Q1.1// The figure below shows the plan of a rectangular raft foundation which supports a total load of 40500 kN. The foundation is located at 3 m from the surface. Evaluate the increase in the effective stress at a point 8 m below the surface and having x, y coordinates as (-9, -6.5) with respect to the central axis of the footing. Y 15 m 9 m

Q1.1// The figure below shows the plan of a rectangular raft foundation which supports a total load of 40500 kN. The foundation is located at 3 m from the surface. Evaluate the increase in the effective stress at a point 8 m below the surface and having x, y coordinates as (-9, -6.5) with respect to the central axis of the footing. Y 15 m 9 m

Principles of Foundation Engineering (MindTap Course List)

8th Edition

ISBN:9781305081550

Author:Braja M. Das

Publisher:Braja M. Das

Chapter4: Shallow Foundations: Ultimate Bearing Capacity

Section: Chapter Questions

Problem 4.2P: A square column foundation has to carry a gross allowable load of 1805 kN (FS = 3). Given: Df = 1.5...

See similar textbooks

Similar questions

The material used in the unreinforced expandedfoundation has poor tensile and flexural properties.To ensure that the foundation has sufficientrigidity, the most effective of the followingmeasures is ( )◼A. Adjust the average pressure on the bottom of thefoundation◼B. Control the allowable value of the height-to-widthratio of the foundation steps◼C. Improve the bearing capacity of the subgrade soil◼D. Increase the compressive strength of the material
o T ☺ ť Q2: A ring foundation having load equal to 400kPa is resting on a saturated clay soil layer, the groundwater level is at the natural ground surface. The outer diameter of the foundation ring is 8m. Find the inner radius of the ring foundation if the total stress at a point located 4m beneath the center of the ring foundation equal to 251kPa, knowing that the saturated unit weight of the clay is 16kN/m'. (Use the below formula) Solution:- Aoz = q مر ر ل لأعلى لاستعراض الفلاتر إضافة شرح.. . mum <
Q2) Find the increasing stress (Ao) at point A, at depth 6 m below the corner of the footing of foundation by using Boussinesq equation and attached table. 3m 660 KN 3 m 1.5 m 6m 3x3 m 6m A pint 1.5 m 40. Table 10.8 Variation of , withm and a Tq (10.30) 0.1 02 04 0.5 07 0.0047 0.0092 00132 0.0092 00179 0.029 0.0328 00132 0.0259 00174 0.0174 00222 001 0.087 00242 0.0474 02 0.0328 00474 0.0602 00711 0.0801 0.O873 00629 0.0801 0047 0.1069 0116 04 0.0711 0.0168 00198 0.0222 00242 0.0873 0.1014 Q1168 0.1277 06 07 0.017 00474
A piece of engineering equipment is supported by the foundation shown. The diameter of the circular pin is 20 mm. a.) Determine the value of P so as not to exceed the allowable bearing stress of 310.5 Mpa in the circular pin. b.) Determine the value of P so as not to exceed the allowable shearing stress of 138 Mpa in the circular pin.
A piece of engineering equipment is supported by the foundation shown. The diameter of the circular pin is 20 mm. a.) Determine the value of P so as not to exceed the allowable bearing stress of 310.5 Mpa in the circular pin.b.) Determine the value of P so as not to exceed the allowable shearing stress of 138 Mpa in the circular pin.
Q2: Compute the total stresses, which induced from geostatic stress and increase vertical stress from circular foundation under points A and B to 3 and 6 m depth from the base of the foundation. The foundation was constructed at 2.0 m below the natural ground level (NGL). The surface load intensity is 330 kN/m². R1= 4, (calculate R2 from the drawing, do not assume it). Assume any other parameter you need in your answer. Aqs net
A continuous foundation is required in a soil where c=10kN/m2, =26, and =19.0kN/m3. The depth of the footing will be 1.0 m. The dead load and the live load are 600 kN/m and 400 kN/m, respectively. Determine the required width for the foundation based on allowable stress design with FS = 3, using Eq. (6.10) and Table 6.1.
A square column foundation has to carry a gross allowable load of 1805 kN (FS = 3). Given: Df = 1.5 m, =15.9 kN/m3, = 34, and c = 0. Use Terzaghis equation to determine the size of the foundation (B). Assume general shear failure.
For the mat in Problem 16.15, what will be the depth, Df, of the mat for FS = 3 against bearing capacity failure? 16.15 Consider a mat foundation with dimensions of 18 m 12 m. The combined dead and live load on the mat is 44.5 MN. The mat is to be placed on a clay with cu = 40.7 kN/m2 and = 17.6 kN/m3. Find the depth, Df, of the mat for a fully compensated foundation.
A flexible circular footing of radius R carries a uniform pressure q. Find the depth (in terms of R) at which the vertical stress below the center is 20% of q.
Q1: determine the increase in vertical stresses at depth of Z=3.5 m under points A, B and C due to apply rectangular and ring foundations. The surface load intensity of rectangular is 250 kN/m², while the surface load intensity of ring is 300 kN/m².The drawing was done without scale and all dimensions in (m). R1 R2 X1 X2 В L 3 4.5 7.5 6. 12 X1 X2 Aqs-net(2) R1 Aqs-net(1) R2
the pad footing is used to support the load of 12 000lb. determine the intensities (in lb/ft) w1 and w2 of the distributed loading acting on the base of the footing for the equilibriumWhat is the computed value of w1 in pounds per foot What is the computed value of w2 in pounds per foot