Problem 04A non-sinusoidal voltage of e= 120 100 sin (377t-20°) + 80 sin (1131t+ 20⁰ )volts is impressed across 100 ohms resistor in series with 100 uF capacitor.Calculate the equation of current produced.

Here we have to calculate the current.

Answered: Problem 04 A non-sinusoidal voltage of…

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Similar questions

What is the minimum AC voltage rating of each capacitor in Question 11?
Establish and analyze Ohm's Law applied for a capacitor in sinusoidal alternating current.
7. In a pure inductive circuit, the phase angle between the voltage waveform and current waveform will havephase shift * 180 deg O deg 45 deg O 90 deg 8. Why do we say the "voltage across" or "the voltage with respect to?" Why can't we just say voltage? * Voltage is a measure of electric potential difference between two electrical points. O It's an electrical cliche. The other point could be negative or positive. None of the above.
QUESTION 3 An inductor, a capacitor, and a resistor are connected in parallel with a function generator. The inductor draws 100mA RMS, the capacitor draws 150mA RMS, and the resistor draws 200mA RMS. Find the magnitude of the total current. O 450mA RMS O 544mA RMS O 352mA RMS O 206mA RMS
2. Sketch Vout if Vin is a 30 V peak to peak sinusoidal wave, D1 is germanium and D2 is silicon. Show your solution 1 K D1 D2 vin V OUT 3.3V 4.BV
An rms voltage of 22.2 V with a frequencyof 1.00 kHz is applied to a 0.290-mH inductor. (a) What is the rmscurrent in this circuit? (b) By what factor does the current changeif the frequency of the voltage is doubled? (c) Calculate the current for a frequency of 2.00 kHz
If three inductors connected in series 0.06 H,0.05H,0.1H.What would be the inductive reactance of the circuit?Assume The inductors are connected to a 60Hz line?
Te netuork show in ope eating in the tondy Thandy state wilh sinussidal vol voltage douce and V, 2 Sin2t delernine the volla fe Va(t) 2178 F Va 2178F 2173F IH
60. Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and a maximum negative amplitude of -5 V using a single 14 V de voltage source. 61 Datermine the volto in the girRuit F Figura 1 1?
calculate the magnitude of the current through the j3.3k ohm inductor. jl k2 1.2 k2 -j4.7 k2 j2.2 k2 8j3.3 k2 20 V/15° 50 V/60° Figure 24-27 ll ll
QUESTION 11 An inductor is connected in parallel with a 6540 resistor and a function generator. The applied voltage is 42V RMS and the total current is 67mA RMS. Find the magnitude of the current through the inductor. Enter your answer in the space provided. Round your answer to one decimal place. Your answer should be in mA but do not enter the unit.
For the Photoflash unit. Vse 9V. RISKO C-1500 uf. R2= 120. The average power dissipated by the lamp is High voltage de supply 6.75W 8.3W 0.675W 10W 0.6W The mutual inductance sign for the following circuit is 352 www Negative R₂ Positive 2 mH 3 mH ell 5 mH www 10 Ω

SEE MORE QUESTIONS

Recommended textbooks for you

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS

Problem 04 A non-sinusoidal voltage of e = 120 + 100 sin (377t-20°) + 80 sin (1131t+ 20°) volts is impressed across 100 ohms resistor in series with 100 uF capacitor. Calculate the equation of current produced.