Answered: Problem 6. The 1.2 m-diameter log with…

Problem 6. The 1.2 m-diameter log with specific gravity of 0.8 is 3.0 m long into the paper. The log dams the water as shown. Compute the net vertical and horizontal reactions at point C.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: (a) The upstream face of a dam is curved and is part of a circle of radius 10 m. and holds back…

Q: A swimming poop has a width of 4m and a side profile as shown. Determine the magnitude that the…

Q: The dam shown is a quarter circle 23 m. wide into the paper. Determine the total hydrostatic force…

Q: Figure below is a representation of the Altus gravity dam in Oklahoma. Find the magnitudes and…

Q: Problem I. In a road construction along the CaviteX expressway, a wedge of weight (W; =552 N) is…

Q: h 1 B b H 2 H = 25ft h = 18 ft b = 8 ft B = 30 ft 8 = 72.4 lb per cu. ft Sconc= 150 lb per cu. ft 1.…

A: Height of the dam, H = 25 ft Height of the water level = 18 ft b = 8 ft B=30 ft Density of water, δw…

Q: Find

A: The weight acts at half of width from toe based on the concept of centre of gravity. 15/2 = 7.5m…

Q: Q-1: Water is flowing through a soil as shown in the figure. Determine the elevation, pressure, and…

Q: Answer the following: a. hydrostatic force acting on a wall b. weight of dam if the unit weight of…

A: Width of the dam = 14.8 mHeight of the dam = 23.2 mDepth of the water = 20.4 mGiven no hydrostatic…

Q: 4. A V - notch weir is located at one end of a tank having a horizontal square section 12m x 12m. If…

Q: A laminar flow flows around the plate as shown in the figure. puox Recr. = 5x105 showing the…

A: Given data:- Critical Reynolds number showing the transition from laminar flow to turbulent flow;…

Q: As part of a flow and pressure analySIs, a rectangular pipe loop with a length m and width of 300 m…

A: Equivalent pipe means a pipe which can replace existing compound pipe while carrying same discharge…

Q: m Water is flowing through a horizontal pipe of diameter 150mm at a velocity of 2-. A circular solid…

A: Given:Pipe diameter, D = 150 mm = 0.15 mVelocity of flow, V = 2 m/sDiameter of solid plate, d = 120…

Q: pls answer asap i'll rate

A: The problem is about designing an open channel to carry a certain amount of water. The channel is…

Q: a) Determine the hydrostatic force (in kips) acting on the dam. b) Determine the moment of inertia…

A: We will solve this question in step no. 2

Q: B 12 m No. 3 Please note, this is an Equilibrium problem. 8 m 10 m 1.2 m A O C 200kg P 2 m SAMPLE…

A: m=200kgtwo cables AB and ACFINDmagnitude of P and the tension in each cable

Q: Given: Figure Find: External reactions in x and y directions needed to hold fixed vane. Solution:…

Q: If the head loss in an 8 km long cast iron pipe carrying water at a rate of 1.42 m^3/s is not to…

Q: Determine the horizontal component of the total hydrostatic force (kN) the water exerts on the gate…

A: The horizontal force on the curved surface is equal to the force on the projection of curved surface…

Q: The submerged sector gate AB shown in the figure is 1/9 of a circle of radius 4 m. The length of the…

A: Radius of the circle = 4mLenght = 10m19th part of circle = 360×19⇒ θ = 40°

Q: The following figure shows a flow net for the flow under a dam with a cutoff wall. Drawn to scale.…

A: Let us first calculate the uplift pressure at A,B,C,D and E points uplift pressure at these points…

Q: A free vortex is defined by its stream function = (-150 In r) m²/s, where r is in meters. (Figure 1)…

A: Given : ψ=(-150lnr) m2s Determine the velocity of particle at r=4m Determine the gage pressure at…

Q: In 1957 H. Görtler proposed the adverse gradient test cases U =- U. (1 + x/L)" and computed…

A: Given Data: Stream velocity n=1 xsep/L=0.159 θ0=0

Q: A) what is the number of drop of the flownet? B) What is the flow of water in the unit of cm^2/min?…

A: The given figure shows a concrete dam on-site and its corresponding flow net.The coefficient of…

Q: A curved surface was submerged in water as shown. Calculate the horizontal component of the…

Q: A cross-section of a concrete gravity dam is shown in figure. Analyze the stability of block A for…

A: Compressive strength is the capacity of a structure to withstand loads tending to decrease the size,…

Q: A rectangular irrigation canal 3 m wide carries water with a discharge of 6 m^3/s. A rectangular…

A: According to given dataThe height of the rectangular weir if it is suppressed will be H= 1.05m…

Q: Please convert 3.4 psi gage pressure to absolute pressure in Sl unit. 161.2 kPa 124.7 kPa 137.8 kPa…

A: Given:3.4 psi gage pressureRequired:Absolute pressure in SI unit

Q: Problem 6. The 1.2 m - diameter log with specific gravity of 0.8 is 3.0 m long into the paper. The…

Q: For the concrete dam shown, where b=0.80m, H= 8m and h3D7m. Unit weight of concrete is 24kN/m3.…

Q: 1.GIVEN: The vessel is initially full. Do = 200 mm %3D C = 0.8 REQUIRED: Time to empty the vessel.…

Q: a new cast iron pipe must carry 1.2m^3/s at a head loss of 5m per km length of pipe.Compute the…

Q: Problem 6. The 1.2 m - diameter log with specific gravity of 0.8 is 3.0 m long into the paper. The…

Q: A 150m-wide (into the page) concrete dam is used to hold back a 25m-deep water reservoir as shown.…

A: Consider the given data

Q: The canal shown below runs 40 m into the paper. Assume unit weight of H2O is 9.79 kN/ m^3. Determine…

