PROBLEM 1 The emission of radiation from a surface can be approximated as a blackbody radiation at T=1000 K a) What fraction of the total energy emmitted is below =5 pum? b) What is the wavelength below which the emmission is 10.5 % of the total blackbody emmission? c) What is the wavelength at which the maximum spectral emission occurs at T=1000 K E (2,T)

PROBLEM 1 The emission of radiation from a surface can be approximated as a blackbody radiation at T=1000 K a) What fraction of the total energy emmitted is below =5 pum? b) What is the wavelength below which the emmission is 10.5 % of the total blackbody emmission? c) What is the wavelength at which the maximum spectral emission occurs at T=1000 K E (2,T)

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter11: Heat Transfer By Radiation

Section: Chapter Questions

Problem 11.2P: A tungsten filament is heated to 2700 K. At what wavelength is the maximum amount of radiation...

See similar textbooks

Similar questions

1.26 Repeat Problem 1.25 but assume that the surface of the storage vessel has an absorbance (equal to the emittance) of 0.1. Then determine the rate of evaporation of the liquid oxygen in kilograms per second and pounds per hour, assuming that convection can be neglected. The heat of vaporization of oxygen at –183°C is .
A semi-transparent material is subjected to an irradiation of G= 600 W/m², 60 W/m² of which is transmitted through the material. If the reflectivity of the material is p = 0.20, find the following quantities: a) absorptivity b) transmissivity c) radiation flux that is absorbed by the material d) emissivity
1) The spectral, hemispherical absorptivity of an opaque surface and the spectral irradiation at the surface are as shown. d' 1.0 G₂ (W/m².um) 500 0.2 0 0 0 2 4 6 8 10 12 14 16 0 2 4 6 8 10 12 14 16 λ(μm) λ(μm) a) How does the spectral, hemispherical reflectivity vary with wavelength? b) What is the total, hemispherical absorptivity of the surface? c) If the surface is initially at 500 K and has a total, hemispherical emissivity of 0.8, how will its temperature change upon exposure to the irradiation?
What is the equation for the distance y to the center of the mth bright region for a single slit diffraction pattern produced by a light source with wavelength A going through a slit of width a seen on a screen located a distance L away from the slit? mAL ㅇ (m+) Ma L. O (m+;)AL
The peak wavelength of radiation emitted by a black body at a temperature of 2000 K is 1.45 um. If the peak wavelength of emitted radiation changes to 2.90 um, then the temperature (in K) of the black body is A. 500 B. 1000 C. 4000 D. 8000
a) b) Find the overall absorptivity of the solar receiver's surface, assuming that the incoming irradiation is coming from the sun (a blackbody at 5800 K).
QUESTION 10 a) A furnace that has a glass window of 50 cm X 50 cm can be considered as a blackbody at 1200 K. If the transmissivity of the glass is 0.7 for radiation at wavelength less than 3 µm and zero for radiation at wavelength greater than 3 µum, determine the fraction and the rate of radiation coming from the furnace and transmitted through the window. b) The reflectivity of aluminum coated with lead sulfate is 0.35 for radiation at wavelength less than 3 um and 0.95 for radiation at wavelength greater than 3 µm, i. determine the average reflectivity of this surface for solar radiation (T=5800 K) and the radiation coming from the surface at room temperature (T=300 K) ii. Kindly evaluate based on the emissivity and the absorptivity of this surface at both temperature, if the material is suitable for use in solar collectors.
7. The emissive power of a blackbody, at 0.8 µm wavelength is measured as 1E5 W/m², µm. Find the blackbody temperature. [Ans. 1739 K]
Wavelength (um) Refractive index in water 2.0 1.1 × 10-3 2.89 x 10-4 9.56 × 10-4 3.17 x 10-3 What are the 2.2 2.4 angles of refraction when 2.6 light enters and exits a water droplet, forming a rainbow in the A case of non- Li-r visible 2.0 - 2.6 um microwaves 'B 180°-2r (First order rainbow)
1) a) Explain how characteristic and continuous x-ray radiations are generated. b) On an x-ray intensity vs. wavelength graph, schematically show Kα, Kβ and continuous radiations. Explain why the intensities and wavelengths of Kα and Kβ are different.
Two point sources of coherent light with a wavelength of 700 nm are near each other. The light from these sources is interfering in space around them. If you determine there is destructive interference between the two sources at a point 70.35 μm away from the second source, how far away from this point might the first source be? (Note that the image shown is not drawn to scale.) Source 1 74.20 μm o 77.175 um - 80.85 um ○ 80.85 μm 80.85 μm ? Source 2 70.35 μm destructive interference here
a) What is the definition of a black body?b) What is the flux from a black body at a temperature of 310 Kelvin?C) Would the peak wavelength of radiation be visible? (The visible band is between 400nm and 700nm)