Problem 2 Analyse the sequential circuit given on the figure and find: a) Input, output equations b) State equations c) State table d) State diagram Q' y Clk

Q: What will be the binary representation of 66 DEC in BCD coding system

A: Given: Decimal number 66

Q: DSP application

A: Answer:-

Q: Construct a 4:16 decoder with 2:4 decoders with active high enable input.

A:

Q: What is the binary pattern ######## (8 bits) to display digit '4' on the 7-segment display?

A: Need to find the binary pattern to display the decimal number '4' in seven-segment display.

Q: What are the minimum and maximum propagation?delays for 1 gate for a 7408 chip? 7402 chip? 7404…

A: To explain:The minimum and maximum propagation delays for 1 gate for:7408 chip,7402 chip,7404…

Q: i. Draw the circuit in the figure below. Complete connection for making seven segment decoder and…

A: IC-7447 is the particular type 4 *7 decoders used in seven-segment decoders. According to the…

Q: a) What a stack? Please explain how it is different from a FIFO (First-In-First-Out).

A: Note : As per our rule we’ll answer the first question since the exact one wasn’t specified. Please…

Q: Find the answers to the following question? a) Convert binary to grey code 0101011

A: Given binary code is 0101011. To convert n bit binary to grey code:…

Q: Construct a 4 X 16 decoder with an enable input using five 2 X 4 decoders with enable input. Include…

A:

Q: Design a 4-bit up/down gray counter?

A:

Q: What is the maximum uncertainty for a 5-bit ADC with ±1 least significant bit operating over a 10 V…

A: Given data, Voltage, V = 10 V. N = 5.

Q: SV D9 D8 D7 20 26 28 32 19 25 27 31 35 DO D3 D5 D6 GND 30 8's cohumn L 'KH CND OPIO 26 IZ OlaD : 2…

A: The solution is given below

Q: 6) Compare between SUB & CMP instructions

A: Please find the attached solution.

Q: Find the address of each register for the PPI and each register of the PIT.

A:

Q: BCD is A. Bit Coded digit B. Binary Coded Decimal C. Bit Code digit D. Binary Coded Digit

A: Given BCD

Q: 14. You want to implement a mechanism that automates the IP configuration, including IP address,…

A: Given:14.You want to implement a mechanism that automates the IP configuration, including IP…

Q: Explain by block diagram and equations the PLL method of Demodulating FM

A: PLL FM DEMODULATOR A Phase-Locked Loop (PLL) is basically a negative feedback system. It consists of…

Q: Find the answers to the following questions? a) Find the excess-3 code of (152) Base 10. b)…

A: a) The excess-3 code of the decimal number can be written by using the following steps.  1- Convert…

Q: 3C. TCCROB is a bit-addressable register. O True or false. TIFRO is a bit-addressable register. 10.…

A: Note:- Student mentioned to solve only Q9. (9) TIFR0 :-   It is a 8-bit timer/counter interrupt…

Q: Attempt two questions Q₁.A Answer the following: ((0 mark) 1- Convert the fractional binary number…

A:

Q: Why must IT professionals possess fundamental electronic skills? Explain why understanding…

A: Step-1->IT professionals must possess fundamental electronic skills because the Internet of…

Q: Part c) 9. If the data select lines of the MUX are S,So = 11, the output will be a. LOW MUX Data S-…

A: c) The given MUX is a 4X1 MUX with 4 input lines and two select lines.

Q: Explain how the data logger works in at least four points or sentences

A: Data logger: It is a measuring device. They will automatically store or record data time to time.

Q: A dairy factory uses an 8255 PPI card at base address 5000 H. a) Explain how port address is changed…

A: Given that: Port A=Output Port B=Input Port C lower=output Port C Upper=Input By default Mode 0 is…

Q: How many bytes are required to encode the instruction MOV SI, 0100H?

A: In this questionWe need to number of byte to encode the instruction MOV SI, 0100H.

Q: D Q' D Q' FF 1 FF 2 fin f2 fa

A: Frequency divider circuit

Q: 1) Compare between the Serial and Parallel ports from the following points of view 1- The length of…

A: Question 1:1. The Length of the CableSerial Port-Large and can support longer cable lengths up to 50…

Q: the binary input to the 7442 decoder is 0111, then output pin number _____ of the IC will become…

A: the binary input to the 7442 decoder is 0111, then output pin number 7 of the IC will become active…

Q: Please solve this exam style question, clearly and simply.

A: Circuit Diagram:The DRAM cell consists of one transistor and one capacitor. The transistor acts as…

Q: In IGBT cross-sectional view, absence of n+ buffer layer results voltage blocking capabilities.

A: In IGBT cross sectional view, absence of n+ buffer layer results ------------- voltage blocking…

Q: not use ai please

A: Step 1:Step 2: Step 3: Step 4:

Q: Assuming 16-bit word sizes, write -2448910 as a signed binary number: 2 type your answer...

A: Given: -2448910

Q: Solve these three MCQs. No need to explain the MCQs. Reference book Barry B Brey 8th edition.    1)…

A: 1) The DMA controller acts as a processor for DMA transfers and overlooks the entire process. True

Q: Explain how AMI can perform simple error detection and what is the advantages of using HDB3 over…

A: AMI stands for Advanced Metering Interface(AMI) .It is an engineering architecture for computerized,…

Q: Needs Complete solution with 100 % accuracy don't use chat gpt or ai plz plz plz plz.

A: Let's solve each congruence step by step: Step 1: 7x≡5(mod13):We need to find the value of 𝑥 such…

Q: The fan connector will have three or four holes. A three-hole connector can fit onto a 4-pin header…

A: The analog pulse modulation techniques are classified into three types, which are mentioned as…

Q: Convert the hexadecimal number, FFF16 into binary, octal, and decimal number system. Show your…

A: Consider the given number is FFF16

Q: i need the answer quickly

A: As per the complexity and designing, I am solving A part only because B & C part need Programme…