Question 1 pls. Complete solution and correct units. Thanks 1:45G令. 国View RecordingsPROBLEM SET A(4 problems)Problem 1The sliding plate viscometer shown below is used to mensture the viscosity of a fluid. The top plate ismoving to the right with a constant velocity of 10 m's in rea lineardistribution.to m1 mmProblem 2Calculate the density and specific weight of carbou dioxide at a pressure of 300 kN'm“ absolute and 60°C.Problem 3A 10 m' oxygen tank is at 15°C and 800 kPa. The valve is opened, and some oxygen is released until thepressure in the tank drops to 600 kPa. Calculate the mass of oxygen that has been released from the tank ifthe temperature in the tank does not change during the process.40:3459:06||

Answered: Image /qna-images/answer/5c548092-2154-49a5-bde4-400e96ee9b6e.jpg

Problem 1 The siding plate viscometer shown below is msed to mensre the viscosity of a fhud. The top plate is moving to the right with a constant vekocity of 10 m's in response to a force of 3N. The botom plate is stationary. What is the viscosity of the flnid? Assume a liner velocity distribution 100 mm

Problem 1 The siding plate viscometer shown below is msed to mensre the viscosity of a fhud. The top plate is moving to the right with a constant vekocity of 10 m's in response to a force of 3N. The botom plate is stationary. What is the viscosity of the flnid? Assume a liner velocity distribution 100 mm

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

100 mm В A 30 mm
Draw FBD and questions 4-8
4 b needs to be done
QUESTION 2 A shaft rotates at 300 rpm. 1). If it carries a spur gear that delivers 5 hp to a mating gear and the spur gear has the diametrical pitch of 10, pressure angle of 20°, and 80 teeth, determine a). The resultant force exerted on the shaft = Ib 2). If it carries a sprocket that delivers 4 hp to a mating sprocket and the sprocket has the pitch diameter of 6", determine b). The force exerted on the shaft Ib 3). If it carries a "flat-belt pulley" (Note: NOT V-Belt Drive) that delivers 8hp to another flat-belt pulley and the pitch diameter of the pulley is 20", determine C). The force exerted on the shaft: Ib
+0.15 +0.25 The dimensions for the shaft size are Ø30 -0.25 mm and the hole size are Ø30 -0.15 mm. i) Find the maximum and minimum limits of hole and shaft. i) Find the tolerance for hole and shaft. iii) Find the allowance. iv) Also find the type of fit.
Using the Milling machine with DRO create a hallow that suites the shape of the given MILD STEEL.
c) The bore of each cylinder a six-cylinder car engine is 52 mm and the stroke for each piston is 150 mm. Calculate the cubic capacity of the engine in cm³ and calculate the clearance volume per cylinder for a compression ratio, r, of 6.75.
can u pls solve the question using hand written notes in detail and figure
ENTIRE ANSWER IS WRONG
I need answers for problems 7, 8, and 9 pertaining to the print provided.
Note 1 indicates 10 GAGE 1010-1020 sheet metal can be used to make the main body of this part According to the left side view, how much tolerance is given to the thickness of the metal?
ANSWER FAST