Q.1) For the figure shown if the tension in cable AC is 21 kN, and 35 m long. Determine (a) the x, y, and z components of the force (CA) exerted by the cable on the support C, (b) the angles 6x, 0y, and 0z defining the direction of that force. 28 m D 20°% 50

Q.1) For the figure shown if the tension in cable AC is 21 kN, and 35 m long. Determine (a) the x, y, and z components of the force (CA) exerted by the cable on the support C, (b) the angles 6x, 0y, and 0z defining the direction of that force. 28 m D 20°% 50

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter5: Displacement And Force In Two Dimensions

Section: Chapter Questions

Problem 82A

See similar textbooks

Related questions

Q: The 50-kg pipe is supported at A by a system of five cords. Determine the force in the cable AB for…

A: Force balance in vertical direction: Tab sin600 = mg= 50x9.8 = 490 Tab= 565.803

Q: A mass, m is hung as shown in Fig. Q2. Maximum tension in each cable AB and AC are 250N and 300N…

Q: What is the resultant force of X=20N, 10° N of E and Y=30N, 30° N of W? By Using the parallelogram…

A: Given : X = 20 N 10° N of E Y = 30 N 30° N of W

Q: What is the magnitude and direction of the single force applied to make the two concurrent forces…

A: A set of forces whose lines of action come through a common point iscalled concurrent forces.…

Q: H.W. Determine the horizontal force P required to cause slippage to occur. The friction coefficients…

A: The normal forces, which are in they-direction, may be determined without reference to the friction…

Q: Determine the magnitude of the forces acting in the wire P and the strut Q. 1.5 m 2.0 m 100N

Q: A 1,425 N dowel is held in place by a light cord at an angle e = 32.5° to the horizontal as shown in…

Q: The guy wires AB and AC are attached to the top of the transmission tower. The tension in cable AB…

Q: OB Zero Lütfen birini seç. A.S 2mp,IB 2P.IB D.

Q: 2. The flower pot shown in Fig. Q2 is supported by three wires. The flower pot has a mass of 50 kg.…

Q: 4.36 Calculate the reaction at each support for the truss shown. Neglect the weight of the truss.…

A: In the given diagram support reactions will be, For pin support at A, there will be one horizontal…

Q: 4] The members of a truss are pin connected at joint O. Determine the magnitude of F, and its angle…

Q: Figure P-313 represents the concurrent force system acting at a joint of a bridge truss. Determine…

A: In equilibrium conditions, the sum of the net forces acting on a body is zero. Forces are vector…

Q: If the beam attached to a hinge is 4 meters long and weighs 600 Newtons, and the sign weighs 400…

Q: Determine the resultant R of the two forces applied to the bracket. Write R in terms of unit vectors…

A: Given Determine the resultant R of the two forces applied to the bracket. Write in terms of unit…

Q: The 537 kg uniform beam is subjected to the three external loads shown. Compute the force reaction…

A: by draw free body diagram we calculate the net force upon point O and find the value of its .

Q: 2/21 Determine the resultant R of the two forces applied to the bracket. Write R in terms of unit…

Q: The guy wires AB and AC are attached to the top of the transmission tower. The tension in cable AB…

A: Draw the free-body diagram of the system.

Q: 2.2 Three forces are acting on the eyebolt as shown. All forces intersect at a common point O.…

A: Free body diagram is-

Q: Express and identify the resultant of the two forces and one couple shown acting on the shaft angled…

A: Torque due to a force couple is given as Torque,τ =(r2→-r1→)×F→ r2 →and r1→ are position vectors of…

Q: Determine the forces in cables AC and AB needed to hold the 20kg ball D in equilibrium. Take d = 1 m…

Q: a 10 kg sphere is supported on a frictionless plane inclined at angle u = 45° from the horizontal.…

A: Mass of the sphere,

Q: The guy wires AB and AC are attached to the top of the transmission tower. The tension in cable AB…

A: Given:- TAB = 8.2 kN Lets O be the bottom of the tower. Now lets find ∠BAO=θ1 and ∠0AC=θ2 first:-…

Q: Two rods and one cable are attached to the supports at O. If two of the forces are as shown,…

Q: Cable AB passes over the small ideal pulley C without a change in its tension. What length of cable…

Q: The following forces pull on a ring along the same plane (i.e. coplanar): 200 N at 30° E of N, 500 N…

A: Given Coplanar forces 200 N at 30°E of N 500 N at 10°N of E…

Q: The guy wires AB and AC are attached to the top of the transmission tower. The tension in cable AB…

Q: In the figure, a 87 kg sphere is supported on a frictionless plane inclined at angle 0 = 48° from…

Q: Ex. 1.4 The body on the 30 deg incline below is acted upon by a force P inclined at 20 deg with the…

A: The given figure can be represented as,

Q: Determine the resultant R (single equivalent force) of the three forces acting on the simple truss.…

Q: 2/27 The guy cables AB and AC are attached to the top of the transmission tower. The tension in…

A: The tension in the cable AC is given as, The tower’s free-body diagram is shown below. Here, R…

Q: A person with 100kg mass is standing erect on the tip of both feet. Find the contact force Cexerted…

A: Given that :m=100 kgg=9.8 m/s2θ=37°

Q: The 55-kg cylinder is suspended from a clamping collar at C which can be positioned at any…

A: According to Newton's second law Net force =mass×acceleration When the system is in equilibrium,…

Q: The 507 kg uniform beam is subjected to the three external loads shown. Compute the force reaction…

A: Suppose the Rx and Ry are the force reactions at point O. W = mg = 4.97 kN (at 2.4 m from O)…

