Answered: (Q1] Determine the input impedance of a…

(Q1] Determine the input impedance of a short-circuited 50 2 coaxial line with B =8.5 rad/m when its length is: (loss less) 1- Infinite 2- 1/8

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter6: Power Flows

Section: Chapter Questions

Problem 6.17P

See similar textbooks

Related questions

Q: A lossless transmission line having 50 Q characteristic impedance and length 4 is open circuited at…

A: It is given that: Zccharacterstic impedance=50ΩVgLoad voltage=3VZgLoad impedance=20Ω

Q: A half-wavelength, lossless transmission line is 1.4 m long and terminated in 20 - j10 0. The…

A: For the lossless transmission line, the characteristics impedance is given as, In the question, the…

Q: )A 60-ohm distortionless transmission line has a capacitance of 0.15nF/m. The…

A: here, the given line is the distortionless transmission line so, the condition of the distortionless…

Q: Line parameters of a transmission line at 2 GHz are R = 10 mn/m, G = 1 µS/m, L = 1 µH/m, C = 1 nF/m…

A: The given circuit diagram is shown below: It is given that: R=10 mΩ/m=10×10-3 Ω/mG=1 μS/m=1×10-6…

Q: A 70-2 lossless line has s = 1.6 and Or 300°. If the line is 0.6A long, obtain r, ZL.

A: The EM wave is formed when electric field is in contact with magnetic field. A transmission line is…

Q: A transmission line has the following per-unit-length parameters: L = 0.5 µH/m, C = 200 pF/t R = 4.0…

Q: An 80 N transmission line operating at 12 MHz is terminated by a load Z1. At 22 m from the load, the…

A: 5. A lossless line is characterized as a transmission line that has no line obstruction and no…

Q: The open-circuit and short-circuit impedances measured at the input heads of a transmission line…

A: Given that zOC=250∠-50°zSC=360∠20° Formula for z is given by z=zOCzSCplugging…

Q: A certain transmission line operating at w = 10° rad/s has a = 8 dB/m, B = 1 rad/m, and Z, = 60 +…

A: Given data : ω=106 rad/sα=8 dB/mβ=1 rad/mZ0=60+j40ΩZg=40ΩZL=20+j50Ω

Q: [Q4] An open wire transmission line terminated in characteristic impedance has the following primary…

Q: A transmission line with a characteristic impedance Z, = 50 Q requires an impedance matching network…

Q: Q1) A microwave 2-port network has the following scattering matrix 0.1 <45° [s] = [0.5 <20° ¹0.5…

A: For the given two port network by using the scattering matrix the loss seen at port 1 when the port…

Q: (a) A 602 lossless transmission line is terminated with an antenna of impedance of (27 + j30) N. Use…

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If…

Q: Consider the lossless transmission line shown below. Z, = 60 2 Z 125 2 VE

A: Reflection coefficients determine how much wave is is reflected at discontinuity of medium. It is…

Q: At 1 MHz, the characteristic impedance and propagation constant of a lossy transmission line are…

Q: A lossless transmission line is 80 cm in length and operating at a frequency of 140 MHz. The line…

A: Given, Length=80cm=0.8m Frequency=f=140MHz Capacitance=C'=70×0.8=56pF Inductance=L'=0.4×0.8=0.32μH…

Q: Tt=3.14 For a Transmission line, L=6,4 nH/m, R=2,9 0/m, C=1,2 µF/m and G=8,5 S/m (f = 1 GHz). For…

A: According to the question we have to find the value of ZR.

Q: Calculate the charecterictics impedance, propagation constant and velocity of propagation at 600 KHz…

A: Given: f=600KHz L=0.5Mh/km C=0.8μF/km R=G=0 (negligible)

Q: 4. A transmission line is terminated in its characteristic impedance as shown below. Explain what…

Q: Q2: For A lossy short-circuited coaxial transmission line, find an input impedance if the…

A: Transmission line- The term transmission line refers to both overhead and underground cables. An…

Q: A transmission line operating at 125 MHz has Z = 40 2, a = 0.02 (Np/m), and B = 0.75 rad/m. Find the…

A: This question belongs to power system . It is based on the concept of distortion less transmission…

Q: -4. A lossless transmission line has a characteristic impedance of 100 N and is terminated in a load…

Q: The parameters of a lossy transmission line are L' = 0.45 µH/m, R' = 0.15 2/m and w 5 x 10° rad/s.…

Q: 2.9 A 75 2 coaxial transmission line has a length of 2.0 cm and is terminated with a load impedance…

A: It is given that: Zo=75Ωl=2 cmZL=37.5+j75 Ωεr=2.56f=3GHz

Q: For a one port network, explain the effect on the admittance frequency characteristics when it has a…

A: In the question, What is effect of frequency in admittance of path if Element is connected to…

Q: A shielded, twin-wire line has a dielectric of relative permittivity 2 and a characteristic…

Q: At an operating frequency of 300 MHz, it is desired to use a section of a lossless 50 N transmission…

A: Transmission line

Q: The network shown below consists of two lossless transmission lines of lengths l, 12 = 1/2 where a…

A: Real power is the power consumed by the load for doing any work, and it is symbolized as P, unit of…

Q: A certain transmission line operating at w = 10° rad/s has a = 8 dB/m, 8 = 1 rad/m, and Z, = 60 +…

A: Wave is function of space and time. The mode at which waveguide have lowest frequency is said to be…

Q: Assume the pair of transmission lines, 1 and 2, are repeated 10 times. (a.) If the individual line…

A: calculate input impedances at line 1 2 3 and 4 by now we can observe a pattern and thereby we can…

Q: A 60-ohm distortionless transmission line has a capacitance of 0.15nF/m. The attenuation of the line…

