Q1: Choose the correct answer for the following: 1- While selecting the location of an intake for collecting surface water, the factor considered, is a-The intake point should be near as far as possible to the treatment plant b-The intake point should be in purer zone of the water source c-The intake point should be upstream of the point of disposal of waste water d-The intake point in meandering rivers should be on concave banks e-All the above 2- A centrifugal pump is required to be primed (checked for suitable location) before starting if it is located at higher level than water level of reservoir b-at lower level than water level of reservoir c- both (a) and (b) d- neither (a) nor (b). v² 3-The formula h₁ = f for the head loss in conduits is generally known as 2g a- Hazen-William's formula b- Manning's formula Darcy-Weisbach formula d- Nikuradse formula.

Q1: Choose the correct answer for the following: 1- While selecting the location of an intake for collecting surface water, the factor considered, is a-The intake point should be near as far as possible to the treatment plant b-The intake point should be in purer zone of the water source c-The intake point should be upstream of the point of disposal of waste water d-The intake point in meandering rivers should be on concave banks e-All the above 2- A centrifugal pump is required to be primed (checked for suitable location) before starting if it is located at higher level than water level of reservoir b-at lower level than water level of reservoir c- both (a) and (b) d- neither (a) nor (b). v² 3-The formula h₁ = f for the head loss in conduits is generally known as 2g a- Hazen-William's formula b- Manning's formula Darcy-Weisbach formula d- Nikuradse formula.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Irrigation and drainage, i need solutions in 15 minutes please. MCQ/For the given data below find the sprinklers system capacity Q (L/sec) Depth of irrigation to be applied = 6 cm Area = 9 hectares (300m× 300m) Peak water requirement= 6.7 mm/day Overall irrigation efficiency =80% Operation hours= 16 hrs . A-16.51 L/sec B-14.68 L/sec C-12.32 L/sec D-11.21 L/sec
Irrigation and drainage, i need solutions in 10 minutes please. MCQ/For the channel shown in the figure below the value of the free board F is * A-10 cm B-20 cm C- 30 cm D-15 cm
Given concepts of water quality: Some of the more important general water quality parameters can be listed as (a), (b), and (c). Solids present in water can be evaluated through size exclusion by using a glass fiber and removing the water from each fraction in an oven at 103 °C. Once dried, the solids left behind can be weighed and three subcategories of solids can be determined: three categories can be further subdivided into furnace) and (d), (e), and (f) all (g) (lost during ignition at 550 °C in the (h) (remain in the dish after ignition at 550 °C). All terms are listed in the singular (solids is not a valid answer for a, b or c), there are no acronyms, or compounded terms. Allare single words. a) ; b) d) e) : e) ; f) ; h)
Using the information below, select the correct answers below: CiAna 360 Discharge: a. O b. O C. O d. 5.52 m³/s 2.52 m³/s 31.2 m³/s 37.8 m³/s Q C = 0.60 A (ha) = 70 Time of concentration, Tc(mins) = 0.02 L0.77 S-0.385 Length of travel = 8000m Elevation difference = 25m Time to the peak, Tp = 0.7Tc 1=984Tp-0.623 h = 1 m
Design the approximate dimensions of a set of two rapid gravity filters for treating water required for a population of 50000, the rate of supply being 18 // d/person. The filters are rotated to work 5000 //hr/m². Assume maximum daily demand to be 1.8 times the average daily demand.
1. Prepare a neat sketch of the dissolved oxygen concentration profile downstream of a wastewater treatment plant discharge and label the dissolved oxygen saturation (Csat), the initial dissolved oxygen concantration (Co), the initial dissolved oxygen deficit (Do), the critical travel time (t*crit), the critical deficit (Derit) and the minimum dissolved oxygen concentration (Cmin). O See pdf O Unsure Check
1.5h Q6: The figure represents a homogeneous earth dam with a horizontal filter. The construction cost per certain possible height (H) of this dam at a given site has been estimated and tabulated below. The storage capacity for all these heights is also given. Dam height (H) (m) 5 15 20 25 30 Construction cost (Million ID) 500 10 800 1100 1500 2200 3100 210 340 440 550 590 Storage capacity (Million m3) 100 The characteristics related to the reservoir upstream of the earth dam are: - - The wind velocity (V) = 50 Km/hr - A straight length of water expanse (F) = 35 Km Find the coordinates of the top seepage line (Phreatic surface). 2.5 2.5m 35 4100 680
B) Answer by True or False for the following statements: 1-Paint shops have extra hazard. 2-The nozzle of hose reels of firefighting system of buildings must reach a height of 10 m. 3-Gutters are usually used with horizontal surfaces. 4-The direct method of water supply of buildings is usually reduced the water pressure of the adjacent buildings. 5-Surface water doesn't get easily pollution.
1. Question Number (1) Wastewater Engineering Civil Engineering State the function of manholes and list down the criteria to insert a manhole along the sewerage network.
Q71 Put a circle around the correct ANSWER Evapo-Transpiration is denoted by a) ET b)PT 2/ Evapo-Transpiration means: a) Evaporation + Transpiration 33/Dimensions of Evapo-Transpiration are: a) (m of water/day) b) (m of water/s) c) (m of water/year) Irrigation Cycle le can be calculated by the following formula: a) (dw)A/ET b) (dw)d/ET c) (dw)A/(dw)d 5) Units of Ic are: a) (day/Irrigation) b) (hr/Irrigation) c) (s/Irrigation) ) Porosity of Porous Soil n can be calculated by: a) n= {1-(G/Gs)}x 100 b) n = {1- (Gs/G)} x 100 c) n = {(G/Gs) - 1} 7) Moisture content of porous soil at its saturation condition (wv) s% can be calculated by the following formula: (wv) s%=n% b) (wv) s% = 0.5 n% c) (wv)s% = 2 n% 8) Groundwater flow in Subsurface Tile Drain occurs : a) under effect of pressure b) under effect of gravity 29) Cross-sectional area of Subsurface Tile Drain is: c) TE b) Transpiration c) Evaporation a) less than the cross-sectional area of secondary open drain. b) greater than the…
Wastewater discharges from two businesses were sampled. The BOD concentrations from Company “A” and Company “B” were 400 mg/L and 250 mg/L within DO concentrations 2.5 mg/L and 6.2 mg/L, respectively. Which company discharge would cause the greatest reduction in Nitrogen concentration (nitrification) in the body of water the discharge was flowing into? Group of answer choices B A and B None of these A
1) Chlorine contact tank (Wastewater Treatment) An activated sludge plant has a design flow (average daily flow) of 11 MGD. Determine dimensions of chlorine contact tank. The design parameters: use 1 tank. depth = 10 ft, rectangular tank: L = 4 W detention time = 15 min (based on maximum hourly flow, Q = 3 x average flow rate) I have an answer for this problem however im confussed on it. I posted is an image of the first step (solving for V) Where does the17.02 come from. I understand the (3)(11)(15) and (60) but where does the 17.02 come from?? Image 2 for problem 2 2) Chlorine contact tank (Wastewater Treatment) An activated sludge plant has a design flow (average daily flow) of 11 MGD. Determine dimensions of chlorine contact tank. The design parameters: use 1 tank. depth = 10 ft, rectangular tank: L = 4 W detention time = 15 min (based on maximum hourly flow, Q = 3 x average flow rate) I have an answer for this problem however im confussed on it. I posted is an image of…