Q: BenZoic acid in a solution with toliene is to be extra using water as solvent initially containing 0.01% of benzoic acid. The benzoic acid concentration in the toluene feed is 2% by weight and 95% of the benzoic acid is to be recovered in the water phase. A counter current mixer - settler installation equivalent to five theoretical stages is available. If the solvents may be regarded as immiscible, what is ratio of water to toluene should be employed, and what is the composition of the final extract phase? in the following cases: (A) The equilibrium data are: X (10-3) Y (10-4) 6. 10 14 18 22 26 2.9 7.2 10.1 12.4 14.0 15.6 16.8 Where: X is the weight of benzoic acid / weight of toluene. Y is the weight of benzoic acid /weight of water.

Q: BenZoic acid in a solution with toliene is to be extra using water as solvent initially containing 0.01% of benzoic acid. The benzoic acid concentration in the toluene feed is 2% by weight and 95% of the benzoic acid is to be recovered in the water phase. A counter current mixer - settler installation equivalent to five theoretical stages is available. If the solvents may be regarded as immiscible, what is ratio of water to toluene should be employed, and what is the composition of the final extract phase? in the following cases: (A) The equilibrium data are: X (10-3) Y (10-4) 6. 10 14 18 22 26 2.9 7.2 10.1 12.4 14.0 15.6 16.8 Where: X is the weight of benzoic acid / weight of toluene. Y is the weight of benzoic acid /weight of water.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

(a) Based on the tabulated data, prove that the distribution of benzoic acid in water and and benzene follows C2water/Cbenzene=K. Cite the possible relations and assumptions. (b) Determine the moles of benzoic acid which may be extracted from 150 cc of a 0.3 molar aqueous solution 15 cc of benzene at 20oC by (1) single extraction and by (2) five extractions.
Neutralize of acetic acid and sodium hydroxide 50ml of CH3COOH set at 1 M 50ml of NaOH set at 1 M
A water containing 50 mg/L of phosphate (PO,") is flowing in an open channel at a volumetric flow rate (Q) of 2 MGD (million gallons per day). (a) What is the concentration of phosphate expressed in (i) mg/L as PO, --P, (ii) mM as PO., and (iii) mM as PO, P. (b) Find the mass flow rate (S) of phosphate through any section perpendicular to the direction of flow in the open channel expressed in lb/day? Given: Atomic weights: P= 31 g/mole, O = 16 g/mole, 1 gallon = 3.785 L, 1 kg = 2.204 Ib. %3D
MN.51.
i need the answer quickly
Differential Distillation A 100 gmole liquid mixture containing 50 mole% n-heptane and 50 mole% n-octane at is to be subjected to a differential distillation at atmospheric pressure. The process is stopped when the mole fraction of MVC (n-heptane) in the still reaches 0.33. Determine the amount of composited distillate collected and its mole fraction a) The data given as: X00.012 0.039 0.097 0.157 0.284 0.312 0.487 0.510 0.655 y 0 0.025 0.078 0.184 0.279 0.459 0.492 0.674 0.698 0.810
4.21. A dilute aqueous solution of H SO, (Solution A) is to be mixed with a solution containing 90.0 wt% H2SO, (Solution B) to produce a 75.0 wt% solution (Solution C). Solution A Flowmeter A Analyzer Solution C 75% H,S0, Solution B 90% H,SO. Flowmeter B MIXER The flow rate and concentration of Solution A change periodically, so that it is necessary to adjust the flow rate of Solution B to keep the product H,SO, concentration constant. Flowmeters A and B have linear calibration plots of mass flow rate (in) versus meter reading (R), which pass through the following points: Flowmeter A: mA 150 lb/h, RA 25 %3D %3D 500 lbm/h, RA 70 %3D %3D Flowmeter B: mp = 200 lbm/h, Ry = 20 800 lbm/h, Rg 60 %3D The analyzer calibration is a straight line on a semilog plot of %H;SO4(x) on a logarithmic scale versus meter reading (R,) on a linear scale. The line passes through the points (x and (x (a) Calculate the flow rate of Solution B needed to process 300 lb/h of 55% H,SO, (Solution A), and the…
Calculate the solubility at 25 °C of PbCO3 in pure water and in a 0.0100M Pb(NO3), solution. You'll find Ksp data in the ALEKS Data tab. Round both of your answers to 2 significant digits. 0 // solubility in pure water: x10 solubility in 0.0100 M Pb(NO3)2 0-/- solution: L X 09 00 X S ?
A sodium hydroxide solution is to be standardized using KHP (99.5% purity, MW = 204.22). A 1.500-g KHP dissolved in water required 14.84 ml of NaOH solution for the phenolphthalein endpoint. Calculate the molarity of the NaOH solution.
Find and show work for Moles of KMNO4- Delivered at Mass%oxalate
thos.learn.cloudflare.blackboardcdn.com/5f7d95ffb29e2/2503155?X-BIlackboard-Expiration=D1619017200000&X-B.. E Q * * Cheap Instagra. y! Canvas - Yahoo Sea.. 1 / 2 114% 3. The AGO for the reaction Citrate → Isocitrate is +6.64 kJmol-1. The AGo' for the reaction Isocitrate → a-Ketoglutarate is -267 kJmol-1. Calculate the AGo' for the conversion of citrate to a-ketoglutarate? 1 |Page Is that reaction exergonic or endergonic, and why? 10:17 PM 4/21/2021 F5 F6 & F7 FB F9 F10 F11 F12 Backspace Delete 7 9. Y { 5
Full solution pls