Problem 3. w2 kN/m 7x kN/m From the figure, 1. Find the resultant of the forces w1 kN/m 2. Find the location of the resultant from point B. 5m Sm

Problem 3: (Final Answer: Louckling = 17.73 ft} In protest, a flag-pole sitter climbed to the top of 2-1/2" diameter, aluminum (E = 10,000 ksi) flag pole with a moment of inertia (1) of 0.53 in'. If the flag pole is 22 ft tall, and the flag-pole sitter is 289 Ib, how high can the sitter climb before the flag pole buckles?

Question is in the picture.

determine the reaction forces at points A and B in Fig. 2.

The figure shows a bicycle wheel resting against a small step whose height is h = 0.100 m. The weight and radius of the wheel are W = 20.0 N and r = 0.390 m. A horizontal force is applied to the axle of the wheel. As the magnitude of increases, there comes a time when the wheel just begins to rise up and loses contact with the ground. What is the magnitude of the force when this happens? Number Units ✪ F

Hi, I have been given this pin-jointed frame analysis to solve (see pictures of the structure attached). Can you help me? The Figure 2 attached is a simplified structure to undertake a structural analysis on a concept design for a low cost stroller/buggy for children. The buggy consists of a number of metal sections that are pin-jointed together. The buggy is designed to accommodate a child of mass no more than 20 kg, sat on the seat which is supported at four points (Fc) on the frame of the buggy.  Assume that the weight of the child is equally distributed across all of the points  indicated on Figure 2 as Fc. Assume that there are no additional forces applied to the handle of the buggy, that the buggy is static (stationary) and that the buggy, and the elements of the frame have no mass. At points A and G, there are roll supports. At Points B, F and D there are the pin supports. I am required to determine the following: 1) Draw a free-body diagram of the structure 2) Simplify the Free…

2.22 Calculate the centre distances for a v-belt drive given pulley pitch diameters of 180 mm (motor) and 400 mm (driven) when the belt is (a) an SPÁ 2 360; and (b) an SPB 3 800. [716 mm; 1 441 mm] Calculate the angle of contact on the smaller pulley for both cases. Determine the tension ratio if the groove ang- les are 38° and u is 0,25. (162°; 171

Please solve Correctly and Explain. I would like to learn

please i need her solving with using the formulas attached below of pin joint linkage

The following question does not violate the honor policy as it is an after class practice problem not to be used on homework or any sort of test.          I am looking for help with this problem solving for all 4 parts. I have some confusion regarding the angles these forces are acting in.