Problem 2: A Class III two-lane highway is on level terrain, has a measured free-flow speed of 45 mi/h, and has 100% no-passing zones. During the peak hour, the analysis direction flow rate is 150 veh/h, the opposing direction flow rate is 100 veh/h, and the PHF = 0.95. There are 5% large trucks and 10% recreational vehicles. Determine the level of service.

Problem 2: A Class III two-lane highway is on level terrain, has a measured free-flow speed of 45 mi/h, and has 100% no-passing zones. During the peak hour, the analysis direction flow rate is 150 veh/h, the opposing direction flow rate is 100 veh/h, and the PHF = 0.95. There are 5% large trucks and 10% recreational vehicles. Determine the level of service.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Analyze the unsignalized intersection below and calculate the optimum cycle length if the intersection will be signalized. Approach E W N S Maximum no. of lanes 5 5 4 4 Direction Through left Through left Through left Through left N Total volume pcu/hr 1,480 370 860 586 1,360 494 2,030 265 Sat. flow rate pcu/hr/lane 2,400 1,700 2,400 1,700 2,200 1,800 2,200 1,800
Eight lane urban freeway is on mountainous terrain with lane width of 12 ft, right shoulder lateral clearance of 4 ft, and 12 ramps over the 6-mi analysis segment. The traffic stream consists of familiar road users. Peak hour volume for a directional weekday of 5200 vehicles is observed with 500 vehicles arriving in the most congested 15-min period. If the traffic stream has 10% large trucks and 12% buses and 10% recreational vehicles, determine the heavy vehicle adjustment factor. Round your answer to 3 decimal places. Exclude the unit in the answer box.
A six-lane freeway (three lanes in each direction) in rolling terrain has 11-ft lanes and obstructions 4 ft from the right edge of the traveled pavement. There are five ramps within three miles upstream of the segment midpoint and four ramps within three miles downstream of the segment midpoint. A directional peak-hour volume of 2000 vehicles (primarily commuters) is observed, with 600 vehicles arriving in the highest 15-min flow rate period. The traffic stream contains 12% large trucks and buses and 6% recreational vehicles. What is the density of the traffic stream (in pc/mi/In)? A) 16.5 B) 14.2 13.8 D 15.3
Eight lane urban freeway is on mountainous terrain with lane width of 12 ft, right shoulder lateral clearance of 4 ft, and 12 ramps over the 6-mi analysis segment. The traffic stream consists of familiar road users. Peak hour volume for a directional weekday of 5200 vehicles is observed with 500 vehicles arriving in the most congested 15-min period. If the traffic stream has 10% large trucks and 12% buses and 10% recreational vehicles, determine the density in pc/mi/In. Round your answer to 3 decimal places. Exclude the unit in the answer box.
A new section of a freeway is to be designed with a free-flow-speed of 65 mph along of 0.75 mile on 5% upgrade. The expected traffic volume is 4200 v/hr. The traffic composition is 15% trucks, 5% recreational vehicles, and 10% buses. The peak hourly factor is 0.9, the unfamiliar driver factor is 0.95. If the design requirement is to target a level of service (B), how many lanes must be provided to satisfy the design requirement?
A four-lane freeway with the following characteristics: ten foot travel lanes lateral obstructions at 0 feet at the roadside total ramp density is 4.5 ramps/mile rolling terrain The roadway has a current peak demand volume of 3500 veh/h. The peak hour factor is 0.95 and there are no trucks, buses, or RVs in the traffic stream because the roadway is classified as a parkway and such vehicles are prohibited. At what level of service will the freeway operate during its peak period of demand?
Find level of service (LOS) for an old freeway in Basrah city with the following characteristics: (free flow speed (FFS) = 65 (mi/hr), peak hour factor (PHF) = 0.80, umber on lanes (N) = 3 in one direction, factor of heavy vehicles (fív) = 0.90 and traffic volume (V) = 2200 (veh/hr).
An existing six-lane divided multilane highway with a field-measure free-flow speed of 45mph serves a peak-hour volume of 4,000 vehicles per hour, with 10% trucks (50% SUT, 50% TT). The PHF is 0.88. The highway has generally rolling terrain. What is the likely level of service for this segment? Good weather, no incidents, no work zones, and regular drivers may be assumed.
A) The following traffic counts were taken on a rural highway during the morning peak hour at (9:00-10:00 am) on Saturday of a week. Time periods (minute) Number of vehicles Find: 9:00-9:30 AM 412 9:30-9:45 AM 702 9:45-10:00 AM 254 1. The hourly volume, the peak rate of flow within the hour, and the peak hour factor. 2. The daily volume for Saturday if the hourly expansion factor (HEF) is 14. B) At a highway segment, six vehicles travel the same distance of 20 miles during 21, 25, 30, 29, 31, and 25 minutes, respectively. These vehicles have stopped at a check points for about 5 minutes. Find the average running and overall travel speeds. C) A parking garage located in Misan city center opens its doors to serve 350 vehicles from 8 am to 3 pm. An analysis of data collected at the parking site indicates that these vehicles are parked for an average of 1.5 hours. If parking efficiency is 0.9, determine the number of additional spaces needs when the number of space-hours increases by 16%.
B- A traffic count was conducted to a rural highway if the peak 15 mints 800 vehicles and peak hourly factor (PHF) 0.95 the directional distribution (35:65)% and traffic composition is 75%p.c and 25%truck, 1-Estimate the number of lanes required ? (capacity = 2000 PC/hr/1 lane) 2- Estimate Level of service if the free flow speed 110 km/hr.
A segment of rural freeway is being designed for a FFS of 70 mph through rolling terrain. The directional (i.e. one-way) design volume is 3,000 vehicles per hour. If 10% of the design volume is expected to be heavy vehicles (i.e. trucks and buses), what is the heavy vehicle adjustment used to determine the flow rate? Provide you answer to the nearest hundredths.
A traffic count was conducted to a rural road, if the peak hour traffic volume is 1500 vehicle/day. If the directional distribution (40:60%) and traffic composition is 70%Pc, 20% bus and 10% trucks. Estimate the number of lanes. Assume Lane capacity is 2000 Pc/hr/lane and PHF= 0.7