A: Given data Z0=60 ΩC=0.15 nF/mα=1.15×10-3 Np/m i) Expression of characteristic impedance Z0=LC…

Q: Transmission line of Zo = 75 Q and electrical length (= 0.333A is terminated with a Z = 30-j40 N.…

A: (i) The reflection coefficient at the load is given by the expression as shown below: τ0=ZL-Z0ZL+Z0…

Q: 1. A certain transmission line operating at w = 106 rad/s has a = 8 dB/m, ß = 1 rad/m and Z, = 60 +…

A: According to guidelines, only the first question will be solved. If any other solution is needed,…

Q: If the two media have equal impedances (Ni = n2), then I = . . and S = 1, and if medium 2 is a…

Q: The open-circuit and short-circuit impedances measured at the input terminals of an air- spaced…

Q: Q1: A transmission line has the following per-unit-length parameters: L = 0.5 µH/m, C = 210 pF/m, R…

A: Power System Network: A basic Power system network consists of Generation unit, Transmission unit…

Q: A telephone line has R At a frequency, f = 4.75 kHz, determine the characteristic impedance and the…

Q: 2- Transmission line 10m long has distributed parameters R = 52/m, L = 6µH/m, G= 10 mS/m, and C = 25…

Q: Consider an LTID system with system function H\z] = bo 9/16 (a) Determine the constant bo so that…

A: The transfer function of the system is: The frequency response of the system is given. First, we…

Q: A 602 lossless transmission line is terminated with an antenna of impedance of (27 + j30) Q. Use the…

Q: A) Determine the primary constants, R, L, G, and C for a distortion-less line working at 300 MHz.…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: 9. In air, a lossless transmission line of length 50 cm with L=10µH/m, 40PF/m is operated at 25 MHz.…

Q: In air, a lossless transmission line of length 50 cm with 10µH/m, C = 40PF/m is operated at 25 MHz.…

A: Given a lossless transmission line having, Length, l = 50 cm Inductance, L=10 μHm Capacitance, C=40…

Q: On a 144 N lossless transmission line, the following observations were noted: distance of first…

A: Given Characteristic impedance is Zo=144Ω, Distance of first voltage minimum to the load is 3cm…

Q: A 300Ω transmission line 150m long, operates at 400kHz with attenuation coefficient of 2.4 x10^(-3)…

A: A 300Ω transmission line 150m long, operates at 400kHz with an attenuation coefficient of 2.4…

Q: For a medium transmission line, VRNL is equal to Vs. Select one: O True O False

A: sending end voltage will be same as no load receiving end only when capacitance effect is absent .…

Q: 1) Find the median path loss using Okumura's model for d = 50 km, h, = 100 m, h, = 10 m in a…

Q: The line parameters of a lossless transmission line are L = 0.25 µH/m and C= 100 pF/m. If the…

Q: For a one port network, explain the effect on the admittance frequency characteristics when it has a…

A: In the question, What is effect of frequency in admittance of path if Element(either indotor Or…

Q: What is the input impedance of a 50 Ω open circuit transmission line of length λ ⁄ 8, in ohms?

A: Solve as below

Concept explainers

Types of Charge Carriers

A carrier is a type of object which carries a particular thing from one point to another point. For instance, people use different vehicles from one place to another, and the vehicle carries those people and acts as a carrier.

Question

[Q1] Determine the input impedance of a short-circuited 50 2 coaxial line with B =8.5
rad/m when its length is: loss less)
1- Infinite
2- 1/8

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Types of Semiconductor Material and Its Energy Band Analysis

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4 cm, the distance between the conductors is three and half meters and the height above ground is eight meter. Determine 1)The capacitance in uF/km without effect of ground 2)The capacitance in uF/km with effect of ground
A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4 cm, the distance between the conductors is three and half meters and the height above ground is eight 1-The capacitance in uF/km without effect of ground is 2-The capacitance in pF/km with effect of ground is
The VSWR on an 50-Ohm transmission line is 5. The distance between successive voltageminima is 80 cm while the distance from the load to the first minimum is 30 cm. What are thereflection coefficient and load impedance
The capacitance of a single phase two-wire transmission line depends on: Select one: a. All the above O b. the material of cables c. the radius of cables d. the distance between the cables O e. None of above
Q-7 b, A transmission line has equal voltages at the two ends maintained constant by two sources a third source is to be provided to maintain constant voltage equal to the end voltages either at the mid-point or 75% of distance from the sending end then the maximum power transfer capabilities from sending end in original case and the other two cases will be in the ratio?
19- Noise due to inductive coupling can be reduced by twisting the wires carrying a signal. True False
Q2. Explain how you would determine the primary and secondary constants of transmission by impedance measurements. Also, explain how the velocity of propagation and attenuation constant can be experimentally determined.
b) If quantity A is PATAT with TC of 2mV/C, and quantity B is CTAT with TC of -1mVrC, then determine the following quantities if they are PTAT or CTAT 1. 1/A 2. 1/B 3. A+ 5°B
Ideally, a dc load line is a straight line drawn on collector characteristic curves between which of the following? Please select one: a. Q Point and shear b. Q Point and saturation c. V_CE (interrupt) and I_C (sat) d. I_b = 0 and I_B = I_C/ß_DC
b) A 6052 characteristic impedance transmission line is fed by a DC source of 100V with an internal resistance of 4002. The line is 200m long and has a dielectric constant of 2.25. The load impedance is 12002. Calculate: i. The load reflection coefficient. ii. The source reflection coefficient. iii. What is the voltage at the source terminals just before AND just after 2us?
Deficiency in transmission is caused by attenuation, distortion, and noise. What's the solution, and how can we make things better?
1) the value of IN is?/2) the value of ZL for maximum power transfer?