Problem 2)- The figure below shows the binary input data and carrier signal that used in a optical comm system. Determine the data rate and baud rate for the following modulation schemes: a) Binary Phase Shift Keying b) Binary Frequency shift Keying. Assume the carrier swing is 3MHz. Input data Carrier 1 a 1 Sus Sus

Problem 2)- The figure below shows the binary input data and carrier signal that used in a optical comm system. Determine the data rate and baud rate for the following modulation schemes: a) Binary Phase Shift Keying b) Binary Frequency shift Keying. Assume the carrier swing is 3MHz. Input data Carrier 1 a 1 Sus Sus

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Q: Explain in details with all figures ind equations the modulation index of Amplitude Modulation (AM) and then show the AM wave when the modulation index > 1, modulation index < 1 and modulation index
7- When does over-modulation occur? a) Modulating signal voltage carrier voltage c) Modulating signal voltage = carrier voltage d) Modulating signal voltage = 0
There exists one or more discrete ime signal. What is it control system ? (a) discrete time or (b) continuous time
What is the effect of over-modulation on the output signal? How one can avoid the over- modulation case?
Construct MOD 12 asynchronous counter. What will be the output frequency, if the input frequency is 1 MHz. If the counter is at state 6, what will be the count after 60 pulses.
For the DBPSK modulator shown in Figure 40a (page 93), determine the output phase sequence for the following input bit sequence: 00110011010101 (assume that the reference bit 1). * 0°180°0°0°0°180°0°0°0°180°180°0°0°180°180°0°180° 10111011100110010 180°0°0°0180°0°0°0180°180°180°0°0180°180°0°0° 01110111000110011
What is the problem with AM signal when overmodulation occurs?
Conversion of digital signal to analog signal is a. Modulation b. Demodulation c. Encapsulation d. Bypass
An a differential pulse code modulated system, the transmitted bits per sample is 7. How many levels are present in the quantizer?
For the DBPSK modulator shown in Figure 40a (page 93), determine th output phase sequence for the following input bit sequence: 00110011010101 (assume that the reference bit 1). * 0°180°0°0°0°180°0°0°0°180°180°o°0°180°180°0°180° 10111011100110010 180°0°0°0180°0°0°0180°180°180°0°0180°180°0°0° 01110111000110011
14. What type of receiver detects the phase shift in the received signal?A. Binary phase-shift keyingB. Quadrature phase-shift keyingC. Differential phase-shift keyingD. Frequency-shift keying
Offset voltage compensating network is connected in between pin number .......... &.. of LM741 op-amp .... O 1 and 4 O 1 and 5 O 2 and 3 O 4 and 7