Prob A supply voltage Vs with magnitude of 230 Volt RMS with 60 Hz frequency and a phase angle of zero degrees is connected in parallel configuration to two loads each load consumes power as following: Load 1: 30 K watts with Power factor of 1. (PF= 1) Load 2: 5 K VA (apparent power) with Power factor of 0.86 (PF = 0.86) lagging. (Note that lagging PF means the difference between phase of the voltage and phase of the current is positive) A. (10 pts) The complex power consumed by each load B. (10 pts) The current drawn by each load from the source. 230 RMS 60Hz 0° Load 1 GND Load 2

858445655 O Blackboard Remaining Time: 59 minutes, 28 seconds. * Question Completion Status: 90 10 110 120 130 14D 150 160 440 450 46D 470 480 49D 500 10 70 18 19 201 40 50 36 370 38 3940 410 42 43D 20 QUESTION 35 What is indicator number 1 called. 6 1 Heading indicator Airspeed indicator O Altimeter indicator QUESTION 36 Attitude indicator is also known as: O Virtual horizon O Visual Horizon O Artificial Horizon Th Click Save and Submit to save and submit. Click Save All Answers to save all answers. MacBook Air

Refer to the National Electrical Code® or the working drawings when necessary. Where applicable, responses should be written in complete sentences. For problems 1 and 2, six luminaires, similar to Style E used in the Commercial Building, are to be installed in a room that is 12 ft x 18 ft (~3.7 m x ~5.5 m) with a 9 ft (2.8 m) floor-to-ceiling height. The spacing ratio for the luminaire is 1:0. 1. The maximum distance that the luminaires can be separated and achieve uniform illuminance is ft ( m). For problems 2-5, two luminaires, 8 ft (2.5 m) and 4 ft (1.2 m) in length with dimensions as shown in Figure 15-7, are to be installed in tandem (end to end). The end of the long luminaire is to be 2 ft (600 mm) from the wall. 2. The center of the outlet box should be roughed in at ft ( m) from the wall. 3. The first support should be installed at the wall. ft ( m) from 4. The second support should be installed at from the wall. ft ( m) 5. The final support should be installed at the wall. ft…

1. The only exception to the need for all information technology equipment to be satisfactorily grounded is where the equipment is A. DC powered.B. backup generator powered. C. double-insulated.D. isolated equipment. 2. Which section of the National Electrical Code lists sizing requirements for wire-type equipment grounding conductors? A. 250.66 B. 250.118 C. 250.4 D. 250.122 3. Which of the following statements about grounding electrical equipment is true?A. If no wire-type equipment grounding conductors are present with the branch circuits, the equipment grounding terminal bar isn't required.B. Grounding electrical equipment increases the possibility of metal parts remaining energized.C. The nonmetal parts of some electrical equipment are required to be connected to an equipment grounding conductor. D. Equipment grounding conductors can be spliced together outside of a grounded metal box. 4. Which of the following is a condition that must be met in order to qualify for the exemption…