RN1 = 7921 round off maximum tension to the nearest whole number Problem 3A 30-m cable is strung as shown between two buildings. The maximum tension isthe cable is(a) the horizontal distancefoundtobe(500 +0.001* RN1)N,and thelowest point ofobserved to be 4 m above the ground. Determinebetween the buildings, (b) the total mass of the cable.10 m4 m1 of 2

Answered: Image /qna-images/answer/d1bd9126-d076-451a-bef8-54cab6cc5777.jpg

Problem 3 A 30-m cable is strung as shown between two buildings. The maximum tension is and the lowest point of the cable (a) the horizontal distance found to be (500 + 0.001* RN1) N, is observed to be 4 m above the ground. Determine between the buildings, (b) the total mass of the cable. 10 m 4 m 1 of 2

Problem 3 A 30-m cable is strung as shown between two buildings. The maximum tension is and the lowest point of the cable (a) the horizontal distance found to be (500 + 0.001* RN1) N, is observed to be 4 m above the ground. Determine between the buildings, (b) the total mass of the cable. 10 m 4 m 1 of 2

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Define the term wide-flange sections?
d.Tensile stress in the cable in MPa. e.Shearing stress at B in MPa.
Solid mechanic 2 Sketch the strain element that experiences a negative shear strain only on x-y plane.
- Once answered correctly will UPVOTE!!
- once answered Correctly will UPVOTE!!
5 The best size wire is fitted in a groove of a metric screw such that the wire touches the flanks of the thread on the pitch line as shown in the figure. The pitch (p) and included angle of the thread are 4 mm and 60°, respectively. The diameter of the best size wire is mm (round off to 2 decimal places). Pitch line Flank 60⁰ Wire 0.25p -0.5p-
TRUE OR FALSE ? QUESTION : For a bolt pattern in shear, if the line-of-action of the load passes through the centroid of the bolt pattern, then the secondary shear force, Fi'', will be zero.
17 Bending causes increase in the thickness of the sheet metal. Select one: True False
S2 - 9 and 10
Draw FBD of Bicycle axle (Thru axle)
P. P, P. 10 11 12 13 14 15 16 17 12'-0" TYP. Use the diagram shown above. Given P - 100 # P2 =400 # • Pa- 800 # Calculate the magnitude of the internal force in Member 2. (Magnitude is a positive value.) Note: Enter the numerical value only for your calculation results. You'll be asked to specify the unit for your calculation result in the following question. (This is due to Canvas' lack of ability to require units for calculation question. 12'-0" TYP.