Prob.12. Air enters a convergent nozzle from a reservoir at 2200 kPaand 100°C. If the exit area is 3.25 cm², what is the maximum mass flowrate that this nozzle can handle ? Assume the process to be isentropic andthat the air behaves as an ideal gas.

Consider the ratio of specific heats γ = 1.4. For the maximum mass flow rate, the pressure at the…

Prob. 12. Air enters a convergent nozzle from a reservoir at 2200 kPa and 100°C. If the exit area is 3.25 cm2, what is the maximum mass flow rate that this nozzle can handle ? Assume the process to be isentropic and that the air behaves as an ideal gas.

Prob. 12. Air enters a convergent nozzle from a reservoir at 2200 kPa and 100°C. If the exit area is 3.25 cm2, what is the maximum mass flow rate that this nozzle can handle ? Assume the process to be isentropic and that the air behaves as an ideal gas.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: CO, enters a nozzle at a mass flowrate of 5000 kg/hr at a pressure of 200.0 kPa, a temperature of…

Q: The air in a car tire is held at a pressure of 220 kPa (gage) in an atmosphere where the atmospheric…

A: Given, Gauge pressure inside car tire = Pcg = 220 kPa Atmoshpheric pressure = Patm = 94 kPa Air…

Q: (a) Determine the work spent on the system if the compression is reversible as well as the exit…

A: GIVEN :- P1=200 KPaT1=250°CP2=3.5 MPa SOLUTION :- taking the super heated steam properties from…

Q: If stream 5 is saturated liquid with H5 = 259.636 kJ/kg and P5 = 22 kPa, what is the enthalpy of…

Q: Air enters an adiabatic nozzle at 250 kPa and 700 K with a very low velocity anc exits at 500 m/s.…

A: Given data :- P1 =250 Kpa T1 = 700K Efficiency =90% Exit velocity =500 m/s

Q: The power of the steam turbine in a thermal power plant is 40MW. Water vapor enters the turbine at 3…

Q: Helium expands in a nozzle from 220 psia, 740 R, and negligible velocity to 15 psia. Calculate the…

A: Consider the diagram shown below for the nozzle. Since the inlet velocity is negligible, the inlet…

Q: Steam with specific enthalpy of 3278kj/kg goes through nozzle at station A velocity of 20m\s. If the…

Q: A typical automobile engine Hot and cold reservoir temperature 515 K, 300 K Heat loss of cold…

A: First law of thermodynamics states that the energy can neither be created nor destroyed but can be…

Q: 4. It is important to remember that the isentropic relations and normal shock relations are…

A: To determine the Mach number of the given total temperature static pressure is and to determine…

Q: 2. (Pp160p-ex4.18-jrfra) - Consider an ordinary shower where hot water at 60 °C is tempered with…

Q: Given the temperature of the sink, the change in entropy and the effective work done by Carnot…

Q: If 4000J of heat tansfer occures from a hot reservoir at temper ature equal to 600 K to a cold…

Q: Consider 5.0 kg/s of water at 1 MPaa, 500 °C, that enter an ideal steadystate, steady-flow turbine…

A: To determine the temperature of the steam at the exit of turbine, we will use the relation given as…

Q: Saturated liquid water at 700 kPa is throttled through a partially-open valve to a pressure of 1…

Q: In a convergent divergent passage normal shock wave forms in the divergent section. The entropy…

A: 1) After the shock wave the randomness of the molecules increases. 2) So, the velocity will increase…

Q: Change in specific ENTROPY in the ideal gas from state 1 to state 2.

A: Given data: T1=420 KT2=530 KP1=130 kPaP2=480 kPaCp=2 kJ/kg.KCv=0.7 kJ/kg.K Need to determine the…

Q: Methane is heated in a steady-flow process at approximately atmospheric pressure. 1000 kJ of heat is…

A: Entropy Change is process which measures the change of disorder or randomness in any thermodynamic…

Q: Cold air enters the mixing chamber at 85°C and 105 kPa at a rate of 0.55 m /s, while warm air enters…

Q: A compressor (300 W) increases air pressure from atmospheric to 2,000 kPa. As the compressor…

A: as given that the outer casing is heated so the process is not adiabatic.

