Problem 4 (a) Water from a water reservoir is delivered through a 2-cm pipe to a 200-litre tank as shown in Figure below. The water level (H) is at 2 m above the pipe. Calculate (a) the time it would take to fill the tank and (b) the height difference of the mercury, h in a U-tube manometer. State all assumptions needed. (Non-anonymous questionO)

Problem 4 (a) Water from a water reservoir is delivered through a 2-cm pipe to a 200-litre tank as shown in Figure below. The water level (H) is at 2 m above the pipe. Calculate (a) the time it would take to fill the tank and (b) the height difference of the mercury, h in a U-tube manometer. State all assumptions needed. (Non-anonymous questionO)

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: 4. The pressure in the ideal gas law must be unit length along any line in the surface 7. weight per…

A: Hi and thanks for the questions. Since you have asked multiple questions, as per our honour code, we…

Q: If a closed tank contains compressed air and oil (SGoil = 0.90), with a U-tube manometer using…

Q: mp while the volumetric e

A: Volume, V= 50 m3 Time, t = 5 min Length, L1 = 5.2 m Length, L2 = 2.2 m Efficiency, ηpump = 95%…

Q: Open tank (4 m long, 3 m height and 3 m wide) contains liquid (S-0.8) to height 1.5 m. If this tank…

Q: Two vessels are connected to a differential manometer using mercury, the connecting tubing being…

A: To find: The pressure head difference in meters of water. Given: The higher pressure vessel is 2.5 m…

Q: n orifice for its outlet. When the water surface in the tank is 5m above the orifice, the surface…

A: given:z1=5mp1=1.0135×105N/m2v1=2ghv1=2×9.81×4=8.86m/ssecond casez2=5m

Q: 1. In the benzene plant, the pressure drop at some point of a pipeline in which benzene is passing…

A: Given: The height of water in left column, hw,left = 4 cm The height of water in right column,…

Q: 1. Compute the pressure @ point n ( Pn ) as shown by the differential manometer in KPa if pressure @…

Q: Q4) A reservoir-pipe system given in the figure below. The air pressure in the tank is 25 N/em?.…

Q: B EL? Q3: Answer ONE Section only. a. Three reservoirs are connected, if pipe (1) and pipe (3)…

Q: Q2 (a) An apparatus shown in Figure Q2 consists of a rubber squeeze bulb filled with sand connected…

A: Rise or fall of water level through small orifice is due to the capillarity phenomenon.

Q: wo ends of an U-tube manometer which contains mercury, is connected between two pipes (A & B), that…

Q: 37. For a tank (T = 41 C°, volume = 0.051 m³, the rate change of density = 2.6 kg-m³-s*), through a…

Q: Q/ A manometer connected to a pipe which contain a liquid A flow at vacuum pressure gauge as shown…

Q: 37. For a tank (T = 41 C°, volume = 0.051 m³, the rate change of density = 2.6 kg-m-s"), through a…

A: Giventemperature T=41oCvolume of tank V=0.051m3rate change of density ρ˙=2.6kg/m3sarea of hole…

Q: Q2: Two pipes A and B carrying water are conected by a connecting tube as shown in Figure. If the…

Q: 03: Answer ONE Section only. a. Three reservoirs are connected, if pipe (1) and pipe (3) having…

Q: d, is fitted to the outlet pipe of a pump with diameter D. Let h; be the height of the section 0-0…

Q: b) An inverted differential manometer is connected to two pipes A and B The fluid in the manometer…

Q: e static pressure diff al section through wil flow rate, the mercu

Q: Problem 2: A U-tube manometer is connected to pressurized tanks (Tanks A and B), as shown in Fig. 2.…

Q: Two pipes A & B carries an oil of specific gravities 0.9 & 1.2 respectively. The center of the pipe…

Q: Q.2: Calculate the pressure difference in sections (1) and (2) to the system in the figure. Will…

