Q1- Water flows in a rectangular channel of 5 m width and flow rate of 15 m³/s with F= 2.75 and water depth y1=0.495 m. Due to slope change in this channel, a hydraulic jump will occur. Calculate the depth of the hydraulic jump in this channel.

Q1- Water flows in a rectangular channel of 5 m width and flow rate of 15 m³/s with F= 2.75 and water depth y1=0.495 m. Due to slope change in this channel, a hydraulic jump will occur. Calculate the depth of the hydraulic jump in this channel.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: ngular channel 3 m wide and 1 m deep, the value of Bazin's constant is 1.75 for earthen channel in…

Q: The sequent depths in a hydraulic jump formed in a 4.0m wide rectangular channel are 0.3 m and 1.2…

A: Given- Sequent depths- y1=0.3 m,y2=1.2 m, Width of channel b = 4 m, It is needed to find the…

Q: D=1.2m

A: Diameter of Pipe, Do= 1.2 m Depth of flow, y = 0.08 mm θ is angle subtended by water surface at…

Q: Given the following data for a stream of uniform flow: A = 8.98 sq.m. (average stream cross section)…

A: Given data, A = 8.98 m² P = 10.76 m S = 0.008 n = 0.020 To find out the hydraulic radius of…

Q: At the foot of a spillyway, water flows at a depth of 23 cm with a velocity of 8.1 m/s, as shown in…

Q: on. a) Using the above values, determine the hydraulic radius. b) Calculate the value of the Chezy's…

Q: PROBLEM 3 Water is to flow at a rate of 30 m³/s in the concrete channel (n = 0.013) with the…

Q: A trapezoidal channel with 3.0m bottom width and 1:1 side slope carries a discharge of 10 m³/s at a…

Q: Given that Q = 20 m3/s, calculate the flow depth of the stream after the scour hole.

Q: 4: A discharge of 25 cumec occurs in a rectangular open channel 2.7m wide with bed slope of 0.003…

Q: bot can't answer it right.

A: The objective of the question is to calculate the hydraulic radius, mean velocity of the flow, and…

Q: Water is flowing uniformly in an open channel (triangular shap has a 1:2 (v:h) side slope and a…

Q: depth of 0.8m with a Froude Number of 5 befo jump. a. Find the Froude Number after the jump. b. What…

Q: Situation 5 A well of diameter 300 mm is constructed to the full depth of a soil of thickness 150 m,…

A: As per bartleby guidelines. We have to solve 1st question in case of multiple question. Please…

Q: For the irregular channel shown, determine: (a) the area of flow, A [m], (b) the wetted perimeter, P…

Q: Q. M The hydraulic radius (m) for a circular pipe of diameter (D) behaving as open channel is given…

Q: A triangular channel flows with a side slope 1 H:3V. If the roughness coefficient and hydraulic…

Q: The 3.2-meter width of a trapezoidal channel is shown below. Determine the normal depth (meter) that…

Q: trapezoidal cross-section with bottom width, B = 3 m, and sidewall slope, 0 = 60° is shown as below.…

A: As per guidelines we need to answer only first 3 subparts of the question so please repost rest…

Q: The seepage loss in cm?/sec for a hydraulic structure, if the flow net contains 5 flow lines and 9…

Q: 8.15) The flow rate and water depth just upstream of a dam are 15 m³/s and 4.0 m respectively. The…

A: Reference : Fluid mechanics, Rectangular Channel section. Given : Flow rate, water depth, width ,…

Q: The depth after the jump is 1.4m a. What must be the depth before the jump? b. Determine the head…

A: Given:- Rectangular channel of width, b = 5 m Discharge in the channel, Q = 6 m3/sec Depth after…

Q: A rectangular open channel is 4m wide and has a discharge of 10 cu.m./s when the depth of flow is…

A: Given data: width of channel=4m Discharge=10 cu.m/sec Depth of flow=2m It is asked to calculate…

Q: A hydraulic jump occurs in a V-shaped channel having sides sloping at 45°. Derive an equation…

A: Hydraulic jumpA hydraulic jump is a phenomenon that occurs regularly in open channel flow, such as…

Q: Question 5 a. As a result of a sudden enlargement in a piper from a diameter 0.30 m to 0.60 m, the…

A: As per guidelines we can solve one question at a time, please upload separately,Thanks Solution…

Q: : A box culvert, as shown in the figure, was designed to carry a discharge (Q m/s) from a square…

A: The significance of understanding the mechanics of fluids is clear from when we turn on our kitchen…

Q: Q16) For the flow condition shown in the figure, determine: 1) The hydraulic gradient. 2) The total…

Q: A hydraulic Jump occurs in a trapezoidal channel having b=6ft, m=2, and Q=200cfs. The flow depth…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub- parts for…

