Q1: For the Figure Below if the input to the first tank is step with magnitude 2 find 1. What type of relation between (tanks 1 and 2) and tank 3 2. Initial real value of H2, if the steady state value is 10 3. Final Value of H3 4. H1 at t=1.5 5. For the system tank1 and tank 2 only which case is applied to them (overdamping, underdamped or critically damping) A₁=1 A₂=1 Tank 1 R₁ = 2 * Tank 2 R₁₂=2 A3=0.5 hy R₁=4 Tank 3

(Civil eng.) Modify the program written for Exercise 9 to determine the maximum load that can be placed at the end of an 8-foot I-beam, shown in Figure 2.21, so that the stress on the fixed end is 20,000lbs/in2. Use the fact that this beam’s rectangular moment of inertia is 21.4 in4 and the value of c is 3 in.

(Thermodynamics) The work, W, performed by a single piston in an engine can be determined by this formula: W=Fd F is the force provided by the piston in Newtons. d is the distance the piston moves in meters. a. Determine the units of W by calculating the units resulting from the right side of the formula. Check that your answer corresponds to the units for work listed in Table 1.1. b. Determine the work performed by a piston that provides a force of 1000 N over a distance of 15 centimeters.

(Civil eng.) The maximum load that can be placed at the end of a symmetrical wooden beam, such as the rectangular beam shown in Figure 2.20, can be calculated as the following: L=S1dc L is the maximum weight in lbs of the load placed on the beam. S is the stress in lbs/in2. I is the beam’s rectangular moment of inertia in units of in4. d is the distance in inches that the load is placed from the fixed end of the beam (the “moment arm”). c is one-half the height in inches of the symmetrical beam. For a 2” × 4” wooden beam, the rectangular moment of inertia is given by this formula: I=baseheight3=12=24312=10.674 c=(4in)=2in a. Using this information, design, write, compile, and run a C++ program that computes the maximum load in lbs that can be placed at the end of an 8-foot 24 wooden beam so that the stress on the fixed end is 3000lb/in2. b. Use the program developed in Exercise 9a to determine the maximum load in lbs that can be placed at the end of a 3” × 6” wooden beam so that the stress on the fixed end is 3000lb/in2.