Q: The flanged steel cantilever beam with riveted bracket is subjected to the couple and two forces…

Q: In checking a recently installed fencepost for adequacy of the ground support, a person exerts a…

A: Given: A Person exerts a force on the top of the post is

Q: A rod is laying on top on two poles. The rod is uniform and has a length of 3.22 m. The left pole is…

Q: The three forces acting on the pole are equivalent to a single force R. Determine (a) the magnitude…

Q: A 10 N ball is supported by an incline and a cable making an angle a with the vertical direction.…

Q: There is this ladder with a length L = 3.5 m and mass M = 15 kg leans against a smooth vertical…

A: Given data: Length of ladder is, L=3.5 m. Mass of ladder is, M=15 kg. Coefficient of friction…

Q: weight angle o above the rod. The other end rests on a small frictionless support and presses into a…

A: given:weight of rod, w = 74.0 Nlength L = 2.85 mtension in the cable = Langle = 340

Q: A uniform bar weinghing 60N has a lenght of 4M and is supported at its end by string. A load W=200N…

Q: 1,175 N dowel is held in place by a light cord at an angle ? = 31.0° to the horizontal as shown in…

A: θ=31φ=59

Q: The 50-kg pipe is supported at A by a system of five cords. Determine the force in the cable AB for…

Q: Cable AB passes over the small ideal pulley C without a change in its tension. What length of cable…

Q: Five equal forces of 10 N are applied at a point. If the angle between them is equal, what is the…

A: θsep=360°5=72° Draw the rough diagram as per the given data.

Q: The homogeneous 18-kg pulley is attached to the bar ABC with a pin at B. The mass of the bar is…

A: Angle at C,

Q: The 58-kg cylinder is suspended from a clamping collar at C which can be positioned at any…

Q: A uniform plank of length 2.00 m and mass 32.0 kg is supported by three ropes, as indicated by the…

Q: The guy wires AB and AC are attached to the top of the transmission tower. The tension in cable AB…

Concept explainers

Torque

Torque is the rotational equivalent of linear force in physics and mechanics. Based on the course of study, it is also known as the moment of force, rotational force, or turning effect.

Question

Q.1) For the figure shown if the tension in cable AC
is 21 kN, and 35 m long. Determine (a) the x, y, and
z components of the force (CA) exerted by the cable
on the support C, (b) the angles 0x, 0y, and 0z
defining the direction of that force.
28 m
20°
50

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1 Given

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

The forces are in static equilibrium. The 140 lb force is directed along the x-axis and the 300 lb force is directed along the negative z- axis. Determine the magnitude of the unknown force, R. Z X R Ox лог 140lb A (-50, 80, 160) lb By 300 lb у
A cable stretched between the fixed supports A and B is under a tension T of 2.3 kN. Express the tension as a vector using the unit vectors i and j, first, as a force TA acting on A and second, as a force Tg acting on B. 760 mm Α' 490 mm Answers: TA-i TB-i i+ i i+ i B j) kN j) kN
16. ao The drawing shows a rectangular piece of wood. The forces applied to corners B and D have the same magnitude of 12 N and are directed parallel to the long and short sides of the rectangle. The long side of the rectangle is twice as long as the short side. An axis of ro- tation is shown perpendicular to the plane of the rectangle at its center. A third force (not shown in the drawing) is applied to cor- ner A, directed along the short side of the rectangle (either toward B or away from B), such that the piece of wood is at equilib- rium. Find the magnitude and direction of the force applied to corner A. A D Axis Problem 16
Q1 Q1\ ABD consists Isosceles triangle. The AB and AD help support pole AC. Known that the tension in AB is double AD tension and the distance between A and C is 0.7 of BD. Determine the magnitude of these tensions if the value of resultant forces is 120 Ib. B.
400 N 30° 5. If the tension in the cable is 400 N, determine the magnitude and direction of the resultant force acting on the pulley. This angle is the same angle 0 of line AB on the tailboard block. 400 N
Assuming that force in the boom AC is directed along the boom, find tension force in cable BC and the force in the boom AC. B 200 lb 55° 60° 15° 30° 300 lb А
SAQ 1 1.2 m D C 80 kN m An 80-kn.m couple shown in the plate is caused by a pair of parallel forces of magnitude F (not shown). 1.6 m Determine: a) the smallest possible value of F, and b) the value of F if the forces act at points A and C and are parallel to the dashed line shown at A. A В 60°
A sign is held by the following beam and cable. The sign has a mass of 11 kg. The beam has a length of 1.11 m and a total mass of 1.1 kg. What is the tension in the cable, if theta; = 60 degrees? Express the tension in Newtons. Ꮎ L Sign
SAQ 1 1.2 m D C An 80-kn'm couple shown in the plate is caused by a pair of parallel forces of magnitude F (not shown). Determine: 80 kN m a) the smallest possible value of F, and 1.6 m b) the value of F if the forces act at points A and C and are parallel to the dashed line shown at A. A В 60°
40 4N 65° 6N B (a) Calculate the x- and y- componeni of force A. (b) Calculate the x- and y- component of force B. (c) Calculate the x- and y- component of the total force A+B. (d) What is the magnitude of the total force | A+B|? (e) What is the angle between the total force and the +x axis?
Find the resultant of force Y 390 Ib MATHalino.com 12 30 1 1 300 lb 722 Ib Figure P-265
A cylinder having a mass of 250 kg is to be supported by the cord which wraps over the pipe. Determine the largest vertical force F that can be applied to the cord without moving the cylinder. The cord passes once over the pipe, B = 180° Take us 0.2.