Q: rectangular Cha depth at a section is 0.5 m, determine the: (1) Conjugate depth (2) Length of the…

A: Width of channel(B)=3m Discharge through channel=12.9m3/s Depth of flow(y1)=0.5m

Q: the head required to convey the discharge through the culvert

A: Given, Discharge, Q =0.5342 m3 /s Length of pipe, L = 38.5 m Head Loss, HL=n2V2LV4/3 Where , n…

Q: Need help asap. Water flows in a wide channel at q = 10 m³/s/m and a depth of 1.25 m. If the flow…

Q: Q3 Figure Q3 shows a flow net for flow through a weir, the base of which is 2m below the ground…

Q: the thickness of the water at that section is:

Q: fficient section if the wetted area is 1.0 square meters. Draw the cross section of the channel with…

A: Given- A=1m2 θ=45°

Q: mber In a lined rectangular canal, the Froude hl of incoming flow is 3.0. A hydraulic jump forms…

Q: Water flows at the rate of 1 m3/s along a channel of rectangular section, 1.75 meters in width. If a…

Q: Determine the critical depth for best hydraulic cross-section of a trapezoidal channel that carries…

A: For trapezoidal channel we have:yc=49×Q2g15

Concept explainers

Highway Drainage

Highway drainage is the process of extracting and regulating the excess surface water on the pavement by giving the desired slope. The construction of a highway drain helps to divert the water present on the surface, and sub-grade by the means of slope. Highway drainage systems are a necessary part of smooth functioning of traffic, since the highway drainage systems provide proper disposal of unwanted substances from the highways.

Question

Q1- Water flows in a rectangular channel of 5 m width and flow rate of 15 m³/s with F= 2.75
and water depth y1=0.495 m. Due to slope change in this channel, a hydraulic jump will occur.
Calculate the depth of the hydraulic jump in this channel.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given

VIEW

Step 2: Calculation

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A pipe of length L = 500 m, diameter D = 300 mm and absolute roughness k = 0.02 mm transports a flow Q = 456 m3/h. Using the Darcy-Weisbach formula determine the hydraulic gradient and headloss through the pipe. The water temperature may be assumed to be 20° C.
In a lined rectangular canal, the Froude number of incoming flow is 3.0. A hydraulic jump forms when it meets the pool of water. The depth of flow after the jump formation' is 1.51 m. Froude number of flow after the hydraulic jump is:
A trapezoidal channel having side slopes of 2 3 horizontal and 1 vertical discharges 14.35 m/s of water at a velocity of 1.0m/s. The channel lining has a roughness coefficient, n = 0.013. Find the dimensions of the channel for the least expenditure of energy. Find also the slope of the bed
Question 2 A trapezoidal channel with these conditions: Left side slope = 3H:2V Right side slope = vertical . has a bottom width of 8 meters and depth of 6 meters. Determine the hydraulic radius in meters.
A pluvia drainage channel, in a city where large sudden rains occur, has the shape shown in the figure. It is made of unfinished concrete and has a 0.5 percent slope. The sectionhigher allows large volumes to be transported through the channel. Determine the normal discharge for depths of 0.5 m and 2.5 m
A trapezoidal channel having side slopes of 2 3 horizontal and 1 vertical discharges 14.35 m/s of water at a velocity of 1.0m/s. The channel lining has a roughness coefficient, n = 0.013. Find the dimensions of the channel for the least expenditure of energy. Find also the slope of the bed
a) A trapezoidal weedy excavated earth channel has a bottom slope of 1°, base width of 5 m and a side surface slope of 1:1, as shown in Figure 1. Given that n = 0.030, calculate the flow depth, y. 45° 45° - 5 m Figure 1
In the case of a rectangular channel 3 m wide and 1 m deep, the value of Darcy-Weisbach's constant is 0.038. a.Using the above values, determine the hydraulic radius. b.Calculate the value of the Chezy’s constant.* c. For a bed slope of 1/2500, find the flow rate.
The coefficient of permeability below a dam is 12 m/day. The water in the upstream side is 32 meter higher than on the downstream side (level with the ground). To estimate the seepage below the dam, a flow net is graphically drawn such that the number of potential drops, Nd = 8 and the number of flow channels Nf = 3. The base of the dam is founded 1.8 m below the ground. Between the heel and the toe of the dam, a distance of 32 meters, there are 6 potential drops. a. Estimate the seepage per meter length of the dam in liters per minute. (IN EXPONENTIAL FORM AND IN 2 DECIMAL PLACES) b. Determine the uplift pressure at the heel in kPa. (IN 2 DECIMAL PLACES) c. Determine the uplift pressure at the toe in kPa. (IN 2 DECIMAL PLACES)