Q: . Problem:Pressure in the tank is measured by a multitube manometer. air Using the manometer…

Q: A tank containing helium has a manometer attached, as shown in the figure. The local atmospheric…

A: Given: The value of local atmospheric pressure is, Po=101 kPa. The value of gravitation…

Q: Derive an expression relating to the velocities U and V with manometer reading (R) as shown in…

Q: I. 5,64 kPa II. 11,8 kPa III. 10 kPa IV. 21,6 kPa V. 45,89 kPa Water h1 A h2 Hg h3 Hg- h4 Water

A: Calculated gauge pressure at

Q: If you have a closed system that is filled with water on 2bar, the pump is selected for pressure…

A: 1) As it is a closed system, and the water inside the system is considered to be in static form…

Q: EXAMPLE 5(H.W): One means of determining the surface level of oil in a tank is by discharging a…

Q: 1. In the benzene plant, the pressure drop at some point of a pipeline in which benzene is passing…

Concept explainers

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.

Question

Problem 4
(a) Water from a water reservoir is delivered through a 2-cm pipe to a 200-litre tank as shown
in Figure below. The water level (H) is at 2 m above the pipe. Calculate (a) the time it would
take to fill the tank and (b) the height difference of the mercury, h in a U-tube manometer.
State all assumptions needed. (Non-anonymous questionO) *
h
H
Water
Mercury
S.G. =13.6 Jet
200-litre
Tank

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Show complete solutions.
If a closed tank contains compressed air and oil (SGoil = 0.90), with a U-tube manometer using mercury (SGHg = 13.6), is connected to the tank as shown in the figure below. For column heights h1=1 m, h2= 25 cm, and h3= 245mm then the pressure exerted on the system by the mercury is kPa Air Cil Pressure gage (1) Open (2) H₂
Fast plz
Q1: A vertical conduit is carrying oil (S.g 0.95). A differential mercury manometer is tapped into the conduit at points A and B. Determine (a) the difference in pressure between A and B. (b) the difference head between A and B? Take (specific weight for water =62.4 Ibr/ft³, specific weight for mercury = 847 Ibr/ft³). Dil B 18 in 2 in fr = 3 in Mercury
Two ends of an U-tube manometer which contains mercury, is connected between two pipes (A & B) that carries oil of specific gravities 1.05 & 1 respectively. The center of the pipe B (right limb) is 14 cm above the pipe A (left limb). The mercury level difference in the Left limb is 4.2 cm, and the height of fluid in the left limb is 6.1cm, find the pressure difference between these two pipes in Pascal. Draw the diagram.
Please give me right solution. Help me urgent Thank you A pump is installed on a mountain at 2800 m elevation where the atm (barometric) pressure is 20% lower than at sea level and the ambient temperature is 62 ˚F. What will be the maximum Theoretical Height of a column of water at rest in the suction tube of the pump?
Kindly Solve it with detail
Find the difference of mercury level of a U-tube manometer for a developed pressure head of oil is 5.5 m. The specific gravity of oil is 0.8. The difference in Mercury level in centimeter
The pressure on the suction side of a pump in a water line is 25 kPa (abs). What temperature should the water be to prevent cavitation at sea level? Is this a maximum or a minimum temperature?
1. A U-tube manometer filled with Liquid A is attached to the underside of 4 inch pipe carrying water, as shown in Figure 2. At a point directly above the inclined U-tube manometer tap, the upstream tap of an inverted U tube is located. The inverted-U-tube manometer is filled with a Liquid B. If the P; = 17 psi, determine; (Note: I in (inch) = 25.4 mm, 1 atm = 101.325 kN/m² = 1.01325 bar = 101.325 kPa = 14.7 psi, g =9.81m/s³). (a) the differential manometer reading (psig), and (b) the value of X (inch). Liquid B, SG = 0.5 37 in. 12 in. Water P1. Pz. 4 in. X in. 58 in. 45° Liquid A, SG = 13.6