Q1) A periodic baseband signal is modulated using normal AM system. The periods of the positive and the negative portions of the baseband signal are equal. The function of positive portion of the baseband signal is f(t)=t2 while the negative portion is of rectangular shape. If the units of the signal are volts and the maximum instantaneous power is 12W while the total signal cycle time is 12Sec, calculate the minimum instantaneous power and the average power of the modulated signal.

Q1) A periodic baseband signal is modulated using normal AM system. The periods of the positive and the negative portions of the baseband signal are equal. The function of positive portion of the baseband signal is f(t)=t2 while the negative portion is of rectangular shape. If the units of the signal are volts and the maximum instantaneous power is 12W while the total signal cycle time is 12Sec, calculate the minimum instantaneous power and the average power of the modulated signal.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

42 Modulation is dune in A. Tramamitter Radio veceiver C. Between transmitter and radio receiver D. None of the above 43. At 100 modulation, the power in each sidehands in AY 50% B. 40% C. 60% D 25% 44 In a TV tranumission, picture is modulated A. Frequency B. Phase CT Amplitade D. None of the above of that of carrier. 45. Given a sine wave modulating signal, PM moduluted wave appears to be frequency modulated by cosine modulating wave. A. True B. False
7-18 Abasehand signal having components from near de to 8 kHz is used to frequency modulate a high-frequency carrier, and the maximum frequency deviation is set al +12 kHz. Delermine the approximatle transmission bandwidth.
2
7-18
Find the average value (DC)
7-22 Abasehand signal with frequency components from near de to 15 kHz frequency modulates a 200-kHz carrier, and the frequency deviation is +3 kHz. The signal is applied as the input to a cascade of two frequency triplers and one frequency doubler. Determine the output (a) center fre- quency, (b) frequency deviation, and (c) deviation ratio.
100 MHz carrier wave has a peak voltage of 5 volts. The carrier is frequency modulated (FM) by a sinusoidal modulating signal or waveform of frequency 2 kHz such that the frequency deviation Af is 75 kHz. The modulated waveform passes through zero and is increasing at t= 0. Determine the expression for the modulated carrier waveform.
EE PLSSSSSS
all 4
The baseband signal modulates a 98 kHz carrier sine wave. Using frequency and amplitude labelling similar to that in Figure 2, sketch the spectrum of the modulated signal using a template, similar to that in Figure 3, for the following modulations: AM with the amplitude of the carrier wave being 20 V DSBSC SSB – the lower sideband SSB – the upper sideband
2. Write an OCTAVE program to plot the signal given below. P- Pmax Sin(21Ift); where Pmax= 10 MW, -60 Hz. %3D Find out time period and verify it with graph. Assume necessary data.