Q1. One 2 kg pebble is moving left on frictionless ice at a speed of v = 10 m/s as shown in Fig 1. At t = O s, a constant force F is applied to the particle. After 2 s, the velocity of the pebble has become v2 as shown in Fig. 2. The figures show what you see when viewing it from the top. Determine the magnitude of the force F.

Q1. One 2 kg pebble is moving left on frictionless ice at a speed of v = 10 m/s as shown in Fig 1. At t = O s, a constant force F is applied to the particle. After 2 s, the velocity of the pebble has become v2 as shown in Fig. 2. The figures show what you see when viewing it from the top. Determine the magnitude of the force F.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Q2.A/ Show that the expression (1/2 mv² = √mgh) is dimensionally correct, where v is the velocity and g is the gravitational acceleration, m is the mass and h is the height.
I need the answer as soon as possible
A particle of mass 0.01 kg is traveling at a speed of 15.5 m.s¹ at an angle of 1.8 radians from the i vector (toward j). A force of 0.02e-0.02t N is applied to the particle at an angle of 3.4 radians from i. Answer all questions to at least 3 significant figures. Enter your numerical answers in SI units but do not enter the units. Determine the j component of the initial velocity [m.s¹] Determine the force in the i direction at t=3.8s [N] What is the i component of velocity at t-3.8s? [m.s¹]
Rocket sleds were used to test aircraft and its effects on human subjects at high speeds. It is consisted of four rockets; each rocket creates an identical thrust T. أحسبه المود Calculate the magnitude of force exerted by each rocket (T) for the four-rocket propulsion system shown in the Figure. The sled's initial aceeleration is 49 m/s. the mass of the system is 2100 kg, and the force of friction opposing the motion is known to be 650 N. T. T. T. Solution: H.W Free body diagram
A happy kangaroo leaps vertically upward at a time t = 0. At time t = 0.50 s the kangaroo is at a height of 2.0 meters above the ground. What is the speed and direction of motion of the kangaroo at this time (at t = 0.50 s)? Neglect air friction. 4.9 m/s downward 1.55 m/s upward O none of these 2.45 m/s downward 4.9 m/s upward 2.45 m/s upward
A helicopter with a mass of 10,000 kg takes off straight up at t=0. The thrust of the engine is defined given as a function of time: FT= 95 0.18t- (kN). Where t is in units of seconds. How fast is it rising and what is its elevation at t=4s?
An object with a mass of 0.45 kg is released from rest while immersed within a fluid. It reaches a speed of 50.6 percent its maximum speed in a time of 0.5 seconds. What is the object's terminal speed if the resistive force acting is given by; R = -bv ? (Assume that the gravitational force also acts)
A bullet is fired at an initial velocity of 155 m/s horizontally (0 degrees) at the top of a 114 m tall building. Neglecting air resistance, determine the velocity in m/s with which the bullet will hit the ground. Use the value of the gravity in 2 decimal place. Use up to 4 decimal places. NOTE: Do not assume that this is the same problem as the previous question. The numerical values for each question are different.
Q5. the acceleration due the gravity on the moon is 1/6" of what it is on earth. If you can throw a baseball on earth to reach a maximum height of 20m, how high could you throw a baseball on the moon? If you caught it when it came back down, how much time would elapse between your throw and catch? 3.-0 18m V-18.8m * Figure (1)
We want to design a wagon system like the one below while filling the kiln with coal at the Coke factory inside Kardemir. In this system, we want the wagon to reach a speed of v= 1 m/s in t=2 seconds. It will then shoot at constant speed. How much engine power is required to tow a wagon with W= 500 kgf under these conditions P=? (Losses will be ignored). (The slope angle of the ramp is α= 25 degrees.)
1. Calculate the kinetic energy of a body which has a mass of 5 kg and velocity of 10 m/s. 2. In a non-flow process carried out 5.4 kg substance, there was a specified internal energy decrease of 50 kJ/kg and a work transfer of the substance of 8.5 kl/kg. Determine the heat transfer and a state whether it is gain or loss. 3. A gas is contained in a cylinder with a moveable piston on which a heavy block is placed. Suppose the region outside the chamber is evacuated and the total mass of the block and the movable piston is 102 kg. When 2140 J of heat flows into the gas, the internal energy of the gas increases by 1580 J. what is the distance through which the piston rises? 4. Calculate the increase in internal energy of a gas in a closed system during a process in which of heat is supplied to the system and 400 J of work is produce. 5. Convert the following readings of pressure to kPa, assuming the barometer reads 760 mm Hg. a. 90 cm Hg gauge b. 40 cm Hg vacuum c. 1.2 m H20 gauge
Consider an Atwood machine similar to that used in the experiment: Each pan has a mass of 65.50 g. The right pan is made 8.00 g heavier than the left pan. It takes the right pan 2.52 s to descend from the top platform to the bottom platform 1.24 m below.Compute the % difference between the true value and experimental values of the acceleration of the pans. The mass of the pulley is 82.20 g. Express the accelerations in m/s2. [Use two (2) decimal places]