A: Determine the horizontal component of the hydrostatic force against the quarter circle wall

Q: Equation of Motion (EOM) Along Streamline (2D). What pressure gradient along a streamline, dp/ds,…

A: Introduction: Streamline Flow: Streamline flow (also called flow) is a type of fluid flow in which…

Q: resultant force R exerted on the gate by the water pressure i

Q: Q3) A triangular canal cariying a discharge of 2 m'/s has a step of height 0.3m as shown in the of…

Q: 3. The figure is a section of a masonry dam resting on a foundation and subjected to water pressure…

Q: a. Determine the vertical displacement at joint B b. Determine the horizontal displacement at joint…

Q: Given: Figure Find: External reactions in x and y directions needed to hold fixed vane. Solution:…

Q: For the machine analysis problem, a scoop carries 610 kg of load with center of mass at G.…

A: An incompressible fluid is used to transmit the force generated at one point to another. This is the…

Q: For the concrete dam shown below, determine the minimum width in meters of the dam, b, so that it…

Concept explainers

Highway Drainage

Highway drainage is the process of extracting and regulating the excess surface water on the pavement by giving the desired slope. The construction of a highway drain helps to divert the water present on the surface, and sub-grade by the means of slope. Highway drainage systems are a necessary part of smooth functioning of traffic, since the highway drainage systems provide proper disposal of unwanted substances from the highways.

Question

Problem 6. The 1.2 m-diameter log with specific gravity of 0.8 is 3.0 m long into the paper. The log
dams the water as shown. Compute the net vertical and horizontal reactions at point C.
Water
Log
0.6m
+
0.6m
Water

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

The figure shown is a dewatering plan to build the foundations of an office building below the water table without the sheet-piling. Assume that all b = 6 meters and all 1 = 4 meters in all grids of the middle flow channel. Dewatering wells Marshy soils Ah =Sm Excavated site OL Ah = 2m Ah = 2m Ah = 2m Lowered WT a. What is the value of n? b. How many flow channels are in the figure? c. How many potential drops are in the figure? d. The potential drop at area 1 is: e. The potential drop at area 2 is: f. The potential drop at area 3 is: g. The average hydraulic gradient in each net is:
Solve
USING DOUBLE INTEGRATION METHOD Consider 250 mm x 250 mm (bxh) mm section and e = 100000 MPa DETERMINE VERTICAL REACTION AT B Values:A = 9.4 MB = 5.5 MC = 10.6 KN/MD = 33 KN
2-A water well is fully penetrates a confined aquifer, as shown in the figure, the external radius of the gravel pack around the water well is 35cm. The length of well screen is 25m and the well discharge is 0.15m3/s. Assess the validity of Darcy's law for this flow. Jse p=1000 kg/m³, µ =1.14×10-3 pa.s, d=1mm)
(a) The upstream face of a dam is curved and is part of a circle of radius 10 m. and holds back water to a depth of 9 m. Calculate the magnitude and direction of the resultant hydrostatic force per metre length. WL V JA В 10 m 9 m Given: Sin 0 = 9/10 .:. 0 = 64.158° Given: Area of sector CAD = (64.158°% 360°) x a x 10² = 56 m²
A curved surface was submerged in water as shown. Calculate the vertical component of the hydrostatic force on the curved surface. The system is 2m wide into the paper. 5m 60° r = 2m
Assume the reservoir is very large in the figure below. What should be the angle (in degrees) be if each graduation corresponds to 1 lb/ft? gage pressure for PA. Answer only the numerical value in degrees. Assumptions: 1. inclined arm is fitted with 1 in apart 2. SG of fluid = 0.827 PA D = in Reservoir
Dr. Qassem H. Jalut Associate professor Example, The small dam shown in the figure is 8.5 m wide, An equilateral triangular gate (LM) that is 2.4-m in height is located along the lower face (KN) 5o that the apex is at M. Depth of water above the hinge (L) is 4.5 m. Calculate the magnitude and point of application of the force acting on side LM. deill hingecO 4.5 m he K L. fr=YA hc he H+! ونتراحا عن قوائين الربقة 2.4 m 45° hinge 8.5
Question 4. The L-shaped cap in the figure is hinged from point A. Neglecting the weight of the lid, a) Before opening the lid counterclockwise, determine the maximum water height H in symbols. b) If w=4 m (width of the cover perpendicular to the plane of the paper), B=5.77 m and d=6 m, determine the numerical value of H. C) Find the horizontal and vertical components of the hydrostatic force and the resultant force direction with the values given in b B articulation A H
3m W.S 3 10 6m 6m 10 W.S Sm 6m 6m draln 1. A section of a gravity masonry dam is shown in the figure water is flush at the top of the dam upstream and 5m from the ground downstream. Assume hydrostatic uplift to vary uniformly from full hydrostatic pressure from the heel to zero at the drain density of water is 1000kg/m^3. The specific gravity of concrete is 2.4. Determine: a. The location of the resultant force b. Factor of safety against sliding if coefficient of friction is 0.75 c. Factor of safety against overturning d. Stress at the heel and the toe e. Unit horizontal shearing stress at the base f. Factor of safety against overturning neglecting uplift
Pls answer in 3 decimals
A trough is 12m long, 5m wide, and 3m deep. The vertical cross-section of the trough parallel to an end is shaped like an isoceles triangle (with height 3m, and base, on top, of length 5m). The trough is full of water (density 1000kg/m³ and g = 9.8m/s² is the acceleration due to gravity). a) Find the amount of work in joules required to empty the trough by pumping the water over the top. b) Find the amount of work in joules required to empty the trough by pumping the water out of a spout 4m high.