PRACTICE ANOTH A uniform plank 5.9 m long rests on two supports, 2.5 m apart (see figure below). The gravitational force on the plank is 109 N. The left end of the plank is 1.5 m to the left of the left support, so the plank is not centered on the supports, A person is standing on the plank one tenth of a meter to the right of the right support. The gravitational force on this person is 822 N. How far to the right can the person walk before the plank begins to tip? m to the right of her initial position 15 m 01 m 25 m

PRACTICE ANOTH A uniform plank 5.9 m long rests on two supports, 2.5 m apart (see figure below). The gravitational force on the plank is 109 N. The left end of the plank is 1.5 m to the left of the left support, so the plank is not centered on the supports, A person is standing on the plank one tenth of a meter to the right of the right support. The gravitational force on this person is 822 N. How far to the right can the person walk before the plank begins to tip? m to the right of her initial position 15 m 01 m 25 m

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

Q1. What is the weight and the mass of the rod ? Where is the center of mass? 0.5m im 2.5m 4m 5kg
What is the formula for calculating the torque (from the force)? Using the formula, list 3 different ways to change a torque. Using the formula, list 3 different ways to make a single torque 0. You want to lift a heavy box using a lever. The lever is not centered. Which end do you put the box on? Which end do you push down on? Explain.
A coin is thrown from a moving car. While it is in flight, but its motion relative to any plane is? what is the answer? a) rectilinear b) curvilinear c) rotational d) circular
Physics I Review | Constants A uniform, 255 N rod that is 1.80 m long carries a 225 N weight at its right end and an unknown weight W toward the left end (Figure 1). When W is placed 45.0 cm from the left end of the rod, the system just Part A balances horizontally when the fulcrum is located 75.0 cm from the right end. Find W. Figure 1 of 1 Express your answer with the appropriate units. W = 218 N Submit Previous Answers v Correct Correct answer is shown. Your answer 217.5 N was either rounded differently or used a different number of significant figures than required for this part. 225 N Important: If you use this answer later parts, use the full unrounded
Lever Arm A bolt on a car engine needs to be tightened with a torque of 35 N-m. You use a 25-cm-long wrench and pull on the end of the wrench at an angle of 60.0° from the perpendicular. How long is the lever arm, and how much force do you have to exert? 60.0° 60.0° 25 cm Lever arm
A dentist using a dental drill brings it from rest to maximum operating speed of 339,000 rpm in 2.0 s. Assume that the drill accelerates at a constant rate during this time. (a) What is the angular acceleration of the drill in rev/s?? |rev/s² (b) Find the number of revolutions the drill bit makes during the 2.0 s time interval. rev Additional Materials O Reading
help with two part problem
A force of 50 N is applied at the end of a wrench handle that is 24 cm long. The force is applied in a direction perpendicular to the handle as in the diagram. a. What is the torque applied to the nut by the wrench? b. What would the torque be if the force were applied halfway up the handle instead of at the end?
help me pls i am begging you
What torque does the machinist exert about the center of the nut?
5. A 5 kg solid wood with length of 0.6 m is supported by wires attached to the beam as shown in the figure on the right. A 2 kg rock is placed in the between the wires. What is the tension on each wire? Draw the FBD. Assume that rotation will take place on the leftmost side of the wood. rock 0.1 m 0.6 m
Solve it correctly please. I will rate accordingly