Q.2. A distance AB is observed repeatedly using the same equipment and procedures, and the results, in meters, are listed. 65.401; 65.400; 65.402; 65.396; 65.406; 65.401; 65.396; 65.401; 65.405; 65.404; 65.398 and 65.408 d) Determine the 90% error limits and list the percentage of values that fall within this range, e) Determine the 95% error limits and list the percentage of values that fall within this range.

Q.2. A distance AB is observed repeatedly using the same equipment and procedures, and the results, in meters, are listed. 65.401; 65.400; 65.402; 65.396; 65.406; 65.401; 65.396; 65.401; 65.405; 65.404; 65.398 and 65.408 d) Determine the 90% error limits and list the percentage of values that fall within this range, e) Determine the 95% error limits and list the percentage of values that fall within this range.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Surveying lab
100 and C = 2) A transit with a stadia interval factor of K = at point C on the line between points A and B,and the following stadia readings were observed: 0.381 was set Vertical Hair Readings(m) Position of Rod angle() -7.14 Middle Upper 1.540 1.960 Lower Rod held at A Rod held at B 1.395 1.250 12.28 1.800 1.640 Determine the following: a) length of line AB b)difference in elevation between points A and B
The % error, or E5o = 0.6745(0), is the so called probable error. It establishes limits which the %3D observations should fall half of the time. O 50 O 68 O 95 O 90
How to solve for the Taped Distance and Percentage of Error? Show your step-by-step solution.
Q: Find the distance x in fig below, use the common intensity method as (i= 1200/1+90) x 150 m Sewer 1 Sewer 2 Sewer 3 50 m B Percent Slope Area A 0.44 0.5 B 0.35 2 Sewer D (mm) 1 290 2 410 3 600 0.8 Distance (m) 140 80 d/D 0.3 0.6 V full m/s 1.8 2 1.6
With your pencil, make a dot on the position of your best visual estimate of the centroid of the triangular area. 17.0 13.6 10.2 6.8 3.4 0 0 3.4 (x, y) = (i 6.8 10.2 13.6 Now refer to Sample Problem 5/2 and to Table D/3 and find the exact location of the centroid. 17.0 i )
Q1). The following consecutive readings were taken along a straight line from station (11+090) to station (12+015). The instrument has been changed after third, fifth, eighth and welfth readings. The readings are as bellows: (3 0.68 0.680, 1.455, 1.855, 2.330, 2.885, 3.380, 1.055, 1.680, 2.265, 3.540, 0.835, 0.945, 1.530 and 2.250, first and last point are a bench marks having elevations 50.25m and 50.81 m respectively. 44.8 1- Draw page of level book and enter the above data. 2- Find cleve on of pointe hy height of instrument method. 3- Check your calculation. 4- Determine the gradient of the line joining the first and last point. 5- Determine loop closure and adjust calculated elevations. -5.408
An accidental or compensating error can be eliminated by proper procedures. True False