows.

Q: Which of the following could be the boundaries of the given shape? R=5 A=71⁰ B=16⁰ W

A:

Q: a resistor and capacitor are connected in parallel to 208 v 60 hz power source it has a total…

A:

Q: Calculate the voltage and current values listed for each of the following series and parallel…

A:

Q: A 433 V battery is used to charge a 6.46 µF capacitor. Now the capacitor is connected in series with…

A: We can redraw the circuit as Initially when resistance of rheostat will be zero then there will be…

Q: Ip Si +20 V Vo Si 4.7 k2

A:

Q: a) Total voltage: R9 R10 400 600 R6 300 R7 $500 R8 700 11 I 10A R11 800

A:

Q: How many resistors are there in the hybrid pi model? 0 1 02 04 none of the other choices 05

A: Hybrid pi model: A circuit model for examining transistor small-signal performance is the hybrid-pi…

Q: The Perfomance of

A: Here in this we discuss about the performance of an alternator.

Q: Find the peak current of a series RLC circuit with the following parameters: source voltage= 1OVpk…

A: Given, A series RLC circuit has, Peak value of source voltage (Vpk)= 10 voots Resistance R = 510 ohm…

Q: can you please explain how we do the d) section

A:

Q: Find the peak current of a series RLC circuit with the following parameters: source voltage= 10Vpk…

A: Source Voltage Vs=10 v (p-p)Frequency f=100 HzR=510 ΩC=22 μFL=1 H

Q: Which one of the following voltage levels is not a standard level for residential loads Select one:…

A:

Q: Determine IT and Z in the circuit in the figure below

A:

Q: In purely resistive circuits, the current is out of phase with the voltage Select one: O True O…

A: we need to tell given statement is true or false.

Q: An inductive coil takes a current of 2 A and consumes 160 W when connected to a 240 V AC supply. A…

A:

Q: 16kv-4wire circuit has 150 amps on A at zero degrees, 160 on at 120 degrees and 170 amps on at 240…

A: Since it is 4 wire system. So type of load will be star connected.Now equivalent circuit can be draw…

Q: 9. The initial rate of current rise in an R-L circuit is 800 amps per sec when 453 volts is suddenly…

A: (9) Given  Initial rate of rise of current in the circuit is 800 amp/sec. i.e   di/dt = 800 amp/sec…

Q: Write the current and voltage relations for the following two components. R U U (a) (b)

A: According to the question we have to discuss the voltage and current relation for a given component.

Q: Please solve the numbers c, d and f.

A: The inductive reactance is calculated by the following expression,

Q: Q/A)the current in R according to the source 7v is: * R 150 V1 =7V R3 200 R2 V2 9V A6 0.33 O 0.44 O…

A:

Q: the total resistance of the following circuit is: * 150 Req R1 R3 18Ω 200 R8 R2 140 R5 O 22.72 27.21…

A:

Q: Which is not correct about a power supply O A power supply's primary function is to convert electric…

A: Power supply: Power supply is a electrical device. It is used for electrical power supply to an…

Q: Three capacitors are connected in parallel and have the following voltage ratings: C1 = 32 uF with…

A:

Q: How can i find the total impedance in this circuit

A: In the circuit, resistance , inductance and capacitor Reactance are consist.  find the total…

Q: In the L-C-R circuit shown below, the voltmeter and ammeter readings are : 400 V 400 V O moo L R =…

A: Current in inductive circuit lag voltage by 90 degree Current in capacitive circuit lead voltage by…

Q: A LED which bright one color when forward and another color on reverse is called One directional LED…

A:

Q: what is the puwer burned into Re q maaimizes Pz what value of R

A:

Unijunction Transistor (UJT)

The Unijunction Transistor (UJT) is a three-terminal switching semiconductor device. It contains an n-shaped silicone object bar with a terminal attached to its two ends known as base one and base two. The third terminal is connected to a highly enclosed p-type material attached to the bar section of its length and is known as emitter. As there is only one corrective cross within the device, it is therefore called the 'Unijunction' transistor. The characteristics of the single junction transistor show the wrong resistance if it finds use in resting oscillator circuits for various applications.