Q: Problem #3: Assume air is an ideal gas with variable specific heat, and that the reference…

A: Given data: To = 0 °C = 273 KP0 = 101.325 kPaandu0 = h0 = s0 = 0 from ideal gas equation P0v0 =…

Q: Consider Air “with constant specific heats at room temperature" enters a compressor at 100 kPa, 27°C…

Q: Problem 3: Air initially at t=20°C and pi=1 atm is compressed reversibly and adiabatically to a…

Q: Oxygen at the rate of 3 lb/min undergoes a reversible isobaric process during which its entropy…

Q: 200 kg/h of air is compressed adiabatically, assuming that ∆ ep = 0. The fluid enters the compressor…

Q: It is proposed that a nozzle receive air at 2 m/s, 300 K, and 150 kPa, at temperature of 280 K, and…

Q: We have steam going into a flow turbine uniform with a mass flow of 20 kg / s at 600 ° C, 5 MPa and…

A: @ 5MPa 600 Celsius , specific enthalpy = 3666.8 kJ/kg @ 500 KPa : saturated vapor sp. enthalpy =…

Q: An industrial nozzle accepts steam at 1 MPa, and 300 C. From negligible velocity, the nozzle creates…

A: Given: Inlet pressure: 1 MPa Inlet temperature: 300 C Exit pressure: 800 kPa Exit velocity: 200 m/s…

Q: Ideal air (mass flow rate of 10 kg/s) enters a gas turbine at 1600 (K) and exits at real conditions…

A: Given data:

Q: Question attached

A: Apply first law of thermodynamics for closed system dQ-dW=dU dQ=Tds dW=-pdv Cv=du/dt…

Q: #2 Air at 3.5 MPa and 500°C enters a gas turbine and exits at 200 kPa. If the process in the turbine…

Q: There are 5kg/s of CO2 (R=188.96kJ/kg-K, k=1.288) gas compressed polytropically with n=1.2 from…

A: Unit of R must be J/kg-K or R= 0.18896 kJ/kg-K

Q: Air expands adiabatically from 1000 K & 1.0 MPa to 100 kPa in a gas turbine. The air temperature at…

Q: An air turbine has an isentropic efficiency equal to 0.85. If the turbine expands 2 kg/s from 2000…

A: I have solved using two different approach but answer is not in the given options and i am sure of…

Question

Prob.12. Air enters a convergent nozzle from a reservoir at 2200 kPa
and 100°C. If the exit area is 3.25 cm², what is the maximum mass flow
rate that this nozzle can handle ? Assume the process to be isentropic and
that the air behaves as an ideal gas.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 5 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An adiabatic expansion of 1 kg air (c P = 1.0062 kJ/kg K, k = 1.4) flow through a nozzle from 828 kPa and 344 K to 138 kPa. The initial velocity at entrance is negligible. Find the exit velocity in m/s
Air flows Skeadily through a themally insulated duct of Varyıng Cress- Sectonal area . The air enters at 52°C , 200 kla, and 355 m/Sec, and exits at 77°C and kla. The inlet oross- Sechonal area is 6.57 cm?. Using the ideal gas model, but without assuming constant Specific heats, Calculate the rate of entropy production within the duct in kW/°K using 5 signifigant Agures.
Please help me solve this as soon as possible, and I will surely leave you a like.
Q.3 A steel bar at a temperature of 500°C is dropped into an insulated bath containing 20 kg water at 120°C. The temperature of water and Steel reaches steadily to 150°C. If specific heat for water is 4 .180 kJ/kg-K, calculate the change in entropy of system.
7. If 10 kgm/min of air are compressed isothermally from p1 = 96 kPa and V₁ = 7.65 m³/min to p2 = 620 kPa, find the work, the change of entropy and the heat for (a) nonflow process and (b) a steady flow process with u₁ = 15 m/s and U₂ = 60 m/s. Ans. (a) -1370 kJ/min, -5.356 kJ/K.min; (b) -1386.9kJ/min
Find what is needed and make sure that the solution is correct as shown in the answer to the question
p61#6. Carbon Dioxide at p₁ = 500 psia,v₁ = ft/min, and t₁ = 200°F are cooled at constant volume to 130°F in an internally reversible manner. For m=0.9 lbm/min, determine in ∫pdv and -∫vdp. For nonflow process, find p2, change of internal energy, change of enthalpy, and Q. Also, compute change of entropy.
A- Air at 15°C and 1bar occupies 0.02 m³. The air is heated at constant volume until the pressure is 5bar, and then cooled at constant pressure back to the original temperature. Calculate the net heat flow to or from the air and the net entropy change. Sketch the process on a T-s diagram. (8.5marks)