Problem Number 2: Given the figure below and considering an upward flow, forthe sand the following are its properties e=0.52 and Gs = 2.67. a) Calculate and illustrate through a diagram the 6,u and 6' of the points A, & B.10 Points b) what is the upward seepage per unit volume of soil? 15m 2 m Valve (open) Inflow Sand

Problem Number 2: Given the figure below and considering an upward flow, forthe sand the following are its properties e=0.52 and Gs = 2.67. a) Calculate and illustrate through a diagram the 6,u and 6' of the points A, & B.10 Points b) what is the upward seepage per unit volume of soil? 15m 2 m Valve (open) Inflow Sand

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter8: Stresses In A Soil Mass

Section: Chapter Questions

Problem 8.13P

See similar textbooks

Similar questions

Question 16 The results of a constant head permeability test for a fine sand are as follows Diameter of the sample = 33 cm Length of sample 55 cm Constant head difference =74 cm Time of collection 580 secs Weight of water collected = 382 grams Find the seepage velocity in cm/min. if the void ratio is 0 38. Round off to four decimal places. SUS WE R
PROBLEM 2 Result from the liquid limit and plastic limit tests conducted on a soil are given below. Liquid limit tests: Number of Blows, N Moisture Content, % 15 32.2 19 29.8 23 26.6 30 20.2 Plastc limit tests: PL 15.2% Draw the flow curve and obtain the liquid limit. What is the plasticity index of the soil? а. b.
Given the figure below and considering a downward flow, forthe sand the following are its properties e=0.52 and Gs = 2.67, h= 0.650 and H1 = 1.20 m; H2 = 3.50 m,z = 1.50 m. a) Calculate and illustrate through a diagram the 6,u and 6' of the points C& B. Place your Calculated Values here: Inflow Point 6 6' (歲)。 Valve (open) B Outflow
In the soil profile shown below, the clay is normally consolidated and H,=9m, H2=5m, H3=3m. The depth of water table is then decreased so that H;=2m, H2=12m, H3=3m. a) Calculate the overconsolidation ratio (OCR) at this stage. When a surcharge of Ao = 180 kPa applied to the surface. b) Estimate the primary consolidation settlement of the clay layer. c) Estimate the degree of consolidation will be after 40 days? d) How many days would it take for 90% consolidation? Soil characteristics are as follows (use appropriate relations from the Appendix, 9.81 kN/m³): Yw = Sand: e = 0.56; G, = 2.6 Clay: LL = 63; e = 0.83; G, = 2.77; C, = - Cc; Cy = 6.66 × 10-4cm² /s %3D Ao H1 Sand Groundwater table Sand H2 Clay. Void ratio = e H3 Normally consolidated Sand
Qus - If the void ratio and discharge velocity for soil is 0.5 and 6 * 10^-7 * m / s respectively, what is the value of seepage velocity (m/s)?
Example 1 A sand come test has been performed in a competed fill made with the soil described in 21 example 6.1 20 Ydmax 19.0 kN/m³ 19 95% (Yd,max) 18 17 =18.1 kN/m³ S=100% Wo -11.8% 16 0 5 7% 10 w (%) 15 16% 20 25 Initial mass of sand cone apparatus = 5.912 kg Final mass of sand cone apparatus = 2.378 kg Mass of soil recovered from hole = 2.883 kg Moisture content of soil from hole = 7.0% Density of sand = 1300 kg/m³ Volume of cone below valve = 1.114 x 10-3 m³
A soil has a discharge and a void ratio of is. A B C D 18x10-7 m/sec 12×10-7 m/sec 24×10 m/sec 36x107 m/sec velocity of 6×10¯7 m/sec Its .50. seepage velocity
Homework 1-Results from liquid and plastic limit tests conducted on a soil are Moisture given below. Plastic limit tests: PL 13.4% a) Draw the flow curve and obtain the liquid limit. b) What is the plasticity index of the soil? C) Determine the liquidity index of the soil if Win situ = 32% Number of blows, N content (%) 39.2 %3D 15 34.5 22 26 31.2 29.0 %3D 29 U.S. sieve no. Mass of soil retained 1- The followi
4. With two cases shown in the following figure: Plot pore pressure with depth for the soils if hydraulic conductivity of soils K1 = 5 x K2. a- b- flow through a unit thickness of the cross-section if K1 = 5 x 10$ (f/s) and K2 = 1 x 10$ (f/s). Estimate the rate of seepage (q) per linear foot of cross-section, i.e. calculate the rate of C- Plot flow net for 2 cases. -z (ft) z (ft) Water Water 3 ft 3 ft Soil 1 1.5 ft Soll 1 Sol 2 3 ft 3 ft 3 ft 1.5 ft Soil 2 Datum psf Datum psf porous stone porous stone 3 ft 1.5 ft 1.5 ft Case 1 Case 2
The section through a long cofferdam is shown below, the coefficient of permeability of the soil being 6x10-8 m/s. Determine the quantity of seepage entering the cofferdam. 5.50 m I 0 1 2 3 4 5 As = 0.70 ml +cl 10 B ax 15 m
For a given soil, derive the following relation by drawing the three-phase diagram: Y: = Gs yw (1 - n) (1 + w)
Example 5.4 The clay layer below was subjected to a surcharge that would a total settlement of 10 inches. If C, = 50ft²/yr, then determine the amount of time required to produce 5 inches of settlement for the two cases below. Sand Sand Clay Har = h/2 Clay Case A 50' Case B 50' h Har Sand Bedrock