Problem 4 What is the absolute pressure (in kPa) at the center of pipe B (marked by +)? 50 cm 10 cm + B -Y = 10 kN/m³ 3 Y = 20 kN/m³ 50 cm

Q: What is the distance in miles from the principal meridian that describes Range 4 West? Select one: a…

A:

Q: -/ 10 Question 6 of 10 The copper pipe [G = 8,000 ksi] has an outside diameter of 3.125 in. and a…

A:

Q: Nada never does her homework. The verb does is a full verb. Select one: True False

A: Basic concept introduction- full verb- It is called as the main verb and it has its own meaning.…

Q: What is wrong with the picture at right?" (<25 words) YES! Safel NOI Unsafel

A: A picture including of two images where different cases of cylinders were given.

Q: With the measurements in the following table, calculate the soil moisture flux q (cm/day) between…

A:

Q: y 130 mm 30 mm 30 mm -40 mm 40 mm-

A:

Q: Determine the centroid of the shaded area shown, which is bounded bythe X axis and the parabola y? =…

A:

Q: The timber beam in Figure 2 is simply supported at points A and E. The cross-section of the beam…

A: E = 12 GPa Use virtual method to analyze the beam.

Q: What is the x-coordinate, x1, and y-coordinate, y1, of shape 1’s centroid? (Whole semi-circle, do…

A:

Q: (b) A circular cylinder is placed in a uniform flow with its axis perpendicular to the flow…

A: Given- circular cylinderdrag force per unit length = FDflow velocity=Vfluid density=ρfluid…

Q: Figure 8 60 KN 2.6m 30 KM 40 KN 30 KN

A:

Q: Name this force system Question 18 options: Non-planar concurrent…

A: To name the force system.   Coplanar force system, is one in which all the forces lie in the same…

Q: A clockwise couple M = 4.5 N m is resisted by the shaft of the electric motor. (Figure 1) Part A…

A: Given: The moment M is 4.5 N.m. Consider the figure,

Q: ONS B.S. H.I. F.S. LF.S. ELEVATIONS -a 1.24 234.51m 1.11 3.40 4.6 2.8 3.6 2.4 3.21 2.46 1.2 3.2 2.8…

A: Given profile levelling HI = elevation +   BS elevation = HI - FS or IFS given elevation of BM a =…

Q: CEM IV 42.5 N: Define what each word/number/letter is?

A: 1.CEM-  CEM means CEMENT .Cement is the binding material from which concrete is prepared. Cement act…

Q: Distinguish between intermittent system and continuous system of water supply

A: In Intermittent system water supply is divided into several zone and each zone is supplied with…

Q: A frame ABCDE is subjected to forces Po, Pe, and a moment Mcas shown in the Figure below. If Po = 10…

A:

Q: y Yo 6" (Tampe X y

A:

Q: usescale (1/1) draw the front Section view in mides pan and the side Sectional Vien middles pan for…

A: Front Sectional View: The front sectional view is the view of the object done by taking a section…

Q: Using the following notes, what is the elevation of BM,4 Station B.S. F.S HI Elevation BM12 4.64…

A: what is the elevation of BM₁4

Q: Calculate the y-coordinate of the centroid of the shaded area. The triangle is equilateral. -32 107…

A: The given figure is shown below:

Q: (b) Design the Beam B-B for the maximum sagging section only. Your design should consider the…

A: L=4.55 mh=22.2 mt=122 mmDL=3.55 kPaLL= 4.55 kPafck= 25.5 Mpafy=472 MpaTo design- 1) Loads2) Design…

Q: Differentiate force system based on line of action.

A: A force is a push or pull on an object caused by its interaction with another object.

Q: What is ponit of view? What is first point of view and third point of view.

A: The term  Point of view will be referred to who is telling or narrating the story. A story can be…

Q: ccuracy, precision, Systematic and random errors.

A: The concept where the idea of the extent of  closely a measurement or observation comes to measuring…

Q: Calculate external as well as total indeterminacy

A:

Q: what is mercury manometer? own words

A:

Q: continue the last part

A: Data for pump performance curve is given. We need to select which pump combination would work for…

Q: You are a professor of architecture. Show your students where the horizon line and vanishing points…

A:

Q: * To draw an arc angle between two intersecting lines Fillet O Block O Trim Chamfer O If we want to…

A:

Q: 1. Differentiate atmospheric pressure, gauge pressure and absolute pressure. 2. State the stability…

A: Note- Hi! Thank you for the question As per the honor code, We’ll answer the first question since…

Q: Q1: determaine the coordinates of the centeroid of the shaded area 20 40 50 20 40 30 140

A: The polar coordinate system is a method to calculate points in the system location by proper…

Q: A drone is flying in the air at some altitude. The drone is equipped with piezometer that indicates…

A:

Q: classification of rivers

A: Classification of Rivers

Q: 200 mm 200 mm 400 mm

A: Section  Area  x Remarks  ABC A1  = π42002      = 31400 mm2 x1 = D2    = 2002     =100 mm   AEF…

Q: Describe different causes responsible for water-borne diseases. Name the diseases caused by presence…

A:

Q: Please double check the answer if this is correct!

A: Given, σall = 300 kPa a = 20 mm b = c = 250 mm

Q: Explain the angle of elevation and angle of reflection.

A: The angle of elevation is formed by the intersection of the horizontal line and the line of sight.

Q: The designer will develop a plan. (Choose the correct Passive Voice of this Sentence)

A: The  person when becomes subject of sentence it is termed as passive voice.

Q: How are the sensitive parameters identified?

A: The process of determining probability of a variable of interest affected when value of one or more…

Q: Orothgeomitric on graphical paper

A: Approach to solving the question:Please see attached photos for the detailed solutions. Thank you.…

Q: g) What is the x-coordinate, x4, and y-coordinate, y4, of shape 4’s centroid? h) What is the…

A: g) What is the x-coordinate, x4, and y-coordinate, y4, of shape 4’scentroid?h) What is the…

Q: 2.21 The rigid bars ABC and CD are supported by pins at A and D and by a steel rod at B. There is a…

A:

Q: 3. The tractor is used to lift the 250-kg load B with the 28m-long rope, boom, and pulley system. If…

A: Determine tension in the rope,T=?

Storm Sewers and Detention

The storm drains system transports rainwater or stormwater and other runoff from roads, parking lots, and roof downpipes directly to nearby creeks, rivers, or the sea